Hercules RMX Use and care manual

Hercules Technical Support http://ts.hercules.com
1
DJ Console RMX – Windows Audio Firmware Update Procedure
1) Make sure that USB errors are reported. In order to be sure of this, open the
Device Manager (click Start/Run and enter the following command: devmgmt.msc
press Enter), then open the USB section, and for each host controller:
- Double click on the host controller icon
- Open the "Advanced" tab
- Make sure that the "Don't tell me about USB errors" checkbox is unchecked
2) Download the latest package from the web: ts.hercules.com
3) Install the package. When asked to connect your DJ Console Rmx, just click on
Next (do NOT plug in the device) until it reaches the end and completes the
installation process
At this point, a message saying that the Drivers are older than expected.. will
appear. This is perfectly normal since no console was connected during the
installation process. Click OK and proceed to Step 4
4) Make sure the Control Panel (=
CPL) is closed.
- Open Windows Task Manager
- In the Process tab, select
HDJSeriesCPL.exe
- Click the End Process button
5) Open the Device Manager if not already open
6) Press and hold the MIC On/Off button on the console

Hercules Technical Support http://ts.hercules.com
2
Plug in the device, while still holding the MIC On/Off button
Hold until the Device Manager sees the device arrival OR there is a "Found New
Hardware" dialog.
If there is a "Found New Hardware" dialog, then proceed with the installation of the
device.
If neither occur, unplug the device and try
again, making sure to press and hold the
Mic On/Off button before plugging in the
device, and maintaining the hold thereafter

Hercules Technical Support http://ts.hercules.com
3
7) Check the status of the bulk device (Hercules DJ Console RMX Bulk) in the
Device Manager.
Whether or not the bulk device (Hercules DJ Console RMX Bulk) is enumerated
correctly, right-click on it and select Uninstall.
Then, click in an empty area of the Device Manager, and from the Action menu,
select Scan for Hardware changes. This will insure the latest driver is used.
8) Launch the manual updater. For that click Start/Run and enter the following
command (including quotes):
"C:\Program Files\Hercules\Audio\DJ Console Series\firmware\HDJSeriesUpdater.exe" –manual
If the updater sees the device, make sure that under Current column (in the DJ
Console Series – Firmware Updater), the Firmware Controller should be boot and
under Flash column, the Firmware Audio is selected.. If not, unplug and re-plug
again following the same procedure as described in Step 6.

Hercules Technical Support http://ts.hercules.com
4
9) Click the Open Audio button, then browse for the RMX TUSB (RMX_TSUB.dja)
firmware and click Open
Then click Update! in the DJ Console – Firmware Updater in order to continue
10) THE CONSOLE MUST NOT BE UNPLUGGED until the manual updater
confirms completion and advises to do so.

Hercules Technical Support http://ts.hercules.com
5
When prompted by the updater, unplug the device
11) Plug in the device in normal mode (without pressing any buttons on the console)
In the Device Manager, uninstall the bulk device (Hercules DJ Console RMX
Bulk), (see Step 7) and reinstall all DJ devices for which there is a "Found New
Hardware" dialog
12) Within the manual updater, confirm that the Firmware audio version is 31. If not,
then start again from the beginning (step 5).
The procedure is complete