Heatlie Barbecues 700 BBQ User manual

BBQs Without Legs
(To be placed in a recess or bench)
60 Kinkaid Ave NORTH PLYMPTON SA 5037 PH: 08 0376 9330
Email: [email protected] Website: www.heatlie.com.au ABN:55111671008
!
!
Barbecues without legs can be located in a recess or on a bench.
If Warming Drawer is being used, please refer to ‘Assembly of Heatlie Accessories’ in the Heatlie BBQ User
Manual before commencing.
Measurements
Removing BBQ enables you fit the BBQ
into a smaller recess. If you do want to
leave the handle on the bbq you will
need to add 110mm to the length of
the BBQ.
Add 70mm to the height of the BBQ if
including a warming drawer. You will also
need to purchase a set of “Built In legs” if
you are wanting to use a warming drawer
on a BBQ without legs.
Make sure the rear flue is not blocked
when building the BBQ in.
Allow 25mm clearance on all sides of the
BBQ hotplate from non-combustible
surfaces.
If using a combustible material it can be
constructed using a non-combustible
lining, but ensure the backing of the lining
is also non-combustible.
Allow 200mm clearance on all sides of
the BBQ hotplate from any combustible
surface. See following page.
250mm
960mm
595mm
250mm
mmm
810mm
mmm
595mm
m
1265mm
250mm
m
595mm
m
850 BBQ without Left-hand Handle!
1150 BBQ without Left-hand Handle
700 BBQ without Left-hand Handle!
Standard Height: 250mm
Height with Warming Drawer: 315mm

BBQs Without Legs
(To be placed in a recess or bench)
60 Kinkaid Ave NORTH PLYMPTON SA 5037 PH: 08 0376 9330
Email: [email protected] Website: www.heatlie.com.au ABN:55111671008
!
!
Installation
Any vertical surface of a combustible nature (i.e rear / side wall or enclosure panel) of a recess
installation or any adjacent bench wall be not less than 200mm to the edge of the cooking plate. Any
horizontal bench surface be shall level with or below the position of the cooking plate at the completion
of the installation. Refer to Installation Diagram, below, for detail.
Attached to your BBQ without legs are security feet. The security feet can be located in any position
before fixing by inserting a 10mm allen key, undoing the screw and rotate. These feet are to be attached
to your bench or recess with a dyna bolt or other permanent fixing. If the BBQ is configured for LPG, the
gas cylinder is to be located adjacent to the barbecue, in a position where the gas cylinder will not
overheat, where it is protected and securely located but also does not strain the gas hose. Ensure that
the hose is disconnected when moving the BBQ so as not to impart undue stress on the hose. !
Note: Our product is certified to the appropriate standard for installation without legs in a recessed location at
the minimum clearances as detailed in our installation instructions. For installation in an alternate location and
outside the scope of our installation instructions, ie trailer mounted appliance - refer to your local technical
regulator for guidance and approval.
!