7
3. Take out one of the RFID key and pass it close to the induction
area of the enclosure. A beep sound will be given off and the
Green LED (L) indicator will start flashing when the RFID key
works.
4. Now take out the other RFID key and repeat the previous
operation within three minutes.
5. If the setup process is completed successfully, the Green LED
(L) on the case lights up (fixed).
NOTE: The RFID external drive will be back in waiting mode if the
second RFID key can not be sensed in three minutes. Please
repeat the procedure with the RFID keys all over again if you did
not complete the setup.
Establish partitions
1. Once the device is connected and the computer has detected
the hard disk installation, click My Computer icon and select
the Manage option.
2. When the “Computer Management” screen opens, click on the
Disk Management option under the Storage category.
3. Right-click an unallocated region on your hard disk, then select
New partition.
4. The “New Partition Wizard” will start.
5. Select Primary Partition, then click Next.
6. Type the size of the volume you want to create in megabytes
(MB) or accept the maximum default size, and then click Next.
7. Select “Assign the following drive letter.” then click Next.
8. In the “Format Partition” dialog box, do one of the following:
oIf you don't want to format the volume right now, click Do
not format this volume, and then click Next.
oTo format the volume with the default settings (NTFS), click
Next.
9. After your drive has completed formatting, it will say that you
are finished. Click Finish.
10. Once the formatting procedure is completed, the drive will show
up under “My computer” as another hard drive.
