manuals.online logo
Brands
  1. Home
  2. •
  3. Brands
  4. •
  5. Hearth and Home Technologies
  6. •
  7. Fan
  8. •
  9. Hearth and Home Technologies GFK21B User manual

Hearth and Home Technologies GFK21B User manual

Hearth & Home Technologies • GFK21B Fan Kit • 4016-096 Rev I • 11/08 1
TM
TM
Models:
GFK21B
Fan Kit
Installation
Instructions
Note: An arrow (¨) found in the text signifies change in
content.
Sharp Edges
• Wear protective gloves and safety
glasses during installation.
CAUTION
Note: This appliance must be electrically wired and grounded
in accordance with local codes or, in the absence of local
codes, with National Electric Code ANSI/NFPA 70-latest
edition or the Canadian Electric Code CSA C22.1.
Shock Risk
Explosion Risk
Do NOT wire 110-120 VAC to gas control
valve.
Do NOT wire 110120 VAC to wall switch
• Incorrect wiring will damage millivolt
values.
• Incorrect wiring will override IPI safety
lockout and may cause explosion.
WARNING
If you need clarification of any of the instructions contained here contact your dealer or the Technical Services Department
at 1-800-927-6841.
The Fan Kit has been designed to circulate room air through the appliance to enhance heat output. The fan kit operates on
120VAC, 60 Hz power. This is available through a receptacle in the factory installed junction box. The junction box is located
in the controls compartment of the appliance.
A control module is provided with the fan kit which automatically turns the fan on and off at preset times and is equipped
with a variable speed control to provide a quiet forced air flow at the desired speeds.
Check Contents of Shipping Carton
Compare contents of carton in Table 1 with the actual parts received. If any parts are missing or damaged, contact your
dealer before starting installation. Do not install a damaged fan kit.
Installation Precautions
The Fan Kit is tested and safe when installed in accordance with this installation manual. It is your responsibility to read
all instructions before starting installation and to follow these instructions carefully during installation to assure maximum
benefit from, and safe operation of the fan.
Table 1 Contents of Carton
Fan 1
Screws 6
Foam Tape 2
Control Module 1
Electrical Cord 1
Magnetic Tape 2
Fan Bracket 1
Jumper Wire (blue) 1
Shock Risk
Fire Risk
Use ONLY optional accessories approved
for this appliance.
• Using non-listed accessories voids
warranty.
• Using non-listed accessories may result
in a safety hazard.
• Only Hearth & Home Technologies
approved accessories may be used
safely.
WARNING
Note: You may not need all parts included with this kit.
¨
Hearth & Home Technologies • GFK21B Fan Kit • 4016-096 Rev I • 11/08
2
•If the fan is being installed in a B-vent appliance, the fan
shield supplied with the appliance will also need to be
attached. See Figure 3.
1. Install the Fan Bracket & Shield
•Place the fan bracket around the fan. See Figure 1.
•Use pliers to crimp the bracket tabs around the fan
housing. See Figure 2.
•If no fan shield is needed, install screws to hold the front
of the fan bracket in place. See Figure 4.
Figure 2 Crimp Bracket Tabs
Figure 3 Fan Shield
Figure 6 Magnets
Figure 1 Fan Bracket-No screws Figure 4 Fan Bracket
Figure 5 Foam Tape
•Attach the foam tape (Figure 5) and magnets (Figure 6)
to the fan. Cut one magnet strip in half and save the
remaining strip for control module.
Hearth & Home Technologies • GFK21B Fan Kit • 4016-096 Rev I • 11/08 3
•Robertshaw Valve (Standing Pilot)
- Connect the black, white and red wires with 1/4 in.
female connectors from the fan control module to the
appliance junction box as shown in Figure 9.
- Connect the black ground wire with the ring terminal
to the TP screw on the valve (center).
- Remove wall switch wire connected to valve terminal
marked “TH”.
- Connect the black with white stripe wire with 3/16 in.
piggyback connector from fan control module to valve
terminal marked “TH”.
- Connect wall switch wire removed from valve terminal
“TH” to the piggyback connector on the black with white
stripe fan control module wire.
3. Install the Fan
Position the fan all the way to the rear and center in the ap-
pliance. Press the fan (magnets to the bottom) to the back of
the appliance. See Figure 7. Plug the fan cord into the fan
receptacle labeled “FAN” on the junction box. See Figure 8.
BOTTOM PAN
APPLIANCE
BACK
FAN
FIREBOX
BOTTOM
Figure 7 Rotate Fan
Junction Box
Fan Assembly
Cord
Clips
Figure 8 Position the Fan
4. Install the Control Module
Attach the control module to the bottom pan using the mag-
netic tape provided.
2. Remove Valve Assembly
On a Novus 30 in. appliance (GNDC30 or GNBC30 only) the
valve assembly must be raised slightly to allow the fan to be
moved past it to the back of the appliance.
5. Wiring the Fan Control Module
Wall
Switch
RS
Valve
TP TH
TH
TP
Fan
Control
Module
Black/White
Black Ground
Black
Red
White
Thermopile
Red
White
Figure 9 Robertshaw Wiring Diagram
Note: Fan control timer only for use on units with junction
box pictured in Figure 9.
Note: Thermopile must be wired as shown in Figure 9.
Hearth & Home Technologies • GFK21B Fan Kit • 4016-096 Rev I • 11/08
4
• Dexen Valve (IPI)
- Connect the black, white and red wires with 1/4 in. female connectors from fan control module to appliance junction
box as shown in Figure 10.
- Connect the black ground wire to the appliance.
- Remove the green ignition control wire from the valve.
- Connect the black with white stripe wire with 3/16 in. piggyback connector from fan control module to valve.
- Connect green ignition control wire to piggyback connector on black with white stripe fan control module wire.
Dexen
Valve
Fan
Control
Module
Green Wire from Ignition Control
Black
Black/White
Black
Red
White
Ground
Figure 10 - Dexen (IPI) Wiring Diagram
6. Recommended Fan Control Set-up Procedure
Note: The test sequence works only during the first (approximately) seven minutes after power-up.
• With burner and pilot extinguished:
• Turn control knob clockwise to activate control.
• Press and hold test button on the control module.
- Fan will turn on.
- Adjust fan speed with control knob.
- Release test button. Fan will stop.
• Light burner.
• Press and release test button.
- Fan will come on at set speed
- After one minute fan will stop.
• Extinguish burner.
• Fan control is now fully operational and will operate
automatically each time appliance is used.
• Operates with APPROXIMATELY a 7-minute delay to turn
on and a 12-minute delay to turn off.
• SIT Valve
- Connect the black, white and red wires with 1/4 in. female connectors from fan control module to appliance junction
box as shown in Figure 11.
- Connect the black ground wire with the ring terminal to the TP screw on the valve (center).
- Connect blue jumper wire between fan control wire (black with white stripe) and valve. Plug 1/4 in. female end of blue
jumper wire to the back side of valve wiring block marked TH.
Wall
Switch
SIT
Valve
TP TH
TH
TP
Fan
Control
Module
Black/White
Black
Black
Red
White
Thermopile
Red
White
Blue
Ground
Figure 11 - SIT Wiring Diagram

