Haier HWS60-40 User manual

Spin-dryer
HWS60-40
User's manual
This manual is for
Please read this manual
carefully before using.
Retain it for future reference.
HWS60-50

Contents
Safety precautions
The musts in using
Using sequence
Names of the parts
Trouble-Shooting *Answers to question
Spin-drier
Packing list
User's manual
Name Quantity
One piece
Gland
One piece
One piece
Water inlet hose
One set
×°Ïä˵Ã÷
0.02 0.2
Specification
Injection pressure(MPa)
Rated spinning capacity kg 6.0
Warranty card One piece
The 2nd cover
Specification
The 2nd cover
Pcking list

Base frame
Cabinet
Fixing leg
(four pieces)
Back cover
Handle
Inner cover
Control panel
Note:The figures inthis manual canonly be regardedas diagrammatic sketches.
Please understand that,due to constantimprovement of design,the extractor
and its accessories that youhave purchased maybe inconsistent withthese
figures in the manual.
Names of the parts
Spin tub
Water-filling entrance
Drain hose
Cover of the spin tub
Knob of spin timer
Panel support
Power line
Meaning and description of the symbols
Warning sign
Forbidding sign
Contents marked with that symbol are related
to the safety of the product and the personal
safety of the users. Please operate in strict
conformity to the contents, otherwise it may
cause damage of the machine or injure the
personal safety of the user.
Contents marked with that symbol are actions
forbidden to perform. Performing of those
actions may result in damage of the machine
or injure the personal safety of the user.
Please check if the power receptacle has good earthing
condition before using to guarantee your safety.

In case the spin dryer is installed
on ground with carpet , do not block
the ventilation hole with carpet.
Do not share one receptacle with other
electric appliances. Do not use it in
case that the power plug is damaged
or the inserting into the receptacle is
loose.
Do not wash water-proof laundries
such as the raincoat, bicycle shelter
etc. To avoid abnormal vibration
during spinning.
Do not put the machine at damp place
like the bathroom . Never wash it with
water. Do not place wet laundries on the
control panel.
Please insert the power cord into special
receptacle with rated voltage.Be sure to
use single-phase three pins receptacle.If
possible,please adopt electric leakage
protector.
When the machine is normally using,
please put the power plug at the loc-
ation easily to be inserted and extracted
by hand. Be sure to pull the plug off when
there's power failure, or the machine is
being moved, cleaned or when it is idle.
Ventilation hole at
the bottom of the
spin dryer
Do not bend, stretch, twist, bind the power cord by force,
or reform it. Do not press or clamp it with heavy items.
Keep the prong of the power plug clean.
If dust is found on the power plug, please wipe it off with dry cloth.
If the power cord and power plug are bad, or the receptacle is loose,
be sure to have it replaced by the technicians of our special shop
or our agent, or the after-sale service department for the sake
of avoiding any risk.
Safety precautions

Slanting or uneven ground may result in unstable working or abnormal noise.
Please make the machine stand horizontally.
Do not stretch hands into the working
machine. It is dangerous even if the
rotation is slow. Take special care of
the children.
Handicapped or children without care
shall not use the machine.
Do not put any hot or heavy items
( such as the kettle with hot water )
on the washing machine.
Do not decompose, repair or alter the
machine by yourself.
Keep the machine away from direct
sunlight and heat source like the
heater.
Do not wash laundries with volatile
materials (such as thinner, petrol etc.).
Safety precautions
Petrol
Thinner

