Habey BIS-6621 User manual

21015 Commerce Pointe Drive, Walnut, CA 91789
www.habeyusa.comwww.habeyusa.com
Quick Setup Guide
BIS-6621
Description QTY
BIS-6621 1
Power Cable 1
Power Adaptor 1
Wi Antenna 1
SATA Connector 1
Mounting Rack 1
Mounting Screw Package 1
Packing List
Safety Warning:
The use and installation of this system should only be performed by
professionals. Improper installation of any electronic device or electrical
component can result in serious injury or death. Please make sure that all
safety precautions are taken into account.

Install Guide
Unpack all package contents and inspect
each component. Make sure all included
parts and accessories are present.
Step 1 - Inspect Contents
Using a phillips head screw driver, remove
the four screws on the sides of the enclosure.
Step 2 - Remove Top Cover
Step 3 - Install 2.5” HDD
Using a phillips small head screw driver,
remove the four screws on the bottom cover.
Using a phillips regualr head screw driver,
remove the four screws on the board.
Seperate the bottom cover from the board
and then remove the HDD mounting bracket
from the backplane.

www.habeyusa.comwww.habeyusa.com
Your system is now ready. Connect the power cable to a power source and
press the power button on the front of the system.
Step 5 - Hardware Installation Complete
Mount the HDD on the tray with the four
screws in the small plastic package.
Then mount the HDD bracket back onto the
backplane and x it with four screws.
Use the SATA connector to connect the HDD
with the board as marked in circles.
Take out the four mounting screws from the
screw package and tighen them into the four
mounting holes on the bottom cover.
Place the mounting rack on the top of the
four screws.
Step 4 - Rack Mounting

Input / Output
Dimensions
21015 Commerce Pointe Drive, Walnut, CA 91789
www. habeyusa.com
Copyright©2014. Habey USA. All Rights Reserved. Version 1.
VGA COM
LANUSBHDMI
127mm/ 5”
133.35mm/ 5.25”
48.77mm/ 1.92”
Rear Panel
Front Panel
Audio
ANT
DC
SD/MS/MMC Socket
2x USB2.0
Power Button
IR