Hayward OmniLogic User manual

Qu i c k Re fe re n ce G u id e
Wired Network Setup
MSP
Ethernet Cable to
Router LAN Port
Computers,
and other devices Internet
Connection
Home Router
1. Connect MSP to Home Router
2. Congure wired connection by selecting:
Cong>Wired Networking>
Note: Network status (top left)
should be in “ON”position
For dynamic (DHCP):
Note: Network status (top left)
should be in “ON”position
For static (Fixed IP):
conrm and save with check mark
select “dynamic” on text bar
select “static” on text bar
enter IP for each eld
conrm and save with check mark

LAN (PoE)LAN
WLAN
LAN
PWR
Qu i c k Re fe re n ce G u id e
-
Wi-Fi Bridge Setup
HLWLAN Network Setup
MSP
HLWLAN
1. Connect HLWLAN hardware to OmniLogic
2. Congure Wi-Fi bridge by selecting Cong>wi bridge>
Note: DO NOT reverse Ethernet assembly
Incorrect setup may cause hardware failure
3’ Ethernet Cable
15’ Ethernet Cable
HLW LAN Power to MPP
Note: May take several minutes to
connect once credentials are
accepted
A. Select the desired network name
(SSID) from the list that appears,
then enter the network password
Note: Passwords ARE case
sensitive and may be supplied by
the router
B. Verify IP addresses are present after
connecting to Wi-Fi, If no IPs, check
information and repeat Step A
To take a closer look or see other Hayward products please go to:
www.hayward.com or call 1-844-365-6442
If no IP address is issued:
Verify network encryption through router
Check connection and signal strength using another Wi-Fi ready device
To view OmniLogic tutorials please visit: www.hayward.com/omnivideos
QRG-OLNETSf