Henny Penny FlexFusion Electric SpaceSaver PLUS Technical specifications

Maintenance Instructions
Ventless hood
FM05-229 • 2/14/2017
FM05-229 en-US
REGISTERWARRANTYONLINEATWWW.HENNYPENNY.COM
SPACE$AVER PLUS
FUSION
FLEX
SPACE$AVER
FUSION
FLEX

Henny Penny Corporation
P.O.Box 60
Eaton,OH 45320
USA
Phone [phone]
Fax [phone]
Toll free in USA
Phone [phone]
Fax [phone]
www.hennypenny.com
2 Maintenance instructions

Directory of contents
3Maintenance instructions
1Introduction......................................................................... 5
1.1About this manual ............................................................................ 5
1.1.1Explanation of signs ..................................................................................  6
2Safety instructions ............................................................. 7
3Description of the unit ....................................................... 8
3.1Overview of the unit ......................................................................... 8
4Cleaning and checking ...................................................... 9
4.1Cleaning intervals ............................................................................ 9
4.2Cleaning the condensation area ................................................... 10
4.3Cleaning the grease filter .............................................................. 10
4.4Removing the filter drawer ............................................................ 11
4.5Inserting the filter drawer .............................................................. 12
4.6Cleaning the yellow filter mat........................................................ 12
4.7Checking the activated charcoal filter.......................................... 14
4.8Changing the air filter .................................................................... 14
5Maintenance certificate.................................................... 16
FM05-229

Directory of contents
4 Maintenance instructions
FM05-229

Introduction
5Maintenance instructions
1 Introduction
1.1 About this manual
The maintenance instructions contain information:
•About the safe maintenance of the unit.
Observe the following notes and adhere to them:
•Read the maintenance instructions completely before starting
maintenance.
•Read the Operating instructions before operating the unit.
Target group The target group for the maintenance instructions is trained technical
personnel, who are familiar with maintaining and operating the unit.
Figures All figures in this manual are intended as examples. Discrepancies
can arise between this and the actual unit.
FM05-229

Introduction
6 Maintenance instructions
1.1.1 Explanation of signs
DANGER Imminent danger
Failure to comply will lead to death or very severe injuries.
WARNING Potential danger
Failure to comply can lead to death or very severe injuries.
CAUTION Dangerous situation
Failure to comply can lead do slight to moderately severe injuries.
NOTICE Property damage
Failure to comply can cause property damage.
INFORMATION Information
Notes for better understanding and operation of the unit.
Symbol / sign Meaning
•Listing of information.
Action steps which can be performed in
any sequence.
1.
2.
Action steps which must be performed
in the specified sequence.
Result of an action performed or
additional information relating to it.
FM05-229

Safety instructions
7Maintenance instructions
2 Safety instructions
The unit complies with applicable safety standards. Residual risks
associated with operation or risks resulting from incorrect operation
cannot be ruled out and are mentioned specifically in the safety
instructions and warnings.
The maintenance personnel must observe the safety information in
these maintenance instructions.
The maintenance personnel must also observe the "Safety
information" chapter in the installation instructions.
The maintenance personnel must be familiar with regional regulations
and observe them.
Organizational measures Risk of property damage and personal injury from lack of
organizational measures
•Identify danger zones when transporting, installing and connecting
the unit.
•Inform the operators present prior to starting the mounting work.
•Discuss how to respond to an emergency prior to starting the
mounting work.
•Use equipment and protective gear suitable for the activity.
•Brace housing components to prevent them from falling over and
dropping.
Improper maintenance Risk of physical damage and personal injury from improper
maintenance
•Service the unit only as specified in these maintenance
instructions.
•Use only original spare parts.
FM05-229

Description of the unit
8 Maintenance instructions
3 Description of the unit
3.1 Overview of the unit
a
c
b
d
e
c
g
f
Image: Ventless hood
a Housing e Condensation area
b Drain opening f Air filter
c Filter drawer g Filter mat (yellow)
d Grease filter
FM05-229

Cleaning and checking
9Maintenance instructions
4 Cleaning and checking
DANGER Risk of personal injury and property damage from electric shock
• Before working on the unit, ensure that the unit is dead.
• Do not operate the unit with the housing open.
CAUTION Risk of falling from unstable climbing aids
• Use only approved ladders or step stools as climbing aids.
CAUTION Risk of burns from hot surfaces
Allow the unit to cool down before maintenance.
Only carry out maintenance on a unit that has cooled down.
CAUTION Risk of injury from sharp edges
• Wear protective gloves.
NOTICE Risk of physical damage to activated charcoal filter from incom-
plete filter materials
Operate unit only with fully inserted filter materials.
INFORMATION A slight discoloration of the filter materials does not indicate the degree of soil-
ing or functional capability.
It is not an indication of poor quality.
4.1 Cleaning intervals
The cleaning intervals depend on the manner and intensity of
combisteamer use.
For average use the manufacturer recommends the following cleaning
intervals
•Condensation area under the grease filter – clean once a week
•Grease filter – clean every 4 weeks
•Filter mat (yellow) – clean or replace every 2 months
•Air filter – replace every 12 months
•Activated charcoal filter – visual inspection annually
FM05-229

Cleaning and checking
10 Maintenance instructions
4.2 Cleaning the condensation area
a
b
c
Image: Condensation area
a Filter drawer
b Grease filter
c Condensation area
Prerequisite  Ventless hood and associated unit disconnected from power
 Unit has cooled down
 Stable position of ladder if the ventless hood cannot be reach
without an aid
Clean the condensation area with the provided cleaning brush,
warm water and commercially available detergent.
4.3 Cleaning the grease filter
a
b
Image: Grease filter
a Handles
b Grease filter
CAUTION Risk of injury from sharp edges
• Wear protective gloves.
FM05-229

