Hans Grohe Focus E2 31936007 Manual

ZH 用户手册/组装说明 2
EN Instructions for use / assembly instructions 3
Lesezeichen
中文 02
English 03
Focus E²
31936007

2
中文
安全技巧
装配时为避免挤压和切割受伤，必须戴上
手套。
本产品只允许作为洗浴、卫生和洁身之
用。
冷热水管间过大的压力差必须予以平衡。
必须避免让身体敏感部位（如眼睛）接触
到莲蓬头喷水。必须保持莲蓬头与人头之
间有足够的距离。
该产品不得作扶柄使用。必须安装单独的
扶柄。
安装提示
• 安装前必须检查产品是否受到运输损害。
安装后将不认可运输损害或表面损伤。
• 管道和阀门必须根据通用标准进行安装、冲
洗和检查。
• 请遵守当地国家现行的安装规定。
技术参数
本龙头配有EcoSmart®（流量限制器）
工作压强： 最大1MPa
推荐工作压强： 0,1-0,5MPa
测试压强： 1,6MPa
 (1MPa=10bar=147PSI)
热水温度： 最大70°C
推荐热水温度： 65°C
热力消毒: 最大70°C⁄4分钟
• 自动防止回流
• 该产品专为饮用水设计！
符号说明
请勿使用含有乙酸的硅胶！
大小(参见第页11 )
流量示意图(参见第页11 )
手持花洒
浴缸出水口
备用零件(参见第页12)
清洗(参见第页8)
操作(参见第页7)
保养单向阀(参见第页6)
单向阀必须在符合国家或当地的法律
的情况下按照DINEN1717定期检查（
至少一年一次）。
安装(参见第页4)

3
English
Safety Notes
Gloves should be worn during installation to
prevent crushing and cutting injuries.
The product may only be used for bathing,
hygienic and body cleaning purposes.
The hot and cold supplies must be of equal
pressures.
Do not allow the streams of the shower touch
sensitive body parts (such as your eyes). An
adequate distance must be kept between the
shower and you.
The product may not be used as a holding
handle. A separate handle must be installed.
Installation Instructions
• Prior to installation, inspect the product for
transport damages. After it has been installed, no
transport or surface damage will be honoured.
• The pipes and the fixture must be installed,
flushed and tested as per the applicable
standards.
• The plumbing codes applicable in the respective
countries must be observed.
Technical Data
This mixer series-produced with
EcoSmart® (flow limiter)
Operating pressure: max. 1 MPa
Recommended operating pressure: 0,1 - 0,5 MPa
Test pressure: 1,6 MPa
(1 MPa = 10 bar = 147 PSI)
Hot water temperature: max. 70°C
Recommended hot water temp.: 65°C
Thermal disinfection: max. 70°C ⁄ 4 min
• Safety against backflow
• The product is exclusively designed for drinking
water!
Symbol description
Do not use silicone containing acetic acid!
Dimensions (see page 11 )
Flow diagram (see page 11 )
 Hand shower
 Bath Spout
Spare parts (see page 12)
Cleaning (see page 8)
Operation (see page 7)
Maintenance check valve
(see page 6)
The check valves must be checked regularly
according to DIN EN 1717 in accordance
with national or regional regulations (at
least once a year).
Assembly (see page 4)

4
1.
1.
2.
13244187
(1,8 Nm)
2.
1
2 3
SW 27 mm
4 5
Montage Montage

5
SW 3 mm
(2 Nm)
1.
2.
8
6 7
2.
3.
4.
9
1.
11
1.
2.
10
Montage

6
1 2
2.
1.
3
2.
1.
Wartung Wartung

7
max.
1600
冷/cold
开/ open
开 / open
关/close
热/hot
1.
2.
Bedienung

8
QUICK
CLEAN
QUICK
CLEAN
重要说明
肥皂，洗发水、沐浴液、染发剂、香水、刮胡
水、指甲油的残留也会对产品造成损伤。
此处：使用后要小心地用清水将剩余物冲洗干
净。
同样在产品下方不得存放洗涤剂和化学药品，
例如不可放在用于洗脸盆的梳洗柜中否则挥发
气体将损坏产品。
在已经损伤的表面继续使用清洁剂会给表面造
成更大的损伤。
表面损坏的部件必须更换，否则会有
受伤的危险。
不按规定进行清洁而造成的任何损坏不在本公
司产品保修范围之内。
QuickClean
有了QuickClean，手工清洁功能，要去掉喷头上
的水垢，只需简单地搓除即可。
担保
Hansgrohe向用户保证，该产品无制造缺陷。
如果自购买之日起五年内出现缺陷，Hansgrohe
将免费排除。保证条件和详情见www.
hansgrohe-int.com/guarantee。在提出保修的权
利时请联系您的合同方。本保证不涉及有关国
家法律规定的消费权
汉斯格雅产品的清洁建议
现代的卫浴龙头、厨房龙头、花洒、配件、盥
洗台、浴盆和加热器采用的制造材料非常迥
异，以适应产品外形设计和使用功能的市场需
求。
为了避免产品损坏和由此引发的投诉及争议，
必须在使用和清洁产品时遵循有关规程。
在保养汉斯格雅产品时，原则上必须注意：
• 只能使用那些有明确注明是适用于本产品的
清洁剂。
• 不允许使用含有盐酸、蚁酸、氯漂或醋酸的
清洁剂，因为这些清洁剂会给产品表面造成
严重的损伤。
• 含磷酸的清洁剂必须在特定条件下使用。
• 不允许将两种以上清洁剂混合使用。
• 不允许使用具有研磨作用的清洁工具和设
备，如不适合的清洁粉末、海绵垫或超细麦
克布。
• 必须严格遵守清洁剂生产厂商的使用说明。
• 严格遵守清洁剂的用量和作用时间，决不允
许清洁剂的作用时间长于规定值。
• 定期的清洁以预防水垢。
• 不允许将清洁剂直接喷射到汉斯格雅产品
上，因为喷雾会进入汉斯格雅产品的开口部
分和缝隙中而造成损害。首先将清洁剂喷在
软布上，再用软布进行清洁。
• 清洁之后必须用足够的清水冲洗，以彻底去
除残留的吸附物（清洁剂）。
• 不允许使用蒸汽清洗机，高温会损害产品。
中文
Reinigung Reinigung

