Helping Hand KINGFISHER HA0680 User manual

Bromyard Road, Ledbury
Hereford HR8 1NS
[email protected].uk
www.HHAdlEssentials.co.uk
Fig.2
Fig.3
Adjuster Knob
Fig.4
Fig.1
Adjuster
Knob
Fixing
Bracket
Rubber
Buffer
Fig.5
Fitting Guide
Mark
Fitting Guide
Mark
KINGFISHER BATHBOARD
Part No: HA0680 and HA0686 (with handle)
Max. Safe user weight 200kg (31 stone)
The Kingsher Bathboard is designed to make
getting in and out of the bath easier and safer.
The Bathboard can also be used for showering.
Assembling the xing brackets to the Bathboard:
Four xing brackets t into outer slots on
the underside of the Bathboard (g.1).
Hold the adjuster knob on the bracket and
Fit the head of the angled bolt through
the 'D' shaped hole at the end of the slot
(g.2). ensuring that the bolt ts at onto
the shoulders of the slot, with the rubber
buer facing outwards. Slide the brackets
towards the middle of the board.
Positioning the Board in the bath:
Place the Bathboard on top of the bath with the handle and/or soap
dish on the wall side. Ensure that the area around is clean and ideally
the board should be at the opposite end to the taps (g.3).
Slide the brackets out to the side of the bath. Check the position of the
Bathboard and then tighten up each adjuster knob to lock the brackets
in place (g.4). Take care not to overtighten the adjuster knobs.
Please ensure that the tting guide marks are over the supported
area of the bath tub sides (g.5).
Check that the board is secure before every use.

Bromyard Road, Ledbury
Hereford HR8 1NS
[email protected].uk
www.HHAdlEssentials.co.uk
25mm
Max
Fig.6 Fig.7 Fig.8
USING THE KINGFISHER BATHBOARD
Getting in and out of the bath
Sit on the end of the board
with your hands on either
side (g.6).
Lift each leg one at a time
into the bath (g.7).
Slide across to the middle
of the board (g.8).
To keep clean, please use non-abrasive cleaners suitable for plastic baths, with particular attention to the feet
Do not store in sunlight
Inspect the board for wear and tear and secure tting each time before use
3 year warranty, spare parts are available
Can be autoclaved
Taking care of your Bathboard
ZL1076_7
To reduce the risk of involuntary or accidental movement during use, we recommend
that you check the tting of the bathboard before use, every time.
It is not recommended that the
bathboard be tted where an
overlap of more than 25mm exists.
NOTE: For safety reasons never sit on the edge of the bathboard if it overlaps the bath
Please take care getting in and out of the bath.
The Kingsher Bathboard is from our range of home care equipment to make daily living easier.
Need any further help, please give our team in Herefordshire a call on 01531 635678.