Green Brook DW030A User manual
Diagram 3.
Skip to STEP 5. unless you wish
to change the factory set tune
and volume or house codes.
WIREFREE DOORCHIMES
Diagram 2.
Receiver
Diagram 1.
Transmitter
Before drilling any holes position
the transmitter on the door or door
frame outside (ideally a flat wooden
area) and press the button to ensure
the signals are getting through to
the receiver. Please test with the
door closed to simulate actual
working conditions. You should also
look to position the transmitter in
an unexposed place to protect from
rain.
The range of the unit is up to 100
metres but mounting the
transmitter on metal or UPVC
doorframes may make the unit
inoperative or seriously reduce the
operating range.
As with all low powered
transmitters the number of walls
and ceilings the signal has to travel
through, between the transmitter
and receiver also affects the range.
Once a suitable surface is found
remove the transmitter base
following 1a).Use this as a template
to fix the base on to a doorframe.
Ensure the transmitter is the right
way up so that
the slot is at the bottom.
If mounting on to masonry, wall
fixings will be required. Refit unit to
the base.
IMPORTANT : The screws must be
fixed flush or the battery will not
maintain contact with the terminals
and the unit will not operate.
The unit comes with a factory pre-
set tune but it can be changed.
The tune is determined by the slider
switch as in diagram 3.
Remove transmitter cover as in 1a)
above leaving the battery in and
select tune as shown in Diagram 3.
Press the push button to hear sound
each different setting produces.
Once a desired tune is selected,
carefully replace the transmitter. Up
to 3 different sound options are
available.
The unit comes with factory set
code. Only change it if you
experience interference from a
neighbours unit.
Remove cover transmitter from base
as in 1a) leaving the batteries in
position. Set dial as in Diagram 3. to
required number i.e “6”, set this
number “6” on the corresponding
dial on the reciever.
STEP 1. TESTING THE
TRANSMITTER WITH
BATTERY AND THE
PLUG-IN RECEIVER
STEP 3. TUNE SELECTION
MODEL NUMBERS:
DW030A: Plug-in Chime kit
• Simply plugs into a suitable mains
socket
• Battery included for Transmitter
(12V A23 Alkaline)
• Transmitter fixing screws included
Please read the instructions fully
before attempting installation.
1a) TRANSMITTER
The battery compartment slot is
located on the bottom of the unit.
Using a flat screw driver insert into
slot and gently push to remove the
lower cover.
Insert the two AAA batteries
supplied and refit the base cover.
1 b) PLUG-IN RECEIVER
Plug in to a mains three-pin socket
and switch the power on.
Press the button on the transmitter
and the doorchime will sound.
If there is no sound, ensure the
battery is correctly inserted in the
transmitter. Also ensure power is
switched on at the socket.
You have now tested your
doorchime.
STEP 2. INSTALLING THE
TRANSMITTER TO THE DOOR
STEP 4. CHANGING
THE HOUSE CODE
Press push button on the transmitter
to check that the chime works and
carefully replace transmitter as
above.
Test your doorchime by plugging the
receiver in different rooms and
varying distances from the
transmitter to ascertain the
coverage available in your home,
this way you are unlikely to miss
any visitors.
Fault : Chime does not sound
Cause :
• Check batteries are not exhausted
and they have been inserted the
correct way round. Do not mix
different types of batteries.
• Re-check the dials and switches in
the transmitter and receiver if the
house codes have been changed.
• Move the receiver nearer the
transmitter.
If after going through the trouble
shooting section, you still experience
difficulty please ring us on -
GreenBrook‘s Help Line
01279 772 750
during office hours quoting
the model number
Issue No: 701325
West Road,
Harlow,
Essex
CM20 2BG
Tel 01279 772 750
Fax 01279 635 285
Email: [email protected]
Web: www.greenbrook.co.uk
GUARANTEE
REMARKS
STEP 5. TESTING
6. TROUBLE SHOOTING
Your doorchime is guaranteed for 12
months from date of purchase.
Please retain till receipt as proof of
purchase. This is in addition to your
statutory rights.
For indoor use only.
No naked flame sources, such as
lighted candles being placed near
the unit.
The unit should not be exposed
to dripping or splashing and no
objects filled
with liquids, such as being
placed near vases.
Please dispose of old,defective
batteries in an environmentally
friendly manner in accordance
with the relevant legislation.
This Symbol indicates seperate
collection of electronic/electrical
equipment.
PLEASE KEEP THESE
INSTRUCTIONS SAFE
FOR FUTURE REFERENCE