9
QUICK
CLEAN
QUICK
CLEAN
remove any cleaner residue.
• The use of steam cleaners is not permitted. The
high temperatures can damage the products.
Important
Residues of toiletries such as liquid soaps, shampoos
and shower gels, hair dyes, perfumes, aftershave and
nail varnish can also cause damage.
Here too: Carefully rinse with water after use to
remove residues.
Likewise, do not store any cleaning agents or
chemicals under the products, for example in a vanity
unit, as the vapours may damage the products.
The damage of already damaged surfaces will
deteriorate under the effect of the cleansers.
Components with damaged
surfaces must be exchanged,
otherwise there could be an injury
danger.
Damage caused by improper treatment will not be
covered by our guarantee.
QuickClean
The QuickClean cleaning function only needs a small
manual rub over to remove the lime scale from the
spray channels.
Warranty
Hansgrohe guarantees to the consumer that this
product is free of production faults. If evertheless any
defect is detected within 5 years from date of
purchase, Hansgrohe will remedy this defect free of
charge. You will find the conditions and details of this
guarantee at www.hansgrohe-int.com/guarantee.
Please contact your contracting party to claim your
rights under this guarantee. This guarantee does not
affect the customer‘s rights under the respective
national legislation.
Cleaning Recommendation for Hans-
grohe Products
Today, modern sanitary and kitchen tapware,
showers, accessories, washstands, tubs and radiators
consist of very different materials to comply with the
needs of the market with regard to design and
functionality.
To avoid damage and reclamations, it is necessary to
consider certain criteria when cleaning.
With regard to caring for the Hans-
grohe products, the following must in
principle be heeded:
• Only use cleaning material which is explicitly
provided for this type of application.
• Never use cleaning materials, which contain
hydrochloric acid, formic acid, chlorine pale lye or
acetic acid, as they cause considerable damage.
• Phosphorus acidic cleaners are only conditionally
applicable.
• Mixing cleaning agents is not permitted, generally.
• Never use cleaning materials or appliances with
an abrasive effect, such as unsuitable cleaning
powders, sponge pads or micro fibre cloths.
• The instructions of the cleaning agent manufactur-
ers have to be followed absolutely.
• Cleaning has to be carried out with a specified
cleaner dosage, contact time, object-related and
adapted to the needs.
• The building up of calcifications has to be removed
by cleaning regulary.
• When using spray cleaners, spray the cleaning
solution onto a soft cloth or sponge, never directly
onto the Hansgrohe products, as the atomised
spray could enter openings and gaps in the
Hansgrohe products and cause damage.
• After cleaning rinse thoroughly with clean water to
English
Reinigung

10
> 1 min
3
5
12
6
4
93339000
94246000
Reinigung

11
125125 125
bar
4,5
0,0
0,5
1,0
1,5
2,0
2,5
3,0
3,5
4,0
5,0
0,45
0,00
0,05
0,10
0,15
0,20
0,25
0,30
0,35
0,40
0,50
5,50,55
6,00,60
036912 15 18 21 24 27 30
MPa
00,1 0,2 0,3 0,4 0,5
Q = l/min
Q = l/sec
2
1
Maße/DurchflussdiagrammMaße/Durchflussdiagramm

12 Hansgrohe · Auestraße 5 - 9 · D-77761 Schiltach · Telefon [phone] · Telefax +49 (0) 7836/511440
E-Mail: [email protected] · Internet: www.hansgrohe.com
04/2019 9.04967.51
97779000
98749000
31098000
28562007
98400000
(39x1,5)
97660000
98607000
95941000
95929000
13914000
95819000
94246000
93339000
28071000
94074000
97159000
96775000
98217000
(9x2,5)
98183000
(23x2,5)
98189000
(14x2,5)
98185000
(22x2)
94184000
Serviceteile Serviceteile