Hahdu 7100028-TX User manual

User Manual
Urja remote control egg vibe rechargeable waterproof
7100028-TX
7100028-RX
Transmitter and Receiver
Hahdu Inc
New Industrial Zone, QiuFu Road, Dalang Town,Dongguan City,Guangdong
Province,China.
Tel: [phone]
Fax: [phone]
Note: The information contained in this document is proprietary and confidential
Any unauthorized reproduction, use or disclosure of this material, or any part
thereof, is strictly prohibited.

INTRODUCTION
The product of Egg Vibe is used personal health care, it is small
and individuation so that it is accpted by market of all over the
world.
The product compose with two parts: 7100028-TX (Transmitter) and
7100028-RX (Receiver)
The product operate by wireless system, worked as belowing
description:
Speed I: Press the key one time and hold approximately 2 seconds,
the receiver will vibrate with low speed I.
Speed II: Press the key second time and hold approximately 2 seconds,
the receiver will vibrate with low speed II.
Speed III: Press the key third time and hold approximately 2 seconds,
the receiver will vibrate with high speed I.
Speed VI: Press the key fourth time and hold approximately 2 seconds,
the receiver will vibrate with high speed II.
Power Off: Press the key fifth time and hold approximately 2 seconds,
the receiver will be powered off.
control key

Product parameters
Value
ParaMeter Min Typical Max Unit
Operating(Receiver)
Voltage 3 3.6 4.2 V
Quiescent current 10 30 50 Ua
Current 150 180 220 Ma
Temperature ﹣20 30 60 C°
Battery(Receiver)
Voltage 2.75 3.6 4.2 V
Capaity 250 mah
Size 30*20*05mm
Temperature range ﹣20°C 65°C C°
Storage max.temp ﹣20°C 45°C C°
Weight(approx) 5.6 g
Battery(Transmitter)
Voltage 11.9 12 12.2 V
Capaity 52 mah
Cutoff＠+20C°
Pulse current
Size 23A 3LR50
Temperature range ﹣20°C 60°C C°
Storage max.temp ﹣20°C 45°C C°
Weight(approx) 7.8 g
Frequency characteristics
Frequency 315 MHz
Bandwidth ４50 KHz
Modulation ASK

*** Caution ***
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Changes of modifications not expressly approved by the party responsible for compliance could void
the user ’s authority to operate the equipment.