HIK VISION DS-2CC102PN-IRA User manual

Day/Night Bullet Camera·User Manual
0
IR Bullet Camera
User Manual
V1.0.0

Day/Night Bullet Camera·User Manual
1
Thank you for purchasing our product. If there are any questions,
or requests, please do not hesitate to contact the dealer.
This manual applies to DS-2CC102P(N)-IRA, DS-2CC112P(N)-IRA,
DS-2CC192P(N)-IRA, DS-2CC1182P(N)-IRA,
DS-2CC1192P(N)-IRA, DS-2CC11A2P(N)-IRA Bullet Camera.
This manual may contain several technical incorrect places or
printing errors, and the content is subject to change without notice.
The updates will be added to the new version of this manual. We
will readily improve or update the products or procedures
described in the manual.
DISCLAIMER STATEMENT
“Underwriters Laboratories Inc. (“UL”) has not tested the
performance or reliability of the security or signaling aspects of this
product. UL has only tested for fire, shock or casualty hazards as
outlined in UL’s Standard(s) for Safety, UL60950-1. UL
Certification does not cover the performance or reliability of the
security or signaling aspects of this product. UL MAKES NO
REPRESENTATIONS, WARRANTIES OR CERTIFICATIONS
WHATSOEVER REGARDING THE PERFORMANCE OR RELIABILITY
OF ANY SECURITY OR SIGNALING RELATED FUNCTIONS OF THIS
PRODUCT.”

Day/Night Bullet Camera·User Manual
Regulatory Information
FCC Information
FCC compliance: This equipment has been tested and found to
comply with the limits for a digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the
interference at his own expense.
FCC Conditions
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including
interference that may cause undesired operation
EU Conformity Statement
This product and - if applicable - the supplied
accessories too are marked with "CE" and comply
therefore with the applicable harmonized
European standards listed under the Low Voltage Directive
2006/95/EC, the EMC Directive 2004/108/EC.
2

Day/Night Bullet Camera·User Manual
2002/96/EC (WEEE directive): Products marked
with this symbol cannot be disposed of as unsorted
municipal waste in the European Union. For proper
recycling, return this product to your local supplier
upon the purchase of equivalent new equipment, or dispose of it at
designated collection points. For more information see:
www.recyclethis.info.
2006/66/EC (battery directive): This product
contains a battery that cannot be disposed of as
unsorted municipal waste in the European Union.
See the product documentation for specific battery
information. The battery is marked with this
symbol, which may include lettering to indicate cadmium (Cd),
lead (Pb), or mercury (Hg). For proper recycling, return the battery
to your supplier or to a designated collection point. For m
information see: www.r
ore
ecyclethis.info.
3

Day/Night Bullet Camera·User Manual
Safety Warnings and Cautions
Please pay attention to the following warnings and
cautions:
Hazardous Voltage may be present: Special
measures and precautions must be taken when
using this device. Some potentials (voltages) on the
device may present a hazard to the user. This device
should only be used by Employees from our company with
knowledge and training in working with these types of devices that
contain live circuits.
Power Supply Hazardous Voltage: AC mains voltages
are present within the power supply assembly. This device must be
connected to a UL approved , completely enclosed power supply, of
the proper rated voltage and current. No user serviceable parts
inside the power supply.
4

Day/Night Bullet Camera·User Manual
System Grounding (Earthing): To avoid shock, ensure
that all AC wiring is not exposed and that the earth grounding is
. E e
a
power supply cord is the main disconnect device to
Installation and Maintenance: Do not connect/disconnect
any cables to or perform installation/maintenance on this device
during an electrical storm.
maintained
attached is
and are appr
nsure that any equipment to which this device will b
lso connected to properly wired grounded receptacles
oved medical devices.
Power Connect and Disconnect: The AC
mains (AC power).The socket outlet shall be
installed near the equipment and shall be readily
accessible.
Power Cord Requirements: The connector
that plugs into the wall outlet must be a
grounding-type male plug designed for use in your
region. It must have certification marks showing certification by an
agency in your region. The connector that plugs into the AC
y. There
is a risk of explosion if the battery is replaced by an incorrect type.
receptacle on the power supply must be an IEC 320, sheet C13,
female connector. See the following website for more information
http://kropla.com/electric2.htm.
Lithium Battery: This device contains a Lithium Batter
5

Day/Night Bullet Camera·User Manual
Dispose of used batteries according to the vendor’s instruction
and in accordance with local environmental regulations.
Perchlorate Material: Special handling may apply. See
www.dtsc.ca.gov/hazardouswaste/perchlorate. This notice is
required by California Code of Regulations, Title 22, Division 4.5,
s
ent Practices for Perchlorate Materials.
in des a battery which contains perchlorate material.
Please recycle batteries.
me
heat sinks, power regulators,
t
om
ate radio
o radio
and off, the user is
Chapter 33: Best Managem
cluThis device
Taiwan battery recycling:
Thermal and Mechanical Injury: So
components such as
and processors may be hot; care should be taken
to avoid contact with these components.
Electro Magnetic Interference: This equipment has no
been tested for compliance with emissions limits of FCC and similar
international regulations. This device is not, and may not be,
offered for sale or lease, or sold, or leased until authorization fr
the United States FCC or its equivalent in other countries has been
obtained. Use of this equipment in a residential location is
prohibited. This equipment generates, uses and can radi
frequency energy which may result in harmful interference t
communications. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment on
6

Day/Night Bullet Camera·User Manual
required to take measures to eliminate the interference or
e
en
nvironmental
regulations for proper recycling; do not dispose
of device in unsorted municipal waste.
use of this equipment.
t:
Please recycle this device in a responsible
manner. Refer to local e
discontinue th
Lead Cont
7

Day/Night Bullet Camera·User Manual
Safety Instruction
These instructions are intended to ensure that user can use the
product correctly to avoid danger or property loss.
The precaution measure is divided into “Warnings” and “Cautions”
Warnings: Serious injury or death may occur if any of the
warnings are neglected.
Cautions: Injury or equipment damage may occur if any of the
cautions are neglected.
Warnings Follow these
safeguards to prevent
serious injury or death.
Cautions Follow these
precautions to prevent
potential injury or material
damage.
Warnings
In the use of the product, you must be in strict compliance with
the electrical safety regulations of the nation and region.
Input voltage should meet both the SELV(Safety Extra Low
Voltage).
the Limited Power Source with AC 24V or DC 12V according to
the IEC60950-1 standard.
Please refer to technical specifications for detailed information.
8

Day/Night Bullet Camera·User Manual
the Limited Power Source with AC 24V or DC 12V according to
the IEC60950-1 standard.
Please refer to technical specifications for detailed information.
Input voltage should meet both the SELV(Safety Extra Low
Voltage) and the Limited Power Source with AC 24V or DC 12V
according to the IEC60950-1 standard. Please refer to
technical specifications for detailed information.
Do not connect several devices to one power adapter as
adapter overload may cause over-heating or a fire hazard.
Please make sure that the plug is firmly connected to the
power socket.
When the product is mounted on wall or ceiling, the device
shall be firmly fixed.
If smoke, odor or noise rise from the device, turn off the power
at once and unplug the power cable, and then please contact
the service center.
If the product does not work properly, please contact your
dealer or the nearest service center. Never attempt to
disassemble the camera yourself. (We shall not assume any
responsibility for problems caused by unauthorized repair or
maintenance.)
Cautions
Make sure the power supply voltage is correct before using the
camera.
9