hentech RC03B User manual

RC03B Remote Control Manual
RC03B is a single remote control device used to control underwater light within 200m
(actual distance varies by environment)
Important: This manual includes installation and usage information. Please review all
instructions before installing or initiating. For best functionality, please follow
following guideline
Basic Parameter for RC03B:
Degree of Protection：IP63
Size：135mm x 135mmx 45mm
Weight：0.37KG
Input Voltage：220V AC
Output Voltage：Depending on your input voltage
Operating Temperature: - 40ºC ～+70ºC
Operating Humidity: 1 0 % ～90% RH
Control Distance：within 200M
Packaging：RC03B Remote Device ×1 Remote Control × 2
Product Diagram：
Wiring Diagram
OPERATION
Operate with a remote emitter
Button operation:
Button 1: switch to the next color program
Button 2: turns the lamps ON/OFF.
Button 3: turns ON/OFF switch A.
Button 4: turns ON/OFF switch B.
Input 220V
B
A
color&light
2
1
3
4

Adding or Removing Remote Control：
1. Adding New Remote Control：
Press and hold [REMOTE] until light is switched on.
Press any button on remote control, matching is successful if light is switched off
( 21 remote control match at the most).
2. Remove All Remote Control：
Press and hold [REMOTE]，for 10 second until l the light on processing board turns off, then
release button.
SAFETY WARNINGS
The persons who are in charge of installation should have the required qualifications for this type of work.
Avoid making contact with the electric voltage.
Comply with the current standards regarding accident prevention.
IEC 364-7-702 standards must be observed: WIRING IN BUILDINGS, SPECIAL WIRING, SWIMMING
POOLS.
Any maintenance works must be performed with the 220V incoming wire disconnected or switched off at
the main supply.
Do not handle any electrical components with wet feet.
Wire Connected Drawing: