Tools Needed:
• Jigsaw
• Drill
• Measuring Tape
• Screwdriver
• Square
• Pencil
• Cutout Template
8MQI7IUYMVIHQMR
822.53.200
-S[XS.RWXEPPXLI4YXPIX
Step 1 - Verify the drawer dimensions.
822.53.200
822.53.201
Step 4 - With a 1/2” drill bit, drill a hole in
each corner, being careful not to splinter the
wood on the inside of the drawer box. Using
one of the 1/2” holes, insert a jigsaw and then
make the required cutouts in the drawer box.
Step 2 - Use the technical drawing and ȵip
to the side that corresponds with your
product’s part number.
Step 3 - Locate the proper location for the
receptacle box cutout. You can locate the
proper location from either the inside or
backside of the drawer box, making sure
that the arms will not interfere with the
slides and that there is enough material
surrounding the receptacle box to securely
hold it in place.
•)DLOXUHWRIROORZWKHVHLQVWUXFWLRQV
FDQFDXVHGHDWKRUSHUPDQHQWLQMXU\
'RQRWZRUNRQOLYHHOHFWULFDOFLUFXLWV
0DNHDEVROXWHO\FHUWDLQSRZHULVR
EHIRUHFRQQHFWLQJWKHGHYLFH
• This product is for dry, indoor and
permanent installations only.
• Install the device in accordance with all
national and local electrical codes.
CAUTION – READ CAREFULLY
+'(
