Grab your iGlucose lancing
device, a sterile lancet, and your
vial of iGlucose test strips. Press
and hold e button to power
on e device.
Press and hold to power
on e device. You may need
to charge e device (takes
2-3 hours to fully charge),
en unplug before using.
When you see and “Apply
a drop of blood” on e screen,
place your pierced finger on e
top of e test strip. The entire
line on e test strip should
change from yellow to red. If your
blood sample doesn’t fill e line,1
remove e lancet and start again.
The meter will count down from
5, en display your result. You’ll
see “Reading transmitted and
recorded” when it has been
sent to your Care Everyday
Care Manager.2
Press to choose if
you’re taking your blood
glucose test before eating or
if you’re taking it wiin two
hours of eating.
Your test is complete! Please see
e user manual for instructions
on removing and discarding
used lancets and test strips.
Grab a test strip and insert it into
e meter from e right wi e
arrow pointing down towards e
opening (test strip port). Close
e vial of test strips right away.
Setting up your iGlucose® Glucometer
1
5
2
6
3
7
4
