Hardy Diagnostics 234100HD User manual

UV Chamber
UV light decontamination of
N95 masks

HardyDiagnostics.com
UV Chamber
Decontamination by UV light
The unit is capable of accommodating other wave length bulbs, 254 nm, 306 nm and
368 nm bulbs. No manual calibration required when switching between wavelengths.
• UV decontamination and
sanitization
• Sanitizes four N95 masks
at one time, in 4 minutes
(120 seconds per side)
• Two modes of operation –
Energy or Time
• Open Door Safety
mechanism
• Energy Ecient electronic
ballasts
• Small footprint
• 2 Year Manufacturer’s
Warranty
• UL/CSA/CE Approved
• The unit comes equipped
with 5 x 254 nm
Shortwave Bulbs
Never run out of N95 masks
again. Quickly sanitize
them using UV light.
Cat. no.
234100HD

[e-mail] 800.266.2222
Using the UV Chamber for
Mask Decontamination
1. Power on
4. Open the unit 6. Close the unit
5. Place up to four N95
masks face up
8. When the cycle finishes,
open the unit
9. Remove N95 masks and
turn them over
2. Select energy mode 3. Set to 1,000,000μJ
7. Press the Start Botton
10. Place N95 masks back
inside the unit and close
15. Press the Start Botton to
Decontaminate the unit
11. Press the Start Botton
12. When the cycle finishes,
open the unit
13. Remove N95 masks
14. Close the unit once it is
empty

Headquarters
1430 West McCoy Lane
Santa Maria, CA 93455
800.266.2222
[e-mail]
HardyDiagnostics.com
Distribution Centers
Santa Maria, California
Olympia, Washington
Salt Lake City, Utah
Phoenix, Arizona
Dallas, Texas
Hardy Diagnostics has a Quality
Management System that is certified
to ISO 13485 and is a FDA licensed
medical device manufacturer.
070120ssCopyright © 2020 Hardy Diagnostics
Springboro, Ohio
Lake City, Florida
Albany, New York
Raleigh, North Carolina
UV Chamber