Harris NEO GPS-3903 Installation and operating manual

GPS-3903
Antenna and Receiver
Safety Instructions and Regulatory
Compliance Manual
Edition A
175-000385-00

GPS-3903
Antenna and
Receiver
Safety Instructions
and Regulatory
Compliance
Edition A
February 2007
Insert Logo Here if Applicable

GPS-3903 Antenna and Receiver Safety Instructions and Regulatory Compliance iii
Preface
Purpose
This manual provides details on the safe use of GPS-3903
antenna and receiver systems. This manual supersedes all
other Harris GPS receiver product safety information.
Audience
This manual is written for technicians and operators
responsible for the installation, setup, and/or operation of
GPS-3903 antenna and receiver systems.
Revision History
Revision History
Edition A February 2007

Preface
iv GPS-3903 Antenna and Receiver Safety Instructions and Regulatory Compliance

GPS-3903 Antenna and Receiver Safety Instructions and Regulatory Compliance 1
Important Safety Instructions
Review the following safety precautions to avoid injury and
prevent damage to this product or any products connected to
it. Read these instructions. Keep these instructions. Heed all
warnings. Follow all instructions.
Servicing
Only qualified personnel should perform service procedures.
Refer all servicing to qualified service personnel. Servicing is
required when the apparatus has been damaged in any way,
including the following:
•Spillage of liquids into the apparatus
•Damage to the power-supply cord or plug
•Exposure of the apparatus to rain or moisture
•Abnormal operation
•Physical damage from dropping
Terms and Symbols Found in This
Manual
WARNING statements identify conditions or practices that can result in
personal injury or loss oflife. High voltage is present.Uninsulated dangerous
voltage within the product’s enclosure may be sufficient to constitute a risk of
electric shock to persons.
CAUTION statements identify conditions or practices that can result in
damage to the equipment or other property. Important operating and
maintenance (servicing) instructions are included in the literature
accompanying the product.

Important Safety Instructions
2 GPS-3903 Antenna and Receiver Safety Instructions and Regulatory Compliance
Product Damage Precautions
Review the following safety precautions to avoid injury and
prevent damage to this product or any products connected to
it. Read these instructions. Keep these instructions. Heed all
warnings. Follow all instructions.
Do Not Use This Apparatus Near Water
Clean Only with a Dry Cloth
Do Not Block Any Ventilation Openings
Do not block any of the ventilation openings. Install in
accordance with the manufacturer’s instructions.
Keep Product Away from Heat Sources
Do not install near any heat sources such as radiators, heat
registers, stoves, or other apparatus (including amplifiers)
that produce heat.
Ground the Product
Do not defeat the safety purpose of the polarized and
grounding-type plugs. A polarized plug has two blades with
one wider than the other. A grounding-type plug has two
blades and a third grounding prong. The wide blade or the
third prong are provided for your safety. When the provided
plug does not fit into your outlet, consult an electrician for
replacement of the obsolete outlet.
Protect the Power Cord
Protect the power cord from being walked on or pinched,
particularly at plugs, convenience receptacles, and the
point where they exit from the apparatus.
Only Use Attachments/Accessories Specified by the
Manufacturer
Use with Proper Equipment
Use only with a cart, stand, tripod, bracket, or table
specified by the manufacturer or sold with the apparatus.
When a cart is used, use caution when moving the cart/
apparatus combination to avoid injury from tip-over.

GPS-3903 Antenna and Receiver Safety Instructions and Regulatory Compliance 3
ImportantSafetyInstructions
Do Not Operate With Suspected Failures
Refer all servicing to qualified service personnel. Servicing
is required when the apparatus has been damaged in any
way, such as if the power-supply cord or plug is damaged,
liquid has been spilled or objects have fallen into the
apparatus, or the apparatus has been exposed to rain or
moisture, does not operate normally, or has been dropped.
Use Proper Power Source
Do not operate this product from a power source that
supplies more than the specified voltage.
Install Near Socket Outlet
The equipment shall be installed near the socket outlet, and
a disconnect device shall be easily accessible.
Isolate the IT Power Source
IT pow ersy stem sh allbe iso lated from earth,exceptthatone point
maybe co n n ected to earth through an impedanceora voltage
limiter.Theparts ofthe equ ipm entrequ ired to be earthed sh allbe
co n n ected to earth electrodesatthe user’s prem ises.Protective
earthing sh allbeprovided eitherdirectly to the equipm entorinto
the mainssupply building installation.
ATTENTION:
Observe precautions for handling electrostatic-sensitive
devices.
Fuse Replacement
CAUTION: For continued protection against the risk of
fire, replace only with the same type of fuse: T 250 mAH,
250 V.
French:
ATTENTION: Rem placer uniq u em en tparun fusible demême
type etcalibre.

Important Safety Instructions
4 GPS-3903 Antenna and Receiver Safety Instructions and Regulatory Compliance
Injury Precautions
Warning!
To reduce the risk of fire or electric shock, do not expose
this apparatus to rain or moisture.
French:
AVIS: Risq u e dechoc électrique.Nepasouvrir.
Warning!
Potentially lethal voltages are present within this product’s
frame during normal operation. The AC power cord must be
disconnected from the frame before the top panel is
removed. (In frames with multiple power supplies, remove
ALL power cords.) Power should not be applied to the
frame while the top is open, unless properly trained
personnel are servicing the unit.
Poland:
Przod zd jeciem pokryw y wyciagn ac wtyczke z gniazda sieciow ego.
Use Proper Power Cord
To avoid fire hazard, use only the power cord specified for
this product.
Connect to an Earthed Mains Socket-Outlet
The apparatus must be connected to an earthed
socket-outlet.
Sweden:
Apparaten skall anslutas till jordat uttag nar den ansluts till
ett natverk.
United Kingdom:
WARNING:This appliance must be earthed.
Do Not Operate Without Covers
To avoid electrical shock or fire hazard, do not operate this
product with covers or panels removed.
Do Not Operate in an Explosive Atmosphere
To avoid injury or fire hazard, do not operate this product in
an explosive atmosphere.