1
OFF
SPIN TIMER
2
3
4
5
WATER INLET
Usage of the panel
Set the spinning duration
depending on the category
and amount of the articles.
4.If extra drain hose is needed , please make separate
purchase. The inner diameter of the extra hose shall
not less than 30mm, and the length shall not exceed
1.5m.
<10cm
> 30mm
<1.5m
To set to below 1 minute, first
set to 2 minute then turn it
back. it can increase the
service life of the timer
Usage of the drain hose
The drainage shall be smooth with the drain hose.
1.The height of the drain hose shall be less than
10cm , or the drainage will not be smooth enough
and cause incomplete drainage.
2. Do not tramp or press the drain hose.
3. If the drain hose is too long, cut it at mid point.To make
smooth drainage, cut the front end of the hose slantingly.
Water-added rinsing-
spinning,to be used
during defoaming
-spinning.
The musts in using
Please make the machine stand horizontally.
Confirm that the washing machine is earthed reliably . Then insert the power plug
Into the receptacle. Do not connect the earth terminal to the gas pipe and tap
water pipe.
Put down the drain hose .
Preparation before spinning
Using sequence
2
OFF
SPIN TIMER
4
6
8
10
Set the spinning duration
depending on the category
and amount of the articles.
To set to below 2 minute, first
set to 4 minute then turn it
back. it can increase the
service life of the timer
HWS60-40 HWS60-50

Spin process
1Put the laundries in properly
2Put the gland in properly
3Close the inner and outer cover of the spin tub
4Do you need water-added Rinsing-spinnning
Water-added rinsing-spinning has an effect that can remove the surplus liquid dirt,
Spin for about
1~2 minutes
Foam-removing
spinning
Remove most of
the foam extra
detergent liquid. Remove the detergent
liquid remained
The effect is best when the laundries quantity is below 80% of the rated value.
Spin
Fill water for
about 1 minutes Spin for about
1~2 minutes
Note: Refer to the Notes on Spinning carefully.
5 Take the laundry out when the spinning ends.
When the spinningends, open thetop lid andthe interior lid.Then take out
the depression cover and laundry after the spinning drum has stopped
rotation completely.
Note: If there needs no water-added rinsing-spinning , set the duration for
spinning directly.
Water inlet entrance
Water inlet hose
Install the water inlet hose
The water hose should be connected
as shown in the right figure.
It works in a way as follows:
If you need water-added rinsing-spinning , please check the connection
between the waterhose and fillinginlet.
Notes on Spinning
Use the foam-removing spin-
ning to remove the extra deter-
gent liquid. It can both shorten
the washing time and save the
water consumption.
Please put in the gland properly even if the laundries
.
Do not leaveany articles abovethe depression cover.
Push Gland Push
Proper The laundries
are slanting Proper No gland
quantity is small.

1
2
3
4
Hang up the drain hose.
Pull off the power plug and hang up the power cord.
Wipe the complete unit with soft cloth twisted dry.
Open the inner/outer cover of the spin tub for some time (about one hour),
then close them.
Disposal after spinning
1
2
Wipe off the water drops on
the surface and inside the
tub with clean soft cloth.
Be sure to pull off the power
plug before maintenance.
Maintenance
If the cabinetis dirty, wipe itwith wet softcloth
Do not wash it directly by water.
Wipe with neutral detergent if too dirty
Do not wipe with thinner, petrol,
alcohol, etc.
Thinner
Alcohol
Petrol
Trouble-shooting Answer to question
The machine does not act.
Is there power failure--Please use it when there's power supply.
Is the power plug loose--
(If there's breakdown, please pull off the power plug before checking) The following
phenomena are not breakdowns sometimes. Please confirm again before sending
it to repair. If there are real breakdowns, please come to the special maintenance
department or after-sale service department of our company. Do not repair it by yourself.
Phenomena The reason-How to solve
There's abnormal sound
and violent vibration
during spinning
Is the machine slanting--Adjust the machine to be even
Is the gland pressed evenly--
Insert the power plug tightly.
Put the gland in properly
Check if the laundry is inclined to one side--Take it
out and replace it evenly.
Check if thereare any metalarticles in thelaundry.
-- take themout.
Check if itis too full with the laundry-- load the laundry
only in theright amount.
Check if there are any articles out of the spinning drum
-- put them into the drum.