HelpEmUp Anti-Rotation Device User manual

Help them by helping them up .
Quick Start Guide for the Anti-Rotation Device
For Tripods - our three legged friends
The lifting &mobility harness recommended by most Vets &Therapists .
Specs:
Parts:
1 Anti-Rotation Strap
2 Connector Clips
Sizes:
Extra Large
Large
Medium
Small
THE HELPEM
UP HARNESS
`
TM
The Anti-Rotation Device for Tripods prevents rotation and assists in securing the harness on your dog –
regardless of whether it’s a front or rear amputation. It provides a quick and convenient way to keep the harness
from rotating and hold it properly in place even when they are a missing limb.
It’s comprised of an Anti-Rotation Strap that runs under the length of your dog along with 2 Connector Clips that attach
to the strap and then onto either the front “O” Ring or a shoulder “D” ring on the harness and then to the “D” ring on the Hip
Lift portion of the harness. This strap and clips combine to resist rotation. Remember Help them by helping them up!
XLarge / Large / Medium / Small Choose the one that corresponds to the size of your harness.
Anti-Rotation Strap
2 Connector-Clips: Clips are metal on the XLarge version
The Anti-Rotation Straps & Clips - 4 Sizes Corresponds to the size of your harness.
Princess Grace, 7

Now attach the Connector clips to each end of the strap. Clip the top
clip to either the Soft “O” Ring or up to Shoulder “D” ring.
See #3 to connect to the shoulder “D” ring.
The device is an Anti-Rotation Strap and Two Connector Clips. First pass the strap through the two elastic bands on the “T” Pad [under the
chest]. Now attach the connector clips to either end of the strap. These clips allow you to connect the strap to either the chest “O” Ring or
Shoulder “D” ring and finally, to the “D” ring on Hip Lift. Note: You can leave it connected even when you remove the harness.
Connect the strap to the Shoulder “D” ring. Make sure this strap
is attached to the opposite side of the missing limb.
Finally attach the Rear Connector Clip to the hip lift “D” ring. Now
make adjustments to the strap length. Make it snug but not too
tight. A small amount of drag keeps the harness from spinning.
First pass the Anti-Rotation Strap through one or both of the two
elastic bands. #1 [shown above] on the bottom of the T-Pad and #2
at the top of the chest pad strap [shown in frame #2].
1 2
3 4
The Anti-Rotation strap connects to the Hip Lift
at the opposite side of the front amputation.
[as shown here].
For Front Amputees
Also watch our fitting demonstration at www.helpemup.com/videos
Blue Dog Designs 720-237-6852 [e-mail] www.helpemup.com
Anti-Rotation Strap
The Anti-Rotation strap connects
on the same side as the rear
amputation [shown here].
Note: It can be
left connected
whenever you
remove the
harness.
For Rear Amputees
Anti-Rotation Strap
Hip Lift
Connector Clip
Rear Connector Clip
Connect Clip to “O” Ring or Shoulder “D” ring
Soft “O” Ring
Elastic Band #1
Anti-Rotation Strap
Upper shoulder “D” ring
Elastic Band #2 Connect here to “D” ring Pass under Elastic Bands 1#2
Deuce, 9
Connect Clip to Hip lift “D” ring
Hip Lift “D” ring
Shoulder “D” ring