Harman JBL STADIUM BASSHUB User manual

Owner's Manual -
Manual del propietario -
~
Mode d'emploi -

THANK YOU FOR YOUR PURCHASE ...
Your JBL product has been designed to provide you with
the performance and ease of operation you would expect
from JBL.
• Please take time to read your owner's manual in its
entirety before operating or installing your subwoofer.
• Keep the owner's manual for your amplifier in your glove
compartment along with the owner's manual for your car.
• Put your subwoofer sales receipt with other important
documents in orderto expedite warranty service if
needed.
ABOUT THE MANUAL
This manual describes general installation guidelines
and operation instructions. However, please note that
proper installation of mobile audio and video components
requires qualified experience with mechanical and electrical
procedures . If you do not have the knowledge and tools to
successfully perform this installation, we strongly recommend
consulting an authorized JBL dealer about your installation
options. Keep all instructions and sales receipts for reference.
Consider this manual as an indispensable feature of your
subwoofer.
WHAT'S IN THE BOX
1x Stadium BassHub
1x wiring harness
1x vehic le mounting post
1x vehicle mounting adapter
1x 2.5mm Allen wrench
1xQuick-start guide
~
0
lX
T
I)
MOUNTING THE STADIUM BASSHUB
The Stadium BassHub mounts inside the rim of the spare tire
in your trunk. To mount the Stadium BassHub properly, follow II
these steps:
1. Remove the vehicle's spare mounting post.
2. Make sure that the spare tire is placed in the trunk with
the outside of the tire facing downwards; the back of
the rim should be facing you. This will ensure sufficient
mounting depth for the Stadium BassHub.
3. Carefully place the Stadium BassHub inside the rim of
the spare tire.
4. Insert the Stadium BassHub mounting post into the slot
in the center of the Stadium BassHub. When it reaches
the spare tire mounting bracket, begin turning clockwise
to thread the post into the bracket and tighten.
NOTE : Some applications require the use of the included
adapter to provide a threaded slot for the mounting post.
Insert the adapter into the spare tie-down bracket and twist
to lock into place. Then repeat steps 3 and 4 above.
NOTE : To keep from damaging the Stadium BassHub or the
spare tire rim, do not overtighten the mounting post.
Take out the original base
T
I
gil

CONNECTING THE WIRING
HARNESS
To connect the speaker wiring harness to the input on the
right side of the Stadium BassHub:
1. Use the included 2. 5mm Allen wrench to remove two
screws securing the cover on the top panel of the
Stadium BassHub .
2. Lift off the cover.
Insert the harness into the input.
WIRING THE STADIUM BASSHUB TO
YOUR AMPLIFIER
The Stadium BassHub features dual 4-ohm voice coils that
can be wired in series for an 8-ohm impedance load or in
parallel for a2-ohm impedance load. Be sure to observe
proper wire polarttx.
Plug diagram:
SUB SUB SUB SUB
2- 2+ 1- 1+
□□□□
□□□□
SUB SUB SUB SUB
2- 2+ 1- 1+
For parallel wiring :
1. Connect the SUB1 + and SUB2+ wires to the+ output on
the amplifier.
2. Connect the SUB1- and SUB2- wires to the -output on
the amplifier.
For series wiring:
1. Connect the SUB 1+ wire to the + output on the amplifier .
2. Connect the SUB2 - wire to the- output on the amplifier .
3. Splice the SU81- and SUB2+ wires together.
~~=v
IMPORTANT : Make sure your amplifier is compatible
with your desired impedance load. Connecting a 2-ohm
impedance load to an amplifier that is not rated for 2 ohms
can cause the amplifier to overheat and malfunction or
damage the vehicle.
SPECIFICATIONS
• Power handling : &XJW RMS, 1200W peak
• Frequency Response : 20Hz - 150Hz
• Sensitivity (@2.83V/ 1 m): 90d8
• Vo ice Coil diameter, each : 2.5in. (64mm)
• Impedance : Dual 4 ohms
• Dimensions (D x H): 14-3/16" x 6-1 /2" (D360mm x
H164.5mm)

~
HARMAN
~
· HARMAN International Industries,
Incorporated 8500 Balboa Boulevard,
Northridge, CA 91329 USA
www.jbl.com
© 2020 HARMAN International Industries, Incorporated. All rights reserved.
JBL is atrademark of HARMAN International Industries, Incorporated,
registered in the United States and/orothercountries. Features, specifications
and appearance are subject to change without notice.
JBL Stadium Ba ssHub_OM_VI