Heritor Gemini HR3801 User manual

The Heritor Gemini Timepiece
(HR3801 – HR3806)
Mechanical automatic watches harness the kinetic energy contained within the natural movement o your arm to generate
the orce required to operate. The watch will commence operation a ter a su icient volume o initial power has been
generated by handling / wearing or by manually winding the crown. Supplemental winding through wear or manual winding
will ensure sustained unctionality and increase the duration in which the watch will continue to operate when unworn.
Setting Instructions
1) Pull the crown to its most outward position.
2) Rotate the crown clockwise until the current time is displayed.
3) Push the crown in to its rest / manual winding position.
4) Manually wind the movement by rotating the crown clockwise 10-20 times.
Note: Although manual winding is not necessary, generating an initial power reserve and occasionally
winding the movement manually will increase the duration in which the movement continues to
operate when the watch is not worn.
Water Resistance Guidelines
Note: Manipulation o the crown while in contact with water will negate the rated water resistance as
water penetration may occur.
© Heritor
Rating Submersible Capacity of Resistance
No Marking No Splash/light contact only.
5ATM No Hand/dish washing.
10ATM Yes Low depth and short duration only.
20ATM Yes Short duration diving up to 5 meters.
25ATM+ Yes Average depth and duration diving.

HR3 01 / HR3 02 Resizing Instructions
Note: any cosmetic imper ections or physical damage due to resizing the bracelet is not warranted
by Heritor. As such, pro essional adjustment o the bracelet is recommended.
1)
Support the
bracel
et between two bracelet holders
as
shown below. Note: the link end and link pin will move
as one unit during removal.
2
)
Use a
pin punch
(1mm max
.
)
and a suitable hammer to
drive the link pin in the noted direction.
3)
I
necessary
,
remove the bracelet rom the holders
and gently pry between the center link and link ends to
aid in removal.
4
)
Once separated, the link ends will pull ree o the
bracelet as shown. Repeat on neighboring link or center
link removal (two end links + 1 center link = one ull link).
5)
Reassembly
is
the
reverse o removal.
E
nsure that the
pins are aligned with the link end holes and protect the
link end with a small piece o rubber prior to hammering.
6)
In place o removi
ng one link, or to ine tune itment,
the clasp link spring bar has two alternative mounting
locations on the clasp.
© Heritor