Haneco DUET4W User manual

Thanks for choosing our DUET4W products.
We strongly recommend that you read this manual carefully before installation.
DUET 4W
HANECO LIGHTING TWIN HEAD EMERGENCY LED FLOODLIGHT
For more information
www.haneco.com.au
1300 001 LED (533)
Product Specications
PRODUCT
CODE
MAX POWER
CONSUMPTION
( WHEN CHARGING )
IP
RATING
INPUT
RATING
OPERATING
TEMPERATURE
ELECTRICAL
CLASSIFICATION
EM
TIME
DUET4W 4.5W IP20 220 – 240Va.c.
50/60Hz 0-45° Class II >1.5hr
The Haneco DUET Surface Mount Non-Maintained Emergency LED Floodlight can be installed on plaster walls or solid block surfaces.
The DUET4W comes with a 1.2m ex and plug for easy power connection.
The Haneco DUET4W must be allowed to charge the battery for 16 hours when the tting is connected to un-switched active prior to
operation. The product shall be tested in accordance to the instructions below:
1. Operational test
•Press and hold test button or switch o power, check that both lamps are on.
•Release the test button or switch on power, check that both lamps are o.
2. Duration test
•Press test button once and check that both lamps remain on for at least 2 hours after the rst installation (and at least 1.5 hours for
the following tests). All test results must be recorded in a service logbook that should be kept on-site at all time. Should the unit fail
the test, remedial action must be taken.
For any malfunction such as indicator failure, lamp not illuminated in EM mode or not illuminated for more than 1.5 hours, please check:
•Main power is connected, and turned on.
• Battery is connected.
•Battery, test switch and lamp head for any damage.
• Battery has been allowed to charge for at least 16 hours.
Power circuits may not be powered on most building sites in Australia during construction.
Fittings on these circuits will have their batteries or power storage units discharged.
The LiFePO4 battery of Haneco DUET is designed to perform an excellent long-life in a controlled AS/NZS 60598.2.22 testing environment.
Excessive battery discharging would reduce this performance and cause battery failures.
Battery warranty claims as a result of such abuse are specically excluded from Haneco warranty terms.
Testings
Attention!

For more information
www.haneco.com.au
1300 001 LED (533)
Installation Instructions
Fix four screws on the installation surface.
Put product on the mounting surface, adjust until
tting can sit stable on the mounting screws.
Connect the tting to main by either of the following two ways:
a) Connect the ex and plug with a surface socket or nearby
power outlet directly.
b) Remove ex and plug, wire to main as illustrated below.
Finish the installation and turn power back on.Put the cover back on.
3
5 6
2
4
DUET
Product Code: DUET4W
The luminaire must be installed by a professional electrician.
Always switch the power o when wiring the luminaire.
Ensure input voltage conforms to the voltage range of product.
Ensure wires are securely connected.
Before switching on, ensure that all the wiring is correct.
Warranty is void if product is not installed according to the instructions.
WARNING
HANECO LIGHTING TWIN HEAD EMERGENCY LED FLOODLIGHT
Switch-o main power.
1
257mm
107mm