Other Hearth and Home Technologies Fan manuals

Hearth and Home Technologies 19263A User manual

Hearth and Home Technologies

Hearth and Home Technologies 19263A User manual

Hearth and Home Technologies AK-225 User manual

Hearth and Home Technologies

Hearth and Home Technologies AK-225 User manual

Hearth and Home Technologies GFK4B User manual

Hearth and Home Technologies

Hearth and Home Technologies GFK4B User manual

Popular Fan manuals by other brands

Breeze DVS Series user manual

Breeze

Breeze DVS Series user manual

Craftmade Pro Plus P101 installation guide

Craftmade

Craftmade Pro Plus P101 installation guide

Philips Respironics E30 user manual

Philips

Philips Respironics E30 user manual

PAX Norte manual

PAX

PAX Norte manual

Home Decorators Collection PADGETTE Use and care guide

Home Decorators Collection

Home Decorators Collection PADGETTE Use and care guide

Ruck Ventilatoren MPC D 30 Series Assembly instruction

Ruck Ventilatoren

Ruck Ventilatoren MPC D 30 Series Assembly instruction

AERMEC VES instruction manual

AERMEC

AERMEC VES instruction manual

EUROLAMP FGD-16 instructions

EUROLAMP

EUROLAMP FGD-16 instructions

Harbor Breeze BRISTLE AR13-44BLK AR13-44BN installation manual

Harbor Breeze

Harbor Breeze BRISTLE AR13-44BLK AR13-44BN installation manual

commercial cool CCFWR16W user manual

commercial cool

commercial cool CCFWR16W user manual

ENERMAX ETS-T50 user manual

ENERMAX

ENERMAX ETS-T50 user manual

Hunter 41931-01 Installation and operation manual

Hunter

Hunter 41931-01 Installation and operation manual

Greenheck XG-5700 Installation, operation and maintenance manual

Greenheck

Greenheck XG-5700 Installation, operation and maintenance manual

Ventair VWF150AS Installation and wiring instructions

Ventair

Ventair VWF150AS Installation and wiring instructions

Scarlett comfort SC-SF111B18 instruction manual

Scarlett

Scarlett comfort SC-SF111B18 instruction manual

emerio FN-120955 instruction manual

emerio

emerio FN-120955 instruction manual

Maxwell MW-3503 user manual

Maxwell

Maxwell MW-3503 user manual

Sulion WINDSOR manual

Sulion

Sulion WINDSOR manual

manuals.online logo
manuals.online logoBrands
  • About & Mission
  • Contact us
  • Privacy Policy
  • Terms and Conditions

Copyright 2025 Manuals.Online. All Rights Reserved.