Guide Gear 705520 User manual

Congratulations on your Guide Gear purchase.
Take your game to the next level with field-tested Guide Gear products for a
confident,competitive edge that strikes the perfect balance between performance and value.
Elevated Platform Mounts (Set of 4)
(The Sportsman's Guide item # 705520)
P/N: 02-HP5012GG
DOP: 04/24/18 REV 0
© 2018DOP.
All Rights Reserved.
Before beginning assembly, check your purchase for
damaged or missing parts. Do not use if you identify
damaged or missing any parts. For help with damaged or
missing parts, call toll free at 877-284-9005
(reference Model # 02-HP5012GG)
YOU MUST COMPLETELY READ, UNDERSTAND,
AND FOLLOW THE WARNINGS AND
INSTRUCTIONS CONTAINED IN THIS MANUAL.
FAILURE TO DO SO MAY RESULT IN SERIOUS
INJURY OR DEATH!
WARNING

Elevated Platform Mounts
Operator's Manual
INTRODUCTION
Follow these few simple instructions and your hunting platform will provide you many years of trouble-free pleasure. Instructions
should be kept in a safe place and reviewed at least annually.
CONTENTS
Introduction/Contents/Free Standing Platform Stand Safety Guidelines ............................................................................................................... 2
Warnings...................................................................................................................................................................................................................................... 3-4
Inspection and Maintenance ...................................................................................................................................................................................................4
Assembly Instructions ............................................................................................................................................................................................................ 5
Warranty ........................................................................................................................................................................................................................................6
FREE STANDING PLATFORM STAND
SAFETY GUIDELINES – READ FIRST
READ, UNDERSTAND, AND FOLLOW THE INSTRUCTIONS
ALWAYS read and understand the manufacturer’s WARNINGS and INSTRUCTIONS
before using a free standing platform stand each season. If you have any questions
after reviewing the WARNINGS and INSTRUCTIONS, please contact the manufacturer.
Maintain the WARNINGS and INSTRUCTIONS for later review as needed, for
instructions on usage to anyone borrowing your stand, or to pass on when selling
this item. Use all safety devices provided with your free standing platform stand.
NEVER exceed the weight limit specified by the manufacturer.
USE A HAUL LINE
ALWAYS use a haul line to raise your backpack, gear, unloaded firearm or bow to
your free standing platform stand once you have reached your desired hunting
height. Never climb with anything in your hands or on your back. Prior to
descending, lower your equipment on the side of the platform opposite of your
descent route.
REPLACE DAMAGED PARTS AND STANDS
ALWAYS inspect the free standing platform stand for signs of wear or damage before
each use. Contact the manufacturer for replacement parts. Destroy all products that
cannot be repaired by the manufacturer. Destroy products if the manufacturer no
longer exists.
BE PREPARED AHEAD OF TIME
ALWAYS let others know your exact hunting location, when you plan to return and
who is with you before you go hunting. Hunt with a buddy – it’s more enjoyable and
you’ll have someone to help if an emergency situation arises.
CARRY EMERGENCY SIGNAL DEVICES
ALWAYS carry emergency signal devices such as a cell phone, two-way radio, whistle,
signal flare, PLD (personal locator device) and flashlight on your person at all times and
within reach. Watch for changing weather conditions. In the event of an accident,
remain calm and seek help immediately.
KNOW YOUR LIMITS
ALWAYS know your physical limitations. Don’t take chances.
DON’T RUSH – BE SAFE!
NEVER hurry! While climbing, make slow, even movements of no more than ten to
twelve inches at a time. Make sure you have proper contact with the ladder every time
you move. When using any stand with a ladder or steps, maintain three points of
contact with each step. This means having two hands and one foot (or one hand and
two feet) in contact at all times.
ONLY USE CERTIFIED EQUIPMENT
NEVER use homemade or permanently elevated stands. NEVER make modifications to a
purchased free standing platform stand without the manufacturer’s written permission.
Only purchase and use free standing platform stands that meet or exceed industry
standards recognized by
TMA. For a detailed list of products that are certified to industry standards recognized
by TMA, contact the TMA office or refer to the TMA web site at www.tmastands.com.