Cleaning and checking
11Maintenance instructions
INFORMATION The grease filter lies loosely in its holder.
INFORMATION After the grease filter has been removed visual inspection of the yellow filter
mat is possible.
Removal
Prerequisite Unit dead
Unit has cooled down
Stable position of ladder if the ventless hood cannot be reached
without an aid
1. Grasp the grease filter by the handles at the left and right.
2. Push the lower part towards the back.
3. Pull the upper part down at a slight angle.
4. Remove the grease filter
Cleaning
5. Clean the grease filter in a dishwasher.
6. Dry the grease filter.
Installation
7. Place the dry grease filter back in the ventless hood.
8. Check that the filter is properly seated.
The grease filter is now cleaned.
4.4 Removing the filter drawer
Image: Removing the filter drawer
NOTICE Risk of property damage from failure to remove grease filter
Remove grease filter before removing the filter drawer.
FM05-229

Cleaning and checking
12 Maintenance instructions
Prerequisite Disconnect the ventless hood and associated unit from power
Unit has cooled down
Grease filter removed
Stable position of ladder if the ventless hood cannot be reach
without an aid
Area under the ventless hood protected
1. Carefully pull filter drawer forward and remove it by pulling up at
an angle.
2. If you are using a ladder, hand the filter drawer to a second
person.
3. Place the filter drawer securely on a flat surface.
The filter in the filter drawer can now be removed safely.
4.5 Inserting the filter drawer
Prerequisite Disconnect the ventless hood and associated unit from power
Unit has cooled down
Grease filter removed
Stable position of ladder if the ventless hood cannot be reach
without an aid
Area under the ventless hood protected
1. If you are using a ladder, have a second person hand you the filter
drawer.
2. Carefully slide the filter drawer into the holder fully from above at a
slight angle.
3. Insert the grease filter
The ventless hood is ready for operation.
4.6 Cleaning the yellow filter mat
a
b
Image: Filter mat (yellow)
a Filter drawer
b Filter mat (yellow)
FM05-229

Cleaning and checking
13Maintenance instructions
NOTICE Risk of property damage from improper cleaning
Do not use a fabric softener when cleaning the yellow filter mat.
Always wash the yellow filter mat separately.
Reinstall only a fully dried filter mat.
Prerequisite Filter drawer removed
Air filter removed
1. Remove yellow filter mat, incl. holder.
2. Remove yellow filter mat from holder.
Manual washing
3. Allow the yellow filter mat to soak for 5 minutes in a basin of warm
water and commercially available cleaning agent.
4. Knead it thoroughly several times, but do not wring it.
5. Wash it out under clear warm water and press out the water.
6. Repeat both procedures until the water does not show any more
discoloration.
Machine washing
7. Before washing the yellow filter mat spray it thoroughly with a
grease remover and allow it to act.
8. For normal soiling, wash at 30 °C (86°F).
9. For sever soiling, wash at 60 °C (140°F).
10.Spin at max. 800 rpm.
Drying
11.After washing the filter mat, dry it on a smooth horizontal
substrate at ground level.
Installation
12.Place dry yellow filter mat into holder and close holder.
13.Place holder with filter mat into filter drawer.
The yellow filter mat is cleaned.
FM05-229

Cleaning and checking
14 Maintenance instructions
4.7 Checking the activated charcoal filter
a
Image: Activated charcoal filter
a Activated charcoal filter
Prerequisite Unit dead
Unit has cooled down
Stable position of ladder if the ventless hood cannot be reached
without an aid
Grease filter removed
With the aid of a flashlight, check the activated charcoal filter at
the rear of the ventless hood for soiling.
4.8 Changing the air filter
a
b
c
Image: Air filter
a Foam gasket
b Air filter
c Filter drawer
Prerequisite Filter drawer removed
1. Remove the air filter from the filter drawer.
FM05-229

Cleaning and checking
15Maintenance instructions
2. Place new air filter into the filter drawer with the foam gasket
facing up.
The air filter is changed.
FM05-229

Maintenance certificate
16 Maintenance instructions
5 Maintenance certificate
Type of maintenance Date Company, person Signature
Type of maintenance Date Company, person Signature
Type of maintenance Date Company, person Signature
Type of maintenance Date Company, person Signature
Type of maintenance Date Company, person Signature
Type of maintenance Date Company, person Signature
Type of maintenance Date Company, person Signature
Type of maintenance Date Company, person Signature
Type of maintenance Date Company, person Signature
Type of maintenance Date Company, person Signature
Type of maintenance Date Company, person Signature
Type of maintenance Date Company, person Signature
Type of maintenance Date Company, person Signature
Type of maintenance Date Company, person Signature
Type of maintenance Date Company, person Signature
FM05-229

Maintenance certificate
17Maintenance instructions
Type of maintenance Date Company, person Signature
Type of maintenance Date Company, person Signature
Type of maintenance Date Company, person Signature
Type of maintenance Date Company, person Signature
Type of maintenance Date Company, person Signature
Type of maintenance Date Company, person Signature
Type of maintenance Date Company, person Signature
Type of maintenance Date Company, person Signature
Type of maintenance Date Company, person Signature
Type of maintenance Date Company, person Signature
Type of maintenance Date Company, person Signature
Type of maintenance Date Company, person Signature
Type of maintenance Date Company, person Signature
Type of maintenance Date Company, person Signature
Type of maintenance Date Company, person Signature
FM05-229

Maintenance certificate
18 Maintenance instructions
FM05-229

Henny Penny Corporation
P.O.Box 60
Eaton,OH 45320
USA
Phone [phone]
Fax [phone]
Toll free in USA
Phone [phone]
Fax [phone]
www.hennypenny.com
*FM05-229*