Hawk X90 User manual
HA-X90 OWNER GUIDE
2
ArmAlarm Disarm alarm
Bike Finder Remote start
Congratulations on the purchase of your state of the art Motorcycle / Scooter
security system. This system has been designed to provide years of trouble-
free operation.
HA- X90 Pro v5 is a reliable Motorcycle / Scooter alarm system, which provides
2 designs to prevent thieving. The first design is to use the loud siren. When any
illegal intrusion happens, the siren will sound loudly to warn the intruder. The
second design is to use an immobilisation system to disable the engine start.
This owner’s guide should help you to get the most out of your system.
Please take the time to read it prior to using the system.
HAWK HA-X90 Pro system consists of the following main components:
•Two military grade encrypted LCD Remote transmitters
•Main unit with remote start
•Dual zone HAWKGUARD shock sensor
•Built in Tilt Sensor
•LED
HA-X90 OWNER GUIDE
3
•Built in engine immobiliser relay
•125db siren
•1 x HAWK sticker
•Universal Wiring Harness
Important: When installing a Hawk Alarm to any vehicle fitted with LED indicators (turn
signals) it is responsibility of the installer to verify the indicators are powered by DC 12v & not
CANBUS controlled. If there is any doubt this DO NOT connect the indicators otherwise
irreversible component damage may occur. Commercial Electronics Co Ltd accepts no
responsibility for any damage caused by incorrectly chosen wiring connections.
ARMING THE ALARMSYSTEM
4
To arm the alarm system, turn the ignition switch OFF,
press the button, indicators will flash once; with
single audible bleep LED starts to flash and LCDremote
fob will bleep once, the alarm system will enter into
the arming status after 5 seconds. LCD remote fob will
show icon on the screen. If motorcycle is slightly
moved, the alarm will chirp and the indicator will flash lights 5 times, LCD
remote fob hammer icon will flash and vibrate. If it’s moved hard after 10
seconds then full reaction will occur and sound for 30 seconds. Engine will
be completely immobilised and can not be driven away.
Press the button twice, the lights will flash once LCD
remote fob will bleep with icon appear on LCD screen
and the system will be armed.
To disarm the alarm system, press the button,
indicators flash twice with two audible bleeps. LCD
remote will bleep twice and icon will appear on the
screen to confirm.
Note: In silent arm status, the siren will not bleep.
NORMAL ARMING MODE
SILENT ARMING/DISARMING
DISARMING THE ALARM SYSTEM
5
When the Motorcycle is parked and owner left the Motorcycle after 8
seconds, system will sound siren 3 times and flash indicator lights 3 times,
LCD remote will bleep , lock icon will flash and vibrate to remind owner to
arm the security system.
During arm mode, if button pressed and engine not started within 25
seconds system will re-arm automatically and LCD remote fob will sound
“Du” and vibrate (silent arm mode, siren will not sound).
Enable Emergency Key Reset:
If the remote control is lost the owner can disarm with the key. Please refer to
steps below:
Turn the ignition from OFF to ON 10 times repeatedly, leaving last sequence
to Ignition ON at least 2 seconds. System will disarm automatically.
To Exit Emergency Key Reset:
Press the button on LCD remote fob to exit emergency disarm mode. Also
code learning mode will exit emergency key reset mode.
During 1st stage shock sensor triggered during alarm
mode, the siren sound 5 times and indicator lights will
flash 5 times. Engine will be immobilise immediately.
LCD remote fob will bleep 5 times. Remote fob will
vibrate with flashing of Icons (shock and headlight icon).
This will be done only once.
ARMING REMINDER
AUTO- REARM
EMERGENCY KEY RESET:
TILT / SHOCK SENSOR WARNING
6
During 2nd stage (full alarm mode) if alarm is triggered within 10 seconds after
1st stage. Then system will go into full alarm mode. Siren will activate for 30
seconds and indicator lights flash for 30 seconds and engine will be immobilise.
LCD remote fob will bleep for 30 seconds. Remote fob will vibrate 8 times.
Flashing of Icons (shock and headlight icon) will appear on LCD screen.
After 30 seconds system will automatically re arm.
In silent arming mode, siren will not sound.
Press button once with the ignition in OFF position and the indicator lights
will flash for 10 seconds and siren will bleep for 10 seconds. Press button
to exit bike finder mode.
Press and hold button, indicator lights will flash continuously without
bleeping siren. Press any button to exit bike finder mode.
BIKE FINDER/PANIC
SILENT BIKE FINDER/PANIC
7
Read Warning! Safety First
Press the button twice within three seconds, Remote
engine icon will appear on LCD remote fob, LCD remote
fob will bleep for 3 times, engine will startautomatically,
and used for non-key driving and warm-up. Repeat the above operation if
the engine does not function due to cold weather or due to slow rotation of
engine. Engine will stay on 10 minutes.
How to turn off the remote start function: press the button once
then engine will stop.
Warning! Safety first
When properly installed, this system can start the bike via a command signal
from the remote control transmitter.