Operator's Manual
MODEL 02-HP5012GG
TOTAL WEIGHT LIMIT - 500 LB (300 lb Per Person
Max)
WARNING
This product carries strict height and weight restrictions.
Do Not use this product if you exceed the total weight
limit. Please note that the total weight limit includes the
user(s) and their equipment.
WARNING
When hunting from a treestand or free standing
platform stand falls can occur any time after leaving
the ground causing injury or death.
Read and understand all of the manufacturer’s Warnings
and Instructions and use all safety devices provided by
the manufacturer. Contact the manufacturer for any
questions. Failure to do so could result in injury or death.
Never exceed the total weight limit of the treestand or
free standing platform stand.
Never use a treestand or free standing platform stand
during inclement weather such as rain, lightning,
windstorms or icy conditions and end your hunt and
return to the ground if inclement conditions arise.
Never use a treestand or free standing platform stand
while using drugs (even prescription drugs) or alcohol.
Never use a treestand or free standing platform stand
while feeling ill, nauseous or dizzy, or if you have a prior
medical condition that could cause a problem, that is,
heart condition, joints that lock-up, spinal fusions, etc., or
if you are not well rested. Never sleep in stand.
Always avoid electrical power lines.
Never rely on a tree branch for support.
Never jump or bounce on a treestand or free standing
platform stand to seat it to the tree or ground.
Pull up a bow, backpack, or rearm or other equipment
only after being secure in the treestand or free standing
platform stand and a rearm must be pulled up with it
unloaded, chamber open, and muzzle down.
Always inform someone of the hunting location, where
the treestand or free standing platform stand will be
located and the expected duration of the hunt.
WARNING
A signal device such as a mobile phone, radio, whistle,
signal are or personal locator device (PLD) must be on
your person and readily available at all times.
Inspect the treestand or free standing platform stand and
all safety devices each time before use and Do Not store a
treestand or free standing platform stand outdoors when
not in use.
Never modify your treestand or free standing platform
stand in any way by making repairs, replacing parts, or
altering it except if explicitly authorized in writing by the
manufacturer.
Practice installing, adjusting and using your treestand or
free standing platform stand at ground level prior to using
it at elevated positions. Study your new stand to become
familiar with all of its features and design. Doing so will
conrm that the product is manufactured, assembled
and installed correctly.
Instructions (written and video) shall be kept in a safe
place and reviewed at least annually. It is the responsibility
of the treestand or free standing platform stand owner
to furnish the complete instructions to any person who
borrows or purchases the treestand or free standing
platform stand.
Always use at least four (4) people to install or take down
a free standing platform stand.
Stabilization devices must be attached before climbing to
the platform.
When installing a ladder stand or free standing platform
stand, always bounce on the rst rung to set the ladder
into the ground according to manufacturer’s instructions
before proceeding to climb any higher.
Check every ladder/leg section connection every time
you use the stand before you leave the ground. If ladder/
leg sections are separating, do not use the stand.
Check the ground under the stand to make sure it is rm
and level. Sloping ground or uneven surface (one side on
a rock) can cause your ladder or free standing platform
stand to tilt or shift o as you climb.
Always maintain three (3) points of contact when
climbing a ladder treestand or free standing platform
stand. Proper three-point contact means having either
two feet with one hand or one foot with two hands on
the step portion of the ladder or climbing aid at all times.
Always lean forward as you climb ladder or climbing aid.
Never exceed the stated maximum use height.
Elevated Platform Mounts

Operator's Manual
INSPECTION AND MAINTENANCE SCHEDULE
BEFORE EACH USE PERFORM THE FOLLOWING:
• Inspect all webbing, rope, cord, and strap assemblies for
wear or damage.
• Inspect cables and/or cable ends for damage or kinking.
• Inspect all hardware and chain components for damage.
• Inspect for any structural damage to product. (If any exists
call DOP customer service.)
• Inspect all nut and bolt assemblies to be certain none are
loose.
• Inspect for any missing parts.
• Lubricate all pivot and slide together points with powder
graphite, petroleum jelly or silicone spray to prevent noise,
wear and rust.
• Inspect entire product for any rust, corrosion, cracks,
freezing, excessive heat or rotting damage that may eect
the safety of your product. Discard any questionable
product.
• Inspect entire product for any structural damage - pay close
attention to all weld locations. (Return to factory for repair or
discard product if any damage is found.)
• Using correct wrenches inspect all nut & bolt assembly
locations and snug up any that may be loose. Be careful not
to crush tubing when tightening!
• Inspect and check operation of all cables, cable ends, cord,
rope, webbing, and strap or chain assemblies. Replace with
factory new any item or assembly that shows signs of wear,
damage, kinking, or functions incorrectly.
• Inspect seat. Replace any seat with factory new that shows
signs of structural damage or wear.
• Inspect all hardware for wear or damage, also be sure you
have no missing parts.
• Never modify your stand in any way by making repairs,
replacing parts, or altering adding or attaching anything to it
except if explicitly authorized in writing by the manufacturer.
WARNING
Do Not use this product until you have watched the
included treestand safety DVD, understand it, and
practiced the techniques for safe hunting discussed in
this DVD.
Read and perform all inspection and maintenance tasks
before each and every use. Replace any
questionable components immediately with DOP
original replacement parts.
Do Not crush tubing when tightening bolt assemblies!
Identify and familiarize yourself with all parts before you
start. Bolt identication chart can be found in the back.
Double check assembly steps to be certain you have
correctly assembled this product.
Never use any product that has not been maintained or
inspected properly - Your life depends on it!
Always wear the appropriate footwear when using a free
standing platform stand. A good non-slip safety boot is
important to your personal safety. Be especially careful
that boot laces do not get hooked on the stand or any
of its components (tuck shoelaces into boots before
climbing).
Do not position this product on a slope, unlevel, or wet
ground. It may tip over and serious injury or death may
occur.
Ground should be such that ground stakes can be driven
into the ground through holes provided in foot pads. This
will help prevent pod from tipping over in strong winds.
Elevated Platform Mounts

