Hendi HND298268 User manual

CONVEYOR TOASTER DOUBLE
HND298268
You should read this user manual carefully before using the appliance.

22
Keep these instructions with the appliance.
For indoor use only.

3
Dear Customer,
Thank you for purchasing this Hendi appliance. Before using the appliance for the first time, please read
this manual carefully, paying particular attention to the safety regulations outlined below.
Safety regulations
• This appliance is intended for commercial use.
• The appliance must only be used for the purpose for which it was intended and designed.
The manufacturer is not liable for any damage caused by incorrect operation and
improper use.
• Keep the appliance and electrical plug away from water and any other liquids. In the
event that the appliance should fall into water, immediately remove plug from the socket
and do not use until the appliance has been checked by a certified technician. Failure to
follow these instructions could cause a risk to lives.
• Never attempt to open the casing of the appliance yourself.
• Do not insert any objects in the casing of the appliance.
• Do not touch the plug with wet or damp hands.
• Danger of electric shock! Do not attempt to repair the appliance yourself. In case of
malfunctions, repairs are to be conducted by qualified personnel only.
• Never use a damaged appliance! Disconnect the appliance from the electrical outlet and
contact the retailer if it is damaged.
• Warning! Do not immerse the electrical parts of the appliance in water or other liquids.
Never hold the appliance under running water.
• Regularly check the power plug and cord for any damage. If the power plug or power cord
is damaged, it must be replaced by a service agent or similarly qualified persons in order
to avoid danger or injury.
• Make sure the cord does not come in contact with sharp or hot objects and keep it away
from open fire. To pull the plug out of the socket, always pull on the plug and not on the
cord.
•
Ensure that the cord (or extension cord) is positioned so that it will not cause a trip hazard.
• Always keep an eye on the appliance when in use.
•
Warning! As long as the plug is in the socket the appliance is connected to the power
source.
• Turn off the appliance before pulling the plug out of the socket.
• Never carry the appliance by the cord.
• Do not use any extra devices that are not supplied along with the appliance.
• Only connect the appliance to an electrical outlet with the voltage and frequency
mentioned on the appliance label.
• Connect the power plug to an easily accessible electrical outlet so that in case of
emergency the appliance can be unplugged immediately. To completely switch off the
appliance pull the power plug out of the electrical outlet.
• Always turn the appliance off before disconnecting the plug.

4
• Never use accessories other than those recommended by the manufacturer. Failure to do
so could pose a safety risk to the user and could damage the appliance. Only use original
parts and accessories.
• This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge.
• This appliance must not be used by children under any circumstances.
• Keep the appliance and its cord out of reach of children.
• Always disconnect the appliance from the mains if it is left unattended or is not in use,
and before assembly, disassembly or cleaning.
• Never leave the appliance unattended during use.
Special safety precautions
• Use the appliance only as described in the manual.
• This appliance must be installed, commissioned and services by a qualified or trained
person. And this appliance is intended to be used by trained or qualified personnel such
as kitchen or bar staff.
• Place the appliance on a clean, stable, dry, level & heat-resistant surface only.
• Caution! Danger of burns! The temperature of the accessible surfaces of the
appliance get hot during use. Touch the temperature control knob or speed
control knob only.
• Warning: Keep all ventilation openings in the appliance clear of obstruction. Provide
ventilation in the structure when building-in.
• Warning: During installation, do not place on surfaces or near walls, partitions or kitchen
furniture and the like – unless they are made of non-combustible material or clad with
non-combustible heat-insulating material, and pay attention to the fire prevention
regulations.
• Keep the appliance away from any hot surfaces and open flames. Protect the appliance
against heat, dust, direct sunlight, moisture, dripping and splashing water.
• Do not use the shelves for storage and processing of acidic, alkaline or salty food.
• Allow at least 15cm surrounding spacing for ventilation purpose during use.
• Do not use water jet or steam cleaner and do not immerse the whole appliance.
• Do not place articles on top of the appliance. Do not place objects with open sources of
fire (e.g. candles) on top or beside the appliance. Do not place objects filled with water
(e.g. vases) on or near the appliance.
• Do not use hard utensils to hit the glass surface. Do not pour out the water towards the
glass surfaces, the glass surfaces may break during operation.
• Never cover the appliance during use. This may cause a fire hazard.
• Allow cool down completely before cleaning and storage.
• Do not wash the appliance with water. Washing can cause leakages and increase the risk
of electric shock.