Therefore, never operate the system in anenclosed areaor partially enclosed
areawithout ventilation (such as a garage). It is the user’s sole responsibility to
properly handle and keep out of reach from children all remote control
transmittersto assure that the system does not unintentionallyremote start the
bike.THE USERMUSTINSTALLACARBONMONOXIDE
DETECTOR IN OR ABOUT THE LIVING AREA ADJACENT TO
THE VEHICLE. ALL DOORS LEADING FROM ADJACENT LIVING
AREAS TO THE ENCLOSEDORPARTIALLYENCLOSEDVEHICLE
STORAGEAREA MUST ATALL TIMES REMAIN CLOSED. These
precautions are the sole responsibilityofthe user.
Use ofthis product in a manner contrarytoits intended mode of operation may
result in property damage, personal injury, or death. (1) Never remotely start
the bike with the bike in gear, and (2) Never remotely start the bike with the
keys in the ignition.
REMOTE START
8
The user must also havethe neutralSafety featureofthebike periodically checked,
whereinthe bike must not remotelystart while the bike is in gear. If the bike starts
in gear, cease remote start operation immediatelyand consult with the authorized
dealer to fix the problem.
OPERATION OF THE REMOTE START MODULE IF THE VEHICLE
STARTS IN GEAR IS CONTRARY TO ITS INTENDED MODE OF
OPERATION. OPERATING THE REMOTE START SYSTEM UNDER
THESE CONDITIONS MAY RESULT IN PROPERTY DAMAGE OR
PERSONAL INJURY. YOU MUST IMMEDIATELY CEASE THE USE OF
THE UNIT AND SEEK THE ASSISTANCE OF AN AUTHORIZED DEALER
TO REPAIR OR DISCONNECT THE INSTALLED REMOTE START
MODULE. HAWK CAR ALARM WILL NOT BE HELD RESPONSIBLE OR
PAY FOR INSTALLATION OR REINSTALLATION COSTS.
When system in armed mode if system detects the ignition is forcibly switched
on (hotwired) siren will activate and indicator lights will flash, the engine is
automatically immobilised and motorcycle cannot be started up. Siren and
indicator lights will flash for 30 seconds. On LCD remote fob will bleep for 30
seconds and “Exhaust pipe and headlight Icons will appear on LCD screen.
LCD remote fob will vibrate 8 times and system will rearm again.
Press and hold the button for 2 seconds at the same time when ignition is
on engine will immobilise within 20 seconds, siren will sound continuously
and indicator lights will flash continuously. Press the button to de-
activate anti hijack mode.
When the siren has been triggered, siren can be turned off without switching
off the alarm. Press button once during siren sounding duration.
SIREN SILENCING DURING ARM
ANTI HOTWIRE
ANTI HIJACK
9
Remove dust cover from side of alarm main control box. Adjust shock sensor
sensitivity with screw driver according to user need.
In arm mode LED will flash twice within interval of 2 seconds. This will
indicate alarm is on arm mode.
If system triggered by shock sensor LED will flash continuously for 30
seconds then the LED will flash 4 times within interval of 4 seconds until the
system is disarmed.
If the system is triggered by ignition on (anti-hotwire), the LED will flash
continuously until system is disarmed and Ignition turned on.
During the alert state, if the alarm is detached from the cable harness, when
restored it will “remember” the state in which was, preventing in this way
every attempt of tampering.
The included transmitters are pre programmed into the systems memory at
the factory. Follow the below steps to add or delete a new transmitter.
1. In disarming mode, Ignition OFF position. Open the main control box.
Press and hold the Micro switch. Press any button of 1st LCD remote fob.
LED will flash twice and siren will bleep twice. The first remote fob will
respond with Musical note indicating code learned successfully.
2. Within 8 seconds press any button of 2nd LCD remote fob, LED will flash
four times and siren will bleep four times. The second remote fob will
respond with Musical note indicating code learned successfully.
3. To exit code learning mode, release Micro switch and close the control
box.
ADJUSTING SHOCK SENSOR
LED FUNCTION / ALARM MEMORY:
MEMORY FUNCTION
LEARNING TRANSMITTER CODES: (We have already done this for you!!!)
10
Warning: After entering into code-learning mode, the previous
remote codes will not be cleared. To clear the previous remote codes (In
case remotes were lost), learn a new remote for at least 4 times, it will
automatically replace all other remotes.
In arm mode if no radio signal bar shown on LCD remote fob then alarm is
out of range of main control box. If on the other hand radio signal bar shown
on LCD remote fob then remote fob is communicating with main alarm unit.
Note: Radio range based on line of sight, unobstructed testing in ideal
conditions. Actual range will vary due to local conditions including but not
limited to environment, terrain, physical obstructions, vehicle location and
orientation interference and other possible impediments.
If battery power is low, remote fob will make “Di..Di..” sound when pressing
any key. This will remind user to change battery. If battery icon start to blink
then battery should be changed immediately, otherwise remote fob will not
function.
Press and button together for 1 second to enter time/alarm adjustment
mode.
Press the button to shift and set among the following icon: time/
min➔time/h➔alarm on/off➔alarm/min➔alarm/h➔quit. The icon will flash
when selected.
