Hiland F5001 User manual

F5001 A3 Flash lamp user manual Version: A8
F5001 Flash lamp user manual
I. Technical Specification
1. working voltage：24VAC/DC
2. Loading capacity：less than 16W
3. Flicker Frequency：1HZ
4. Working temperature：-20º～+60℃
5. IP Level: IP54
6．Size：φ90* 125mm
7．Weight：152g
II. Connecting Instruction
1. Connect the wire with J1 if power supply is 24V AC/DC
2. J2 is for connecting the antenna to extend the effective distance of controller
III. Instructions
4.1 Bulb will flicker in 1HZ after power on
4.2 JP1 switch
It’s the switch for switching bulb in flickering or lighting,
When JP1 at FLASH, bulb will flicker in 1HZ after power on;
When JP1 at NO FLASH, bulb will light after power on
IV. Installation
1．Open the package and take out
the accessories for installation.
2．Stick the paper on the proper place, and then drill the hole.

F5001 A3 Flash lamp user manual Version: A8
The interpretation and ownership of this manual belong to Hiland company. Any change of the product can be
without prior notice.
3．Take out the paper and install the expansion tube into the hole.
4．Crush the screw hole of bottom.
5．Take out the lamp ring as the
direction showed.
6．Take off the yellow cover as the
direction showed.
7．Connect the power supply
and antenna.
8．Put board into black base, and
fix them with screw of Φ4*25
9．Install the black seal
ring correctly.
.
10．Fasten the cover into the
bottom.
11．Fix the cover and base with
screw Φ2*8
12．Put on the decorative ring
and finish the installation.