5
Intended use
• The appliance is intended for professional use.
• This appliance is designed only for toasting of
sliced bread. Any other use may lead to damage
of the appliance or personal injury.
• Operating the appliance for any other purpose
shall be deemed a misuse of the device. The user
shall be solely liable for improper use of the de-
vice.
Grounding installation
This appliance is classified as protection class I
appliance and must be connected to a protective
ground. Grounding reduces the risk of electric
shock by providing an escape wire for the electric
current. This appliance is equipped with a cord
having a grounding wire with a grounding plug. The
plug must be plugged into an outlet that is properly
installed and grounded.
Preparation before using for the first time
• Remove all protective packaging and wrapping.
• In case of incomplete delivery or damages, DO
NOT use the appliance. Please contact supplier
(See ==> Warranty).
• Clean the appliance with luke-warm water and
a soft cloth.
• Place the appliance on a clean, stable, dry, level &
heat-resistant surface only.
• Make sure there is enough space around the ap-
pliance for ventilation purposes.
• Position the appliance in such a way that the plug
is accessible in all times.
• Keep the packaging so you can properly store the
appliance when it is not used for an extended pe-
riod of time.
Installation
Attention: Always unplug the appliance from the electrical power outlet and let it cool down completely before
installation.
(A). Installation of front tray
1 3
2

6
(B). Installation of back tray
1
4
2
5
3
6
Note:
1). Do not use the trays for other purposes. 2).Do not use the trays for storage and processing
of acidic, alkaline or salty food.
Control panel
Speed control Heating control and
ON/OFF Switch
Power indicator
Speed control
You can control the “browning” evenness of the
toasted bread by adjusting the speed of the con-
veyor.
Light brown
Medium brown
Dark brown
Heating control and ON / OFF Switch
0 position – Switch OFF the appliance
– Provide full heating power for both upper and
lower heating element
– Provide low heating power for both upper and
lower heating element.
It is also for energy saver when not in use for
some time. But under standby condition for
fast heating when required.
– Provide full power to the upper heating ele-
ment only. Used for making bagels or buns.

7
Operation
• Make sure the heating control knob is switched
to the 0 position.
• Connect the power plug to a suitable electrical
power outlet.
• Power ON the appliance by turning the Heating
control knob to the desired setting (Full power/
Low power/Upper heating only). The power indi-
cator will be light up in green.
• Place the sliced bread on the conveyor by using a
tong (not supplied) to avoid danger of heat burn.
Ensure the bread is evenly placed.
• Rotate the Speed control knob to adjust the
speed of the conveyor & thus the browning even-
ness of the toasted bread.
• When not in use, set the Heating control knob to
the “0” position.
• Unplug the appliance from the electrical power
outlet.
• Allow the appliance to cool down completely be-
fore cleaning or storage.
Note: Due to manufacturing residues, the appli-
ance may emit a slight odor. This is normal and
does not indicate any defect or hazard. Make sure
the appliance is well ventilated.
Cleaning and Maintenance
Attention: Always unplug the appliance from the electrical power outlet and let it cool down completely before
cleaning and storage.
• Clean the appliance regularly and any food resi-
dues removed.
• CAUTION! Never use any abrasive or hard objects
for cleaning.
• Clean the appliance with luke-warm water and
a soft cloth.
• Do not use water jet or steam cleaner for clean-
ing and do not push under the water.
• No any parts can be cleaned in the dishwasher.
Parts How to clean Remark
All accessories
such as trays, etc.
- Soak in warm, soapy water for about 10 to 20 minutes.
- Rinse under running water thoroughly. Dry all parts well at
last.
External surfaces - Wipe clean with a soft cloth and a little mild detergent.
Make sure no water or moisture enters inside the of the
appliance.
Storage
• Always make sure the appliance has already
been disconnected from the electrical power out-
let and cool down completely.
• Store the appliance in a cool, clean place.

