Harbor Freight Tools 41637 Quick reference guide

Bird Bath
Girl with Umbrella
41637
ASSEMBLY & OPERATING INSTRUCTIONS
3491 Mission Oaks Blvd., Camarillo, CA 93011
Visit ourWeb site at:http://www.harborfreight.com
Copyright 1999 by Harbor FreightTools®. All rights reserved. No portion of this manual or
any artwork contained herein may be reproduced in any shape or form without the express
written consent of Harbor FreightTools.
For technical questions and replacement parts, please call 1-800-444-3353.
®

THANKYOU for choosing a HARBOR FREIGHTTOOLS product. For future reference, please complete the
owner’s record below:
Model______________ Serial No._______________ Purchase Date________________
SAVE THE RECEIPT,WARRANTY AND THESE INSTRUCTIONS. It is important that you read the entire
manual to become familiar with the unit BEFORE you begin assembly.
Technical Specifications
Tool Name:Cast Aluminum Bird Bath-Girl with Umbrella
Item Number: 41637
BowlDimensions: 16" Inside Diameterand20" Outside Diameter
Material: Cast Aluminum
Bath Height: 29"
Base: Cast Iron
Base Dimension: 14-1/2" Diameter
Overall Dimensions: 41" H x 20" Diameter
Figure height: 13-1/4" x 2-7/8" x 1-3/4"
Pedal: 3”Diameter
Finish: GreenVerdigris
Warning: The warnings, cautions and instructions discussed in this instruction manual
cannot cover all possible conditions and situations that may occur. It must
be understood by the operator that COMMON SENSE AND CAUTION ARE
FACTORS WHICH CANNOT BE BUILT INTOTHIS PRODUCT, BUT
MUST BE SUPPLIED BYTHE OPERATOR.
The Operator
Do not operate the product if under the influence of alcohol or drugs. Read warning labels on prescriptions to
determine if your judgment/reflexes might be impaired.
Do not wear loose clothing or jewelry as they can be caught in moving parts.
Protective gloves and non-skid footwear is recommended.
Wear restrictive hair covering to contain long hair.
Use eye and ear protection. Always wear ANSI approved impact safety goggles.
Maintain proper footing and balance at all times.
#41637 Page 2

Work Area
TO AVOID RISK OF PERSONAL INJURY, EQUIPMENT DAMAGE, FIRE AND SHOCK, MAKE SUREYOUR
WORK AREA IS:
Free of damp, wet or rainy conditions.
Free of children (never let them handle tools or machinery).
Clean and uncluttered.
Assembly
Your Bird Bath comes unassembled. Please refer to the Parts List on this page and the Assembly Diagram on
page 4 prior to assembly. It is important that your read the entire manual to become familiar with the unit
BEFORE you use it.
Before assembling the Bird Bath, lay out all the parts on a work space or clear area of the floor. Be sure that
you have all parts described in the Parts List.
Step 1) The Girl/Umbrella (part A) has a threaded screw at the bottom which is to be inserted through
theTray (part E), through theTray Supporter (part F), through the Bowl (part B) and screwed
into the Column (part C). Secure the Girl/Umbrella and the rest of the assembly in place by
sliding on a washer (part G) and then by screwing on the Nut (part G) until tight and secure.
Step 2) The Bowl (part B) has three (3) screws (part H) which are inserted downward into the
corresponding holes in the Column (part C). Slide a Washer onto the screw and secure it in
place with the nut. Repeat for all three (3) screws.
Step 3) The Column (part C) has three (3) large threaded screws (part I) facing out from the bottom.
Insert these downward through the holes in the Base Pad (part D). From the bottom, secure
the Column and assemble to the Base Pad by screwing on a washer and then a nut onto each
of the three (3) screws.
Step 4) Check to make certain that all hardware is securely assembled.
Step 5) Set your Bird Bath up on a firm and level spot in your yard. Fill up the bowl with water.
Unpacking
UNPACK AND CHECK CONTENTS
When unpacking your Cast Aluminum Bird Bath, check to make sure the following parts are included. If any
parts are missing or broken, please call HARBOR FREIGHTTOOLS at 1-800-444-3353.
Parts List - #41637
Part # Description Quantity Part # Description Quantity
A Girl with Umbrella 1 F Tray Supporter 1
B Bowl 1 H Screw 6x35, Nut andWasher - 6 mm 3
C Column 1 I Screw 8x35, Nut andWasher - 8 mm 3
D BasePad 1 J Bolt8x20 andWasher - 8mm 2
E Tray 1 K Junction 1
LPump 1
M Pump shelf 1
#41637 Page 3

#41637 Page 4
Bird Bath Assembly Diagram
PLEASEREADTHEFOLLOWING CAREFULLY
THEMANUFACTURERAND/ORDISTRIBUTORHASPROVIDEDTHE PARTSDIAGRAMINTHIS MANUALAS
A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBUTOR MAKES ANY
REPRESENTATIONORWARRANTYOF ANYKINDTOTHEBUYERTHATHEORSHEISQUALIFIEDTOMAKE
ANY REPAIRS TO THE PRODUCT OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OFTHE
PRODUCT. INFACT,THEMANUFACTURERAND/ORDISTRIBUTOREXPRESSLYSTATESTHATALLREPAIRS
AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS
ANDNOT BYTHE BUYER.THEBUYERASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER
REPAIRSTOTHE ORIGINALPRODUCTOR REPLACEMENTPARTSTHERETO,ORARISING OUTOF HISOR
HERINSTALLATION OF REPLACEMENTPARTSTHERETO.