GPS-3903 Antenna and Receiver Safety Instructions and Regulatory Compliance 5
ImportantSafetyInstructions
Avoid Exposed Circuitry
To avoid injury, remove jewelry such as rings, watches, and
other metallic objects. Do not touch exposed connections
and components when power is present.
Isolate IT Power System Connection
CAUTION IT power system shall be isolated from earth,
except that one point may be connected to earth through an
impedance or a voltage limiter. The parts of the equipment
required to be earthed shall be connected to earth
electrodes at the user's premises. Protective earthing shall
be provided either directly to the equipment or into the
mains supply building installation.
Preventing Electrostatic Discharge
CAUTION Electrostatic discharge (ESD) can damage
components in the product. To prevent ESD, observe these
precautions when directed:
lUse a ground strap. Wear a grounded wrist strap to
discharge the static voltage from your body while
installing or removing sensitive components.
2Use a safe work area. Do not use any devices
capable of generating or holding a static charge in the
work area where you install or remove sensitive
components. Avoid handling sensitive components in
areas that have a floor or benchtop surface capable of
generating a static charge.
3Handle components carefully. Do not slide sensitive
components over any surface. Do not touch exposed
connector pins. Handle sensitive components as little
as possible.
4Transport and store carefully. Transport and store
sensitive components in a static-protected bag or
container.
CAUTION To completely disconnect this equipment from
the AC Mains, disconnect the power supply cord plug from
the AC receptacle.
CAUTION Do not expose this equipment to dripping or
splashing and ensure that no objects filled with liquids, such
as vases, are placed on the equipment.

Important Safety Instructions
6 GPS-3903 Antenna and Receiver Safety Instructions and Regulatory Compliance
Safety Symbols Found on the Product
DANGER—Indicates a hazard for high voltage, fire, or
personal injury immediately accessible as one reads the
marking
WARNING—Indicates a personal injury hazard that is not
immediately accessible as one reads the marking
CAUTION—Indicates a hazard to property including the
product or the need to take attention and refer to the
manual
Protective ground (earth) terminal
Fuse—Replace with the same type and rating of fuse: T
250 mAH, 250 V.
Observe precautions for handling electrostatic-sensitive
devices.

GPS-3903 Antenna and Receiver Safety Instructions and Regulatory Compliance 7
Certifications and Compliances
The GPS-3903 Antenna and Receiver complies to all
applicable Canadian, US, Europe, and International safety
certifications and compliances.
EMC Standards
This product has been tested and found to comply with part 15
of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference
received, including interference that may cause undesired
operation.

Certifications and Compliances
8 GPS-3903 Antenna and Receiver Safety Instructions and Regulatory Compliance
EU Standards
Restriction on Hazardous Substances (RoHS)
Compliance
Directive 2002/95/EC—commonly known as the European
Union (EU) Restriction on Hazardous Substances (RoHS)—
sets limits on the use of certain substances found in electrical
and electronic equipment. The intent of this legislation is to
reduce the amount of hazardous chemicals that may leach out
of landfill sites or otherwise contaminate the environment
during end-of-life recycling. The Directive, which took effect
on July 1, 2006, refers to the following hazardous substances:
•Lead (Pb)
•Mercury (Hg)
•Cadmium (Cd)
•Hexavalent Chromium (Cr-V1)
•Polybrominated Biphenyls (PBB)
•Polybrominated Diphenyl Ethers (PBDE)
According to this EU Directive, all products sold in the
European Union will be fully RoHS-compliant and
“lead-free.” (See our Web site, www.broadcast.harris.com/
leitch, for more information on dates and deadlines for
compliance.) Spare parts supplied for the repair and upgrade
of equipment sold before July 1, 2006 are exempt from the
legislation. Equipment that complies with the EU directive
will be marked with a RoHS-compliant emblem, as shown in
Figure P-1.
Figure 1. RoHS Compliance Emblem

GPS-3903 Antenna and Receiver Safety Instructions and Regulatory Compliance 9
Certificationsand Compliances
Waste from Electrical and Electronic
Equipment (WEEE) Compliance
The European Union (EU) Directive 2002/96/EC on Waste
from Electrical and Electronic Equipment (WEEE) deals with
the collection, treatment, recovery, and recycling of electrical
and electronic waste products. The objective of the WEEE
Directive is to assign the responsibility for the disposal of
associated hazardous waste to either the producers or users of
these products. Effective August 13, 2005, producers or users
will be required to recycle electrical and electronic equipment
at end of its useful life, and may not dispose of the equipment
in landfills or by using other unapproved methods. (Some EU
member states may have different deadlines.)
In accordance with this EU Directive, companies selling
electric or electronic devices in the EU will affix labels
indicating that such products must be properly recycled. (See
our Web site, www.broadcast.harris.com/leitch, for more
information on dates and deadlines for compliance.) Contact
your local sales representative for information on returning
these products for recycling. Equipment that complies with
the EU directive will be marked with a WEEE-compliant
emblem, as shown in Figure P-2.
Figure 2. WEEE Compliance Emblem

Certifications and Compliances
10 GPS-3903 Antenna and Receiver Safety Instructions and Regulatory Compliance

Broadcast Communications Division
4393 Digital Way | Mason, OH USA 45040 | Tel: [phone]
www.broadcast.harris.com
©2007 Harris Corporation
Harris is a registered trademark of Harris Corporation. Trademarks and tradenames are the property of their respective companies.
Customer Service Support
[phone]