CLEANING BEFORE USE：
After you remove all of the packaging materials, （especially the foam between outside
condenser and cabinet should be removed）clean the inside of your refrigerator-freezer
before using it.
SPACE REQUIREMENTS
WARNING: Keep flammable materials and vapors, such as gasoline, away form
refrigerator-freezer.Failure to do so can result in death, explosion, fine or burns.
To ensure proper ventilation for your refrigerator-freezer, allow for 200mm space on
each side between walls, 200mm space between back of your refrigerator-freezer and
the wall, and 300mm space between counter top and the roof or ceiling.
If you are installing your refrigerator-freezer next to a fixed wall, leave sufficient space
on the hinge side to allow for the door to swing open.
Never install your refrigerator-freezer near heat source and direct sun shins.
ELECTRICAL REQUIREMENT
WARNING: DO NOT REMOVE GROUND PRONG.
DO NOT USE AN ADAPTOR.
DO NOT USE EXTENSION CORD.
Failure to follow these instructions can result in death, fire or electrical shock.
Before you move your refrigerator-freezer into its final location, it is important to make
sure you have the proper electrical connection.
NOTE: Before performing any type of installation, disconnect the refrigerator-freezer
from the electrical source. When you are finished, connect the refrigerator-freezer to
the electrical source and reset the control to the desired setting.
LEVELING
If the refrigerator-freezer is not leveled during installation. The doors may not close or
seal properly, causing cooling, frost, or moisture problems. It is very important of the
refrigerator-freezer to be level in order to function properly.
To level your refrigerator-freezer you may either turn the adjustable foot clockwise to
raise that side to the refrigerator-freezer or turn counter –clockwise to lower that side.
NOTE: Having someone push against the top of the refrigerator-freezer, take some
weight off. This makes it easier to adjust the adjustable foot.