8
Troubleshooting
If the appliance does function properly, please check the below table for the solution. If you are still unable to
solve the problem, please contact the supplier/service provider.
Problems Possible causes Possible solutions
Neither the lamp indicator nor the
heating elements heat up.
The power plug is not connect-
ed firmly with the electrical
power outlet.
Check the connection and
make sure all the connections
are correctly connected.
When connected to the electrical
power supply, heating control is set &
the power indicator lights on. But the
appliance does not heat up.
Thermal cut-out activated
Contact with the supplier/ser-
vice provider for repair.
Heating element is burnt out.
When connected to the electrical
power supply, heating control is set
but the power indicator does not light
up. The appliance can still heat up.
The power indicator is defective Contact with the supplier/ser-
vice provider for repair.
Conveyor chain does not rotate (See
below photo)
Internal motor is defective
Contact with the supplier/ser-
vice provider for repair.
Control unit is defective
Gear or chain not in the correct
position
Chain Gear
Gear or chain do not rotate

9
Technical specification
Item no. : 261309
Operating voltage and frequency : 230V~ 50Hz
Rated input power : 2240W
Protection class : Class I
Outer dimension : 418 x 368 x (H) 387 mm
Product weight : 16kg
Remark: Technical specification is subjected to change without prior notification.
Important notice to UK users
This appliance is fitted with a UK approved mains
plug and a 13A fuse. Should the fuse need to be
replaced, an ASTA or BSI approved BS1362 fuse,
rated at 13A must be used. If the plug needs re-
placing, ensure that the fuse is removed before-
hand. Always dispose of defunct plugs and fuses
immediately.
Warranty
Any defect affecting the functionality of the ap-
pliance which becomes apparent within one year
after purchase will be repaired by free repair or re-
placement provided the appliance has been used
and maintained in accordance with the instructions
and has not been abused or misused in any way.
Your statutory rights are not affected. If the appli-
ance is claimed under warranty, state where and
when it was purchased and include proof of pur-
chase (e.g. receipt).
In line with our policy of continuous product devel-
opment we reserve the right to change the product,
packaging and documentation specifications with-
out notice.
Discarding & Environment
When decommissioning the appliance, the prod-
uct must not be disposed of with other household
waste. Instead, it is your responsibility to dispose to
your waste equipment by handing it over to a des-
ignated collection point. Failure to follow this rule
may be penalized in accordance with applicable
regulations on waste disposal. The separate col-
lection and recycling of your waste equipment at
the time of disposal will help conserve natural re-
sources and ensure that it is recycled in a manner
that protects human health and the environment.
For more information about where you can drop off
your waste for recycling, please contact your local
waste collection company. The manufacturers and
importers do not take responsibility for recycling,
treatment and ecological disposal, either directly
or through a public system.

10

11

Manufacturer: Hendi B.V.
Innovatielaan 6
6745 XW De Klomp, The Netherlands
Tel: [phone]
Email: [email protected]
Importer: Neville UK PLC
Unit 6, Viking Way. Erith, Kent.
DA8 1EW, England
https://www.nevilleuk.com/
Hendi HK Ltd.
1208, 12/F, Exchange Tower
33 Wang Chiu Road, Kowloon Bay, Hong Kong
Tel: [phone]
Email: [email protected]
Find Hendi on internet:
www.hendi.eu
www.facebook.com/HendiToolsforChefs
www.linkedin.com/company/hendi-food-service-equipment-b.v.
www.youtube.com/HendiEquipment
- Changes, printing and typesetting errors reserved.
© 2021 Hendi B.V. De Klomp - The Netherlands Ver: 21-04-2021