Ventair VWF150AS Assembly instructions

150mm wall mounted exhaust
fan with auto shutters
Installation and Wiring Instructions
Model: - VWF150AS
Please read instructions in conjunction with illustrations
Please save these instructions

READ INSTRUCTIONS IN CONJUNCTION WITH THE ILLUSTRATIONS
IMPORTANT
1. All fans must be fitted in accordance with AS/NZS3000 (known
as SAA wiring rules). This unit should be installed by a licensed
electrical contractor or similarly qualified person.
2. The fan should be sited away from direct sources of heat.
3. If the fan is installed in a room containing a fuel burning
appliance, the installer must ensure that the air replacement is
adequate for both the fan and the fuel burning appliance.
4. All regulations and requirements must be strictly followed to
prevent hazards to life and property both during and after
installation, and during any subsequent servicing and
maintenance.
5. This unit must only be fitted and adjusted by suitably qualified
personnel.
6. This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities,
or lack of knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person
responsible for their safety.
7. Children should be supervised to ensure that they do not play
with the appliance.

DESCRIPTION
The VWF150AS fan is suitable for bathrooms, kitchens and laundry’s where a higher rate
of extraction is required. These are available as wall mounted only (wall kit, not
provided).
FAN LOCATION
A short circuit of the airflow should always be avoided, (Fig.1.) by siting the fan as far
away as possible from, and opposite to the main source of, air replacement in the room.
FITTING INSTRUCTIONS
WALL MODEL
1. Cut a 155mm-160mm diameter hole through the wall and insert a suitable wall
sleeve. Slope the sleeve slightly downwards away from the fan. Cut to length and
cement or secure both ends into position flush with the wall faces.
2. Loosen the screw in the bottom of the grille and remove the front grille. Mark the
screw centres through the holes in the fan back plate. Drill, plug and screw into
position. Fix exterior grille into position with the louvres positioned downwards
Note: - The grille must comply with the standard requirements of your country to
prevent access to the fan’s impeller.
3. After installation, ensure impeller rotates freely and the shutters can open.
WIRING INSTRUCTIONS
WARNING: ENSURE THAT THE MAINS SUPPLY IS SWITCHED OFF BEFORE MAKING
ELECTRICAL CONNECTIONS.
The extraction fan is suitable for connection to 220-240V 50Hz supply. It is a class ll
double insulated product and MUST NOT be earthed.
Cable entry to the fan should be done through the cable grommet provided, this can be
moved for either recessed wiring through the back of the fan or surface wiring.

Electrical connections depend upon the type of fan being installed and the required
mode of operation. After wiring is complete replace the grille, turn on mains supply and
check operation.
A. VWF150AS
Single speed fan. Controlled by remote switch (e.g., light switch or Auto sensor) Fig.2.
For safe use and maintenance of this Fan, wiring must be carried out in
accordance with the current AS/NZS3000 and local supply regulations.
Shutter Operation
The shutters will open approximately one minute after the fan is turned on. The shutters
will close about a minute after the fan is switched off.
This product should not be disposed of with household waste. Please recycle
where facilities exist. Check with your local authority for recycling advice.
VENTAIR PTY.LTD 4 Capital Place Carrum Downs VIC 3201 -Made in the UK
411519A 1222
Fig.2