Harley Benton HB-20G User manual

User manual
HB-20G Guitar Amplifier
Contact:
Musikhaus Thomann
Treppendorf 30
96138 Burgebrach - Germany
Phone.: [phone]
Fax: [phone]
Web: www.thomann.de
E-mail: [email protected]
PRECAUTIONS
WARNING:
This appliance must be earthed. Please check that the supply
voltage details given on the rating label (located on the rear
panel) are in accordance with your electricity supply.
INSTRUCTIONS FOR USE:
- Plug the mains lead into a suitable power socket.
- Connect your guitar/bass to the input socket of the amplifier
- Turn the volume control to the left position and the EQ
controls to the middle.
- Power on the amplifier.
- Adjust the volume level with the equivalent volume control to
your desired level.
WARNINGS:
If, after you have followed the instructions outlined above, your
amplifier fails to function, please contact your local distributor.
Under no circumstances remove the rear panel of the amplifier.
Electrical appliances must never be used where there is a
danger of water splashing or dripping onto the unit.
Your attention is drawn to the instructions printed on the notice
attached to the back of the amplifier.
Exposure to extremely high noise level may cause a permanent
hear loss. Individuals vary considerably to noise induced hearing
loss but nearly everyone will lose some hearing if exposed to
sufficiently intense noise for a prolonged time.
© 2004 Musikhaus Thomann - 96138 Burgebrach.
R - 281204 KR

RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR.
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK
DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE.
C AU TIO N :
IN PU T PO W ER
40W MAX
230VAC~50Hz
1. Input: This is an instrument input for plugging in
virtually anything. You may plug in a guitar
(bass or lead), keyboard, CD-Player or any
pre-amplified signal.
2. Overdrive: This push button switches between the clean
and overdrive channels.
3. Gain: This is the distortion intensity control for the
overdirve channel.
4. Volume: This is the overall level control for the
overdrive channel
5. Volume: This is the overall level control for the normal
channel
6. Treble: EQ control for high frequency range (3kHz)
7. Middle: EQ control for mid frequency range (1kHz)
8. Bass: EQ control for low frequency range (100Hz)
9. Headphones: Inserting a headphone jack will disconnect
internal speaker for quiet private practicing.
10. Line Output: Line signal output, Impedance = 1k ohms
11. Power: Power switch
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION:
CAUTION: Chassis surface hot.
WARNING: To reduce the risk of fire or electric shock,
do not expose this equipment to rain or moisture.
AVIS: Risque de choc electricque ne pas ouvrir.
ATTENTION: Superficie de chassis chaude.
1. AC Line Cord
Technical Specifications:
Back Panel:Front Panel:
20W RMS @ 4 ohms (Overdrive)
14W RMS @ 4 ohms (Clean)
Frequency Response 70Hz - 10kHz
THD 0,5% (Clean)
S/N ratio 75dB
Input Impedance 220k Ohm
Power Consumption 40VA (max.)
Maximum Input Level 0.7Vrms
Dimensions (HxWxD) 340mm x 380mm x 175mm
Weight 7,0kg
Rated Power