Harman Kardon HKTW 6 User manual

ACOUSTIC & ELECTRICAL SPECIFICATIONS:
•Nominal Impedance 8Ω
•Max Amp Power 150 watts*
•Frequency Response 48Hz – 20kHz
•Sensitivity 89dB (2.83V @ 1 meter)
•Crossover Frequency 2,800Hz
SYSTEM COMPONENTS:
•Cabinet HKTW 6
(Not for Sale)
•Grille 339782-001
•Low-Frequency Transducer 6" (152mm) Polymer-coated
cone, shielded
339788-001
DC Resistance 4.6 ohms ±10%
•High-Frequency Transducer 3/4" (19mm) Titanium-laminate
dome, shielded
338035-001
DC Resistance 3.0 ohms ±10%
•Crossover Network 339801-004
AURAL SWEEP TEST SPECIFICATIONS:
•System Aural Sweep Test 6.0V Input 40Hz to 20kHz
•L.F. Aural Sweep Test 5.0V Input 40Hz to 3kHz
•H.F. Aural Sweep Test 2.83V Input 2kHz to 20kHz
PHYSICAL SPECIFICATIONS:
•Dimensions 34-1/2" x 8-1/2" x 10"
(H x W x D) (876mm x 216mm x 254mm)
•Weight 29.5 lb (13.4kg) Each
WARRANTY:
•Refer to Warranty Statement packed with each product.
*The maximum recommended amplifier power rating will ensure
proper system headroom to allow for occasional peaks. We do not
recommend sustained operation at these maximum power levels.
Technical Manual
HKTW 6
HKTW 6
Harman Kardon, Incorporated, 250 Crossways Park Drive, Woodbury, New York 11797 6/03
Legend on Page 2
3
21
3
4
11
.250
.205
INPUT
L2
0.066mH
L1
1.8mH
C2
12uf
100V
.110
L.F.
H.F.
C1
9uf
100V
R1
3.6ohm
10W
+
—
.205
CROSSOVER NETWORK
339801-004
HIGH-FREQUENCY
TRANSDUCER
338035-001
LOW-FREQUENCY
TRANSDUCER
339788-001
36" GRN
36" GRN/BLK
36" YEL/BLK
36" YEL
YEL/BLK
YEL
+— GRN/BLK
GRN
+
—
PACKAGING HKTW 6 WIRING DIAGRAM
HKTW 6 SCHEMATIC

HKTW 6 Cabinet – Not for Sale
10
7
6
12
11
18
16
14
13
5
15
8
9
16
17
(4)
(4)
(6)
(2)
(6)
(6)
(4)
HKTW 6
Technical Manual
HKTW 6
EXPLODED VIEW
Harman Kardon, Incorporated, 250 Crossways Park Drive, Woodbury, New York 11797 6/03
TO SERVICE THE HKTW 6
1. Remove the grille.
2. Remove all (6) rubber grille retainers; this can be accomplished by carefully pulling them out of their cavities with long-nosed pliers or similar tool.
3. Remove the (6) Phillips screws that are now exposed.
4. Carefully separate the front baffle, with tweeter attached, from the cabinet.
ITEM
NO. DESCRIPTION QTY. PART NO.
1. Owner’s Manual 1 339777-001
2. Warranty Card 1 339778-001
3. Top & Bottom Pads 2 350509-001
4. Outer Carton 1 339818-001
5. Spike Foot Set 4 331360-001
6. Tweeter 1 338035-001
7. Tweeter Hold-Down Bar 1 338059-001
8. Front Faceplate 1 350348-001
9. Faceplate Gasket 1 339773-001
10. Woofer 1 339788-001
ITEM
NO. DESCRIPTION QTY. PART NO.
11. Grille 1 339782-001
12. Grille Retainer 6 338535-002
13. Port Tube 1 339796-001
14. Crossover Network 1 339801-004
15. Screw (front baffle) PB PPH M4 x 20mm 6 910501-020
16. Screw (6 woofers, 4 network) 10 903401-012
PB PPH #6 x .75 BLK
17. Screw (tweeter) MS PHH H/L 2 905402-010
6-19 x 5/8 ZNC
18. Threaded Insert – 4401 4 63154