Operator's Manual
Elevated Platform Mounts
2
Parts Illustration
1. Choose the desired size of 4 x 4 wood and cut ends at a 45 degree angle .
2. Place wood ends into the Platform Mounts making sure to get corners a
snug fit , use 5/16'' x 3 '' Lag Screws (NOT INCLUDED )in provided
holes
Individual part # 5012-2100
Lag Screw
4x4 Wood Post
Platform Mount

*All weights, specications and features are approximate and are subject to change without notice. Due to continuous product improvements, product images may not be exact. Warning labels in some product images
may have been removed for photography purposes only. Props shown in photos not included. Some assembly may be required.
LIMITED WARRANTY POLICY
Limited Warranty Periods
Hunting / Shooting Products: 1 Year (12 months) from date of purchase.
Sub-component Items: Many sub-component items are warranted separately by the respective manufactures
and are covered by warranty of their manufacturer. The sub-components original manufactures product
warranty supersedes and takes precedence over this limited warranty policy.
NOTE: ALL WARRANTY CLAIMS MUST BE PREAPPROVED BY THE MANUFACTURER (THE COMPANY) TO BE VALID.
Products are warranted to be free of defects in materials and/or workmanship for the warranty period. Under this limited
warranty, the Company shall be limited to repairing or replacing, at its option, for the warranty period, those parts returned to
the factory, freight prepaid, which in the opinion of the Company shall prove to be defective in materials or workmanship, under
normal use and service. This warranty will not apply unless the product is installed, used and maintained in accordance with
the Manufacturers installation, operation and maintenance instructions.
This warranty applies to the ORIGINAL purchaser only, and is non-transferable. The Company warrants the products to be free
of defects in material and workmanship but, does not cover normal maintenance or adjustments, damage or malfunction
caused by: improper handling, installation, abuse, misuse, negligence, carelessness of operation or normal wear and tear. In
addition, this warranty does not cover equipment when repairs or alterations have been made or attempted without the express
written consent of the company. Product repairs not covered by the warranty, and product updates, will be provided at the
prevailing rate.
The Company is not responsible for damage caused by accident, negligence, abuse, overloading, misapplication, or misuse of
the products. It is solely the purchaser’s responsibility to determine the suitability of these products for the particular
application. Limitations: All other obligations or liabilities, including incidental or consequential damages or contingent
liabilities arising out of the failure of any parts to operate properly are hereby excluded, including but not limited to any
damages resulting from loss of use, inconvenience, loss of time, commercial loss, or any other type of damages general or
specific, foreseen of unforeseen, unless applicable state law provides otherwise.
THIS WARRANTY IS EXCLUSIVE AND IS LIEU OF ALL OTHER WARRANTIES EXPRESSED OR IMPLIED INCLUDING
ANY IMPLIED WARRANTY OR MERCHANTABILITY OR ANY IMPLIED WARRANTY OF FITNESS FROM A PARTICULAR
PURPOSE, AND ALL SUCH IMPLIED WARRANTIES ARE EXPRESSLY EXCLUDED.
THE REMEDIES DESCRIBED ARE EXCLUSIVE AND IN NO EVENT SHALL THE COMPANY, NOR ANY SALES AGENT OR
OTHER COMPANIES AFFILIATED WITH IT OR THEM, BE LIABLE FOR SPECIAL CONSEQUENTIAL OR INCIDENTAL
DAMAGES FOR THE BREACH OF OR DELAY IN PERFORMANCE OF THIS WARRANTY. THIS INCLUDES, BUT IS NOT
LIMITED TO, LOSS OF PROFIT, RENTAL OR SUBSTITUTE EQUIPMENT OR OTHER COMMERCIAL LOSS.
This warranty shall be governed by the laws of the State of Texas, and shall be subject to the exclusive
jurisdiction of the Court in the State of Texas in the County of Tarrant.
RETURNS: Products may not be returned without written approval (Return Material Authorization) from the
Company.
Warranty Rev04152008
Direct Outdoor Products, LLC