r3a-x2.0
3
Introduction
With your r-THREE system, you will be able to easily setup and
remotely control up to three cameras.
The key elements of the r-THREE system are:
From a single point (your chair) and a single controller
(in your hands), you have the ability to
odynamically switch to any camera and operate the
camera remotely (e.g. start/stop record, zoom, focus,
exposure, pan & tilt, etc).
omonitor the view for all camera.
oattach the composite video signal from two or all
three cameras to a live switch or purchase the LS
option.
omonitor the status of your cameras (e.g. record
on/off, time codes, battery charge, etc).
oconfigure the system to your needs (e.g. adjust pan,
tilt and zoom speed, configure joystick response, etc.)
osend camera menu commands to your LANC camera
as if you were dialing the menus dial from the back
of your camera. (e.g. exposure control)
In addition, only a very thin, flexible CAT5 cable from each
pan/tilt head to one centralized interface box is needed for
each remote camera. This cable powers the pan/tilt head
and enables the remote control features for the associated
pan/tilt head and camera as well as sending a video feed
back to the operator. Except for the cameras, the power for
the entire system comes from this one centralized point in
the
