GREENLUX Shoebox 02 User manual

9/331 Ingles Street
Port Melbourne VIC 3207 Australia
T 1300 650 625
[email protected]
Normal Series
greenluxlighting GreenluxLED
www.greenlux.com.au
Installation Manual
1/3
60mm lamp pole
Slip Fitter (60mm lamp pole)
Photocontroller Series
1. Connect exposed lamp
wire to power wire.
60mm lamp pole
60mm lamp pole
2. Install lamp on
the 60mm lamp pole, then
fasten the two M8 screws.
3. Adjust lamp angle.
2. Connect exposed lamp
wire to power wire.
60mm lamp pole
60mm lamp pole
60mm lamp pole
4. Adjust lamp angle.
3. Install lamp on
the 60mm lamp pole, then
fasten the two M8 screws.
1. Insert light sensor into socket,
then fasten by turning clockwise.
Shoebox 02 LED Carpark/Street Light

9/331 Ingles Street
Port Melbourne VIC 3207 Australia
T 1300 650 625
[email protected]
Normal Series
greenluxlighting GreenluxLED
www.greenlux.com.au
2/3
Straight Arm Bracket (100-150mm square pole)
Photocontroller Series
101
3.98"
ø9 3-ø9
54
50
1.97"
64
2.52"
2.13"
ø0.35" 3-ø0.35"
1. Check diagram below for correct installation.
Straight Wall Bracket Holes Installation Diagram
2. Open pole cap.
3. Connect exposed lamp wire to power wire.
Open pole cap
4. Insert all the wires into lamp pole, align
installtion holes, then fasten screws.
5. Put pole cap back
Put pole cap back
101
3.98"
ø9 3-ø9
54
50
1.97"
64
2.52"
2.13"
ø0.35" 3-ø0.35"
Put pole cap back
5. Insert all the wires into lamp pole, align
installtion holes, then fasten screws.
6. Put pole cap back
2. Open pole cap.
3. Connect exposed lamp wire to power wire.
Open pole cap
Straight Wall Bracket Holes Installation Diagram
2. Check diagram below for correct installation.
1. Insert light sensor into socket,
then fasten by turning clockwise.
Installation Manual
Shoebox 02 LED Carpark/Street Light

9/331 Ingles Street
Port Melbourne VIC 3207 Australia
T 1300 650 625
[email protected]
Normal Series
greenluxlighting GreenluxLED
www.greenlux.com.au
3/3
Trunnion Bracket
Photocontroller Series
2. Check diagram below for correct installation.
1. Insert light sensor into socket,
then fasten by turning clockwise.
1. Check diagram below for correct installation.
ø20
30
1.18"
6-ø10
6-ø0.39" ø0.79"
40
1.58" 60
2.36"
Rotate Bracket Holes Installation Diagram
2. Connect exposed lamp wire to power wire.
3. Align lamp position
4. Adjust lamp angle ( -90°.~90° ).
5. Fasten angle screws.
ø20
30
1.18"
6-ø10
6-ø0.39" ø0.79"
40
1.58" 60
2.36"
4. Align lamp position
5. Adjust lamp angle ( -90°.~90° ).
6. Fasten angle screws.
3. Connect exposed lamp wire to power wire.
Rotate Bracket Holes Installation Diagram
Installation Manual
Shoebox 02 LED Carpark/Street Light