WARNING: STRANGULATION HAZARD
• Never allow cord to touch outside wall of mattress where it could be accessed by infants or toddlers.
• Remove all slack from SnoozyPod cord.
• When lowering the mattress support as your child grows, eliminate any additional slack in the cord.
• Always use provided cord protectors as indicated below and secure cord around crib leg with provided zip tie.
WARNING: SNOOZYPOD CONTROL PANEL IS DESIGNED TO BE POSITIONED OUTSIDE CRIB OR BED RAILS.
ONLY USE SNOOZYPOD IN CRIBS, TODDLER OR TWIN BEDS.
ASSEMBLY INSTRUCTIONS: For FAQ visit www.halosleep.com.
WHAT YOU WILL NEED (NOT INCLUDED): Battery operation - 4 AA Alkaline Batteries, Phillips Head Screwdriver to open battery compartment
INCLUDED: SnoozyPod base, SnoozyPod control panel, power cord, 2 cord protectors, 1 zip tie, quick setup instructions, registration card
STOP: Use caution when opening SnoozyPod packaging. Do not pull on wires when removing SnoozyPod from package.
1. SnoozyPod control panel and SnoozyPod base are attached. Carefully remove both SnoozyPod components together from
packaging. Do not pull on wires.
2. Before assembling SnoozyPod, gently tuck any excess wiring into the neck of the control panel so it does not interfere with the
latching mechanism. Insert SnoozyPod control panel into base until you hear a click.
3. Rotate SnoozyPod and slide through the crib or bed slats, keeping the control panel outside the crib.
4. Plug power cord into neck of SnoozyPod and thread the cord along the underside of SnoozyPod. Cord should exit through the groove.
To secure cords out of reach of children (spring or slat cribs and beds):
5. Thread cord down through middle of mattress support.
6. Guide cord and cord protector along floor to crib or bed leg. Cord should be taut.
7. Wrap cord at least 3 times around crib leg. Thread zip tie through holes in both tubes (A, B, C, D) and secure tubes snuggly to crib leg.
8. Plug power cord into wall outlet.
To secure cords out of the reach of children (platform beds):
5a. Guide cord over platform. Cord should exit crib or bed at the head or foot.
6a. Guide cord and cord protector along crib or bed leg. Cord should be taut.
7. Wrap cord at least 3 times around crib leg. Thread zip tie through holes in
both tubes (A, B, C, D) and secure tubes snuggly to crib leg.
8. Plug power cord into wall outlet.
On/O Music Duration
Volume Vibration Night Light
A
D
2.1. 3.
5.
6.
7.
5a. 6a.
4.
Scan here to view assembly video or visit
www.YouTube.com/HaloSleepSack
IMPORTANT: Read all instructions before assembly and use of this product. Keep instructions for future reference.
Recommended for children 6 months to 5 years (or 40 lbs.). Adult assembly required. Keep small parts away from children.
WARNING
FAILURE TO FOLLOW THESE WARNINGS AND THE INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH.
• Read and follow instructions before assembly and use. If you do not have instructions, DO NOT use this product.
Call 1-888-999-HALO or visit www.Halosleep.com.
• Before installation, inspect the SnoozyPod for damaged hardware, loose or missing components or sharp edges.
• DO NOT use the SnoozyPod if parts are missing or broken. Contact or write Halo Innovations for replacement parts and
instructional literature if needed. DO NOT substitute parts.
• ALWAYS place the unit on a flat surface in an upright position.
• This product is NOT a toy. DO NOT allow children to play with it.
• This product contains small parts. Adult assembly required. Exercise care when unpacking and assembling the product and
keep small parts away from children.
STRANGULATION HAZARD
Children have STRANGLED in cords. Keep power cords out of the reach of children (more than 3 feet
[0.9 meter] away). NEVER leave a cord positioned where a child could reach it. DO NOT use unit near water
(such as bath tub, sink, etc.).
SUFFOCATION HAZARD – INFANTS HAVE SUFFOCATED
• To reduce the risk of SIDS, pediatricians recommend healthy infants be placed on their backs to sleep, unless otherwise
advised by your physician.
• Never use plastic shipping bags or other plastic film as a mattress cover not sold or intended for that purpose.
They can cause suocation.
• Discard all plastic packing materials immediately after opening.
BATTERY SAFETY INFORMATION (BATTERIES NOT INCLUDED)
In exceptional circumstances, batteries may leak fluids that can cause a chemical burn injury or ruin your product.
To avoid battery leakage:
• Do not mix old and new batteries or batteries of dierent types: Alkaline, standard (carbon zinc), or rechargeable
(nickel-cadmium).
• Insert batteries as indicated inside battery compartment.
• Remove batteries during long periods of non-use. Always remove exhausted batteries from the product.
Dispose of batteries safely. Do not dispose of product in a fire. The batteries inside may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type as recommended.
• Do not charge non-rechargeable batteries.
• If removeable, rechargeable batteries are used, they are only to be charged under adult supervision.
IMPORTANT SAFETY INSTRUCTIONS
• Heed all warnings – All warnings on the product and in the operating instructions should be adhered to.
• Follow all instructions – All operating and use instructions should be followed.
• Water and moisture - DO NOT use this apparatus near water. For example, near a bath tub, wash bowl, kitchen sink, laundry
tub, in a wet environment or near a swimming pool and the like. Care should be taken so that objects DO NOT fall onto unit
and that liquids are not spilled onto unit.
• Cleaning - Disconnect all units before cleaning. DO NOT immerse in water. Clean only with dry cloth.
• Servicing - DO NOT attempt to service this product yourself as opening or removing covers (except battery doors)
may expose you to hazards.
• Replacement parts - When replacement parts are required, be sure the replacement parts specified by the manufacturer have
the same characteristic as the original part. Unauthorized substitution may result in fire, electric shock or other hazards.
• Usage - Use this appliance ONLY for its intended use as described in this manual.
• Object and Liquid Entry - NEVER push objects of any kind into this product through casing slots as they may short out parts
that could result in a risk of fire or electric shock. NEVER spill liquid of any kind on the product.
• Power cord protection - Protect the cord from being walked on or pinched by furniture or other items. Power cord should be
routed through the cord protectors (provided).
!
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
The Bluetooth® word mark and logos are owned by the Bluetooth SIG, Inc. and any use of such marks by HALO® is under license.
Made in Huizhou, Guangdong, China. Contains FCC ID: WAP4008 IC: 7922A-4008
22978 SnoozyPod Instructions_US.indd 1 11/21/17 3:35 PM
