GREISINGER GMH 5550 How to use

Short Manual GMH 5550 Data logger
H80.0.01.6HC-02
2 logger functions: cyclic and manual logger
The adjustments are done as described in “Configuration”, but go to sub-menu “SEt LoGG” instead of “SEt LoGG”. The
submenu contains the following parameters:
Attention: Menu can be only called if logger not active and no logger data stored!
Menu
Parameter
Value
Description
or
Set Logger: Settings for logger function
Selection of logger function
CYCL
Cyclic: automatic recording with adjustable cycle time
Stor
Store: manual recording with keypress “store”
oFF
Logger deactivated
0:01... 60:00
Cycle time in [minutes:seconds] (for cyclic logger)
1 Manual Recording („Func-Stor“)
a) Save measured value manually:
Press shortly: data set is saved (“St. XX” is displayed shortly, XX = data set number)
or
Input of measuring point “L-Id”: Number between 0…32768
Confirm input with “enter”
If logger storage is full, display will show:
b) Read manual recordings:
Press for 2s: display shows (only if data sets are stored):
Press shortly: change between measuring values, measuring point and date+time of the data set
or
Change between different data sets
End display of recordings

Alternative: Read data with PC-software GSOFT3050
c) Clear manual recordings:
Press for 2s: Call menu “Clear” (only if data sets are stored)
Change between:
Clr no
Clear nothing (cancel menu)
Clr all
Clear all recordings
Clr last
Clear last recording
Confirm selection and quit menu “Clear”
2 Automatic recording with selectable cycle time “Func CYCL”
Cycle time selectable between: 1 s to 60 min.
Data evaluation with software GSOFT3050 (V3.0 or higher)
a) Start recording:
Press for 2s: start automatic recording
Each storage process is signaled by the short display of ‘St.XXXXX’ (XXXXX = data set number).
If logger storage fulll: recording stops automatically, display shows:
b) Stop recording:
Press for 2s: “stop” menu is displayed (if recording is running)
or
Change between
Stop no
Do not stop recording (cancel menu)
Stop yes
Stop recording
Confirm selection and quit menu “stop”
Note: Device cannot be turned off as long as logger is running.
c) Clear recordings:
Press for 2s: If there are data sets stored and recording is already stopped the menu “Clear” is displayed
or
Change between
Clr no
Clear nothing (cancel menu)
Clr yes
Clear all recordings
Confirm selection and quit menu “Clear”