
English C
Important Safety Instructions
 
Moving/Transportation
Before moving this TV, disconnect all 
cables and move in the vertical position 
only. Grasp the device on the upper and 
lower edges of the frame. 
- Do not press or put stress on the front 
panel of the TV. It may take two or 
more people to carry larger TVs.
If you have to briey lay down the TV, 
place the unit with its entire front surface 
lying at on soft material.
The LED screen is made of glass and can 
break if is not handled properly. Always 
wear rubber gloves to carry the unit. If 
the LED screen is damaged, liquid crystal 
might leak out. In case of skin contact, 
immediately rinse thoroughly with water.
 
Power Supply
Incorrect voltages can damage the TV. 
Only connect this unit to a power supply 
with the correct voltage and frequency 
noted on the type plate, using the 
supplied power cable.
The power plug must be easily accessible 
so that the device can be disconnected 
at all time. The unit is live, even if the I/O 
button is switched off, as long as the unit 
is connected to a power outlet.
It is recommended that this unit is placed 
on a dedicated circuit. 
- Do not overload the power outlets by 
connect too many appliances to the 
same outlet. Overloaded wall outlets, 
extension cords, etc. are dangerous 
and can result in electric shock and 
re.
After power off, don't turn it on again in 
5 seconds. Frequent switching power 
supply in a short period of time can cause 
abnormal TV.
 
Power plug and power cable
- Do not touch the power plug with wet 
hands. 
- Do not place heavy objects on the 
power cable. Route the cable so that it 
is not kinked or laid over sharp edges, 
walked on or exposed to chemicals. A 
power cable with damaged insulation 
can cause electric shock and re.
-  Pull the power plug, NOT on the cable 
when disconnecting. The cable can 
become damaged and cause a short 
circuit if pulled on.
- Do not place the power cable near a 
high temperature object.
- Do not move the TV with the power 
cable plugged into a socket.
- Do not use a damaged or loose power 
cable, or a damaged socket outlet.
- Do not use any power cords other 
then the one supplied with this unit. 
 
Set-up
Check that the location is suitable to bear 
the load of the TV. Place on a level, sturdy 
and horizontal base. Ensure that the unit 
does not hang over the edge of the base 
when placed in or on furniture. If placed 
on a cart, use caution when moving to 
avoid the unit from tipping over.
- Place the unit in a normal upright 
horizontal position. It must never 
be operated vertically, lying at or 
hanging overhead from the ceiling.
- Place the unit where it is not exposed to 
direct sunlight or other sources of heat.
When mounting the TV on a wall, follow 
the instructions supplied with the wall-
mount, make sure not to install the TV by 
hanging the power and signal cables on 
the back of the TV.