Press the button to set each function, press the button to enter next
function setting. When Quit icon flash, press the button and button for
1 second to save and quit. Press the only to quite without saving.
LCD REMOTE FOB RADIO SIGNAL STRENGTH INDICATOR
LCD REMOTE FOB BATTERY STATUS INDICATOR
LCD REMOTE FOB TIME / ALARM SETTING
11
Technical Data Working frequency : 433.92 MHZ
Modulated way: FSK
Alarm unit: Working voltage : 12V±3V
Static current: <=3.5 mA
Siren volume: 110~125Db
Operation Temperature: -40c ~ +85c
Consumer Warranty
Commercial Electronics Co Ltd (“HAWK®”) promises to the original purchaser to repair or replace
with a comparable reconditioned model any HAWK unit (hereafter the “unit”), excluding without
limitation the siren, the remote transmitters, the associated sensors and accessories, which proves
to be defective in workmanship or material under reasonable use during one year from date of
purchase. provided the following conditions are met: the unit was professionally installed and
serviced byan authorized HAWK dealer; the unit will be professionally reinstalled in the vehicle in
which it was originally installed byan authorized HAWK dealer; and the unit is returned to HAWK,
shipping prepaid with a legible copy of the bill of sale or other dated proof of purchase bearing the
following information: consumer’s name, telephone number and address; the authorized dealers
name, telephone number and address; complete product description, including accessories; the year,
make and model of the vehicle; vehicle license number and vehicle identification number. All
components other than the unit, including without limitation the siren, the remote transmitters and
the associated sensors and accessories, carry a one-year warranty from the date of purchase of the
same. This warranty is non-transferable altered, the unit has been modified or used in a manner
contrary to its intended purpose; the unit has been damaged by accident, unreasonable use, neglect,
improper service, installation or other causes not arising out of defects in materials or construction.
The warranty does not cover damage to the unit caused by installation or removal of the unit.
HAWK, in its sole discretion, will determine what constitutes excessive damage and may refuse the
return of any unit with excessive damage. TO THE MAXIMUM EXTENT ALLOWED BY LAW,
ALLWARRANTIES, INCLUDING BUT NOT LIMITED TO EXPRESSWARRANTY, IMPLIED
WARRANTY,WARRANTYOFMERCHANTABILITY,FITNESSFORPARTICULAR PURPOSE
AND WARRANTY OF NON-INFRINGEMENT OF INTELLECTUAL PROPERTY, ARE
EXPRESSLY EXCLUDED; AND HAWK NEITHER ASSUMES NOR AUTHORIZES ANY
PERSON OR ENTITY TO ASSUME FOR IT ANY DUTY, OBLIGATION OR LIABILITY IN
CONNECTION WITH ITS PRODUCTS. HAWK DISCLAIMS AND HAS ABSOLUTELY NO
LIABILITY FOR ANYAND ALL ACTS OF THIRD PARTIES INCLUDING ITS AUTHORIZED
DEALERS OR INSTALLERS. HAWK SECURITY SYSTEMS, INCLUDING THIS UNIT, ARE
DETERRENTS AGAINST POSSIBLE THEFT. HAWK IS NOT OFFERING A GUARANTEE
OR INSURANCE AGAINST VANDALISM, DAMAGE OR THEFT OF THE AUTOMOBILE,
ITS PARTS OR CONTENTS; AND HEREBY EXPRESSLY DISCLAIMS ANY LIABILITY
WHATSOEVER, INCLUDING WITHOUT LIMITATION, LIABILITY FOR THEFT,DAMAGE
AND/OR VANDALISM. THIS WARRANTY DOES NOT COVER LABOUR COSTS FOR
MAINTENANCE, REMOVAL OR REINSTALLATION OF THE UNIT OR ANY
CONSEQUENTIALDAMAGES OFANYKIND. IN THE EVENTOFACLAIM ORADISPUTE
INVOLVING HAWKOR ITS SUBSIDIARY, THE PROPER VENUE SHALL BE ENGLAND &
WALES . THE MAXIMUM RECOVERY UNDER ANY CLAIM AGAINST HAWK SHALL BE
STRICTLY LIMITED TO THE AUTHORIZED HAWKDEALER’S PURCHASE PRICE OF THE
UNIT. HAWK SHALL NOT BE RESPONSIBLE FOR ANY DAMAGES WHATSOEVER,
INCLUDING BUT NOT LIMITED TO, ANY CONSEQUENTIAL DAMAGES, INCIDENTAL
DAMAGES, DAMAGES FOR THE LOSS OF TIME, LOSS OF EARNINGS, COMMERCIAL
LOSS, LOSS OF ECONOMIC OPPORTUNITYAND THE LIKE. NOT WITH STANDING THE
ABOVE, THE MANUFACTURER DOES OFFER A LIMITED ONE YEAR WARRANTY TO
REPLACE OR REPAIR THE CONTROL MODULE AS DESCRIBEDABOVE.
Manufactured By Commercial Electronics Co. Ltd • Great Britain • © Commercial Electronics 2021
This manual suits for next models
1
Table of contents
Other Hawk Car Alarm manuals
