HeyCafe HC-880 Operating instructions

Troubleshoo�ng: HeyCafe HC-880
Fault Cause
Remedy
The grinder is
not grinding,
the display is
not lit up.
The grinder
is making
n
oise but
not
grinding.
•The mains plug is
not plugged in.
•
The thermal cut-
out has tripped.
•
The electrical fuse
has tripped.
•
The grinding
mechanism is
clogged. / The
grinding degree is

•

built up in the
grinder because of
an excessive

•
A foreign object
has got into the
grinding
mechanism.
insert the power plug into a properly
installed socket.



the socket and allow the grinder to cool
down for 30 minutes. replace the power plug


grinder again as normal. if the cut-out trips
repeatedly, contact a service technician for
support.

Check the electrical fuse. if required, restore
the fuse to its original state or replace it.
Check whether other loads are connected to
this fuse and if so, pull out their plugs. if the
fuse repeatedly trips, contact a service
technician for support.



grinder will clear itself. Then set the desired



spout including the spring using a brush. Set

and start the grinding process. The grinder
will clear itself. Then set the desired grinding


Clean the grinder See HeyCafe HC-880 User
Manual Chapter 9, “Cleaning the Grinding
Chamber” for 
grinding chamber
the foreign object. If the foreign body cannot
be removed in this way, further

Hey Café

The grinder is
not grinding

•
The grinding discs
are worn out or
require
readjustment.
required. Contact a service technician for
support.

See HeyCafe HC-880 User Manual Chapter 9,
“Cleaning the Grinding Chamber” for
or
contact a service technician for support.

The grinder
does not
grind

interrupts
the grinding.
The grinder’s
dispensing
accuracy is
decreasing.
•The trigger
switch is

•The spout is
clogged. Too
much ground

deposited in
solid form inside
the grinder.
Trigger switch requires replacement. See
HeyCafe HC-880 User Manual Chapter 9,
“Cleaning the Grinding Chamber” for
removing the front panel to
access the switch or contact a service
technician for support.

Clean the spout including the spring with a


and start the grinding process. The grinder
will clear itself. Then set the desired
.
Maintenance and service
if you require service or maintenance, contact an authorized technician

also be found at:
www.heycafe.com
Fault
Cause
Remedy