Hitachi CM1584ME User manual

COLOUR MONITOR
FARBMONITOR
MONITOR EN COLOR
MONITOR ACO1ORI
MONITEUR COULEUR 15MVX
CM7584ME
USER MANUAL .........■. . . . . . . . . . . . . . . .page 2
BEDIENUNGSANLEITUNG ...■.......=.■ ■ =seite 8
MANUAL DEL USUARIO . . . . . . . . . . . . . . . . p~gina 1(5
lSTRUZIONI PER L’USO. . . . . . . . . . . . . . ..=.. =pag 22
MANUEL DE L’UTILISATEUR . . . . . . . . . . . . . ●page 28

–NOTICE
=The i~o-ation in tfis d~ument is subject to change without notice.
-Hitachiassumesno responsibilityfor any errors thatmay appear in this
=doeumenL
Colour Monitor ‘hVIVX
Operating Guide
Features
●The fo]lo~ng features are provided with the HITACHI colour
Monitor 15MVX.
●Wide compatibility range of graphics standard, VGA, XGA,
8514/A, Super VGA, and Macintosh II Video Card.
●Sharp focus and remarkable display quality by new design CRT.
●Cubic and Simple design cabinet with Tilt and Swivel base.
●NOventilation holes on top of the cabinet for better safety.
TRADEMARK ACKNOWLEDGMENT
IBM PC, PC/XT, PC/AT. Personal Systems/2, VGA, and 8514/A are registered
trademarks of International Business Machines Corporation.
Apple and Macintosh are registered trademarks of the Apple Computer, Inc..
Macintosh II Video Card is atrade mark of Apple Computer, Inc..
2lSMVX User Manual

@i@
E■
m
-
NEVER REMOVE THE BACK COVER E.
Removal of theback cover MUST be carriedout only by
qualiikd personnel. This dwplay monitor qontainshigh voRage
tilde.
DO NOT USE IN HOSTILE ENVIRONMENTS
DO NOT expose thisdisplay monitor to rainor moistureto
preventelectric shock or fue hazard. This unitis designed to be
used in office or home.
DO NOT subject theunitto vibrations,dust,or corrosive gases.
KEEP IN AWELL VENTILATED PLACE
DO NOT cover thismonitor or place anythingagainstthesides
of unit. Ventilationholes areprovided on thecabinet to prevent
thetemperaturefrom rising. Ventilationholes are also provided
on thebottom of thecabinet.
AVOID HEAT
Avoid placing theunitinduect sunshineor nearaheating
appliance.
BE CAREFUL OF MAGNETIC FIELDS
DO NOT place amagnet,loud speakersystem, floppy disk
drive, or anythingwhich will generatemagnetismnearthe unit.
Amagnetic field may cause blurredcolors or distortionof the
displayed pattern.
lSMVX User Manual 3

i @PERATm@
-Controls
Front View
[
[m
(7) (6) (5) (4) (3) (2) (1)
Rear View
u
El
J) u—--,R@
(i)
(1) Power Switch
Use this switch to power ON or OFT by pressing it.
When the power is ON, green light on the knob turnson to indicate.
(2) ContrastControl [0)
Use this to set theforeground brightness of thescreen.
(3) Brighmess Control [~@)
Use thii to set the background to black.
Most of the latestapplication software utilizes coloured background and this control
is usually set atits maximum.
(4) Horizontal Size [~]
Adjust this control to the preferred horizontal width. If the width is too wide, partof
information will lx missed from the screen.
(5) Horizontal Position [~]
Adjust this to place the display at thecentre of the screen.
415MVX User Manual

(6) Vertical Size
Adjust thiscontrol to the preferred height.
(7) Vertical Position
Adjust this to place the display at the centre of the screen.
(8) Signal Cable
Connect the end of the cable to your computer.
(9) Power Cord In-let Comector
Insertproper power cord here.
BEFORE CONNECTING THE MONITOR TO YOUR
COMPUTER, MAKE SURE THE POWER TO THE MONITOR
AND COMPUTER ARE TURNED OFF.
1. Connect the signal cable to your computer’s video outputconnector. The connec-
tor is compatible with IBM P.S./2 series computers and VGA standardgraphics
cards for IEM PC, PC/XT, PC/AT, and compatibles. When you are using the
monitor with Apple Macintosh II computer, please obtain an optioml converter for
connection from your dealer. Hitachi’s pantnumber for converter: SC-1
2. Connect power cord to the monitor thento wall power outlet.
USE PROPER UL/CSA APPROVED POWER CORD...HO5F-F
3. Power on the monitor thenpower on your computer. When you switch OFF, do
the reverse sequence.
4, Adjust front located user controls to obtain right picture size, location, and
brightness. Display location on thescreen and the size may change when you switch
one application software to another one.
5. Adjust Tilt& Swivel to suit your eye level.
DO NOT use themonitor with abright background light, direct sunshine, or bright
light into the screen area. These may increase eye fatigue.
Earth magnetic field can affect the display screen, therefore, when the
monitor is turned on the bases and shows impurity of color, power off the
monitor then power onto activate automatic degauss circuit. Do not make
this sequence too quick.
15.MVX User Manual 5

:@COMPATIBILITY>
❑15MVX is compatible with
1. IBM PS/2 series computers with MCGA, VGA XGA and 8514/A graphics
standards. Signal cable is conilgured as IBM 8514 monitor.
2. Most of the VGA and Super VGA standardgraphics boards available for the PC,
PC/AT,PS/2 and EISA bus computers. Please ask your dealer for details.
3. Apple Macintosh II computer with Macintosh Video Card. You haveto obtain a
15 pinto 15pin converter (Hitachi partsxSC- 1)from your dealer.
Connector Pm Assignment
Pin#
1Red Video
2Green Video
3Blue Video
4Ground
5Ground
6Red Ground
7Green Ground
8Blue Ground
Pin#
9No Pin
10 Ground
11 Ground
12 No Pin
13 Horizontal Sync
14 Vertical Sync
15 No Connection
615MVX User Manual

CRT
input Signal
Synchronization
Resolution
Video Band Width
Active D~play Area
Miswnvergence
Power Supply
Power Consumption
Dmensions
Weight
Environmental
Conditions
w
15(14V) inches diagonal, 0.28 mm dot pitch Black ~
mati Silica coa~ Short Persistence. m
Video: 0.7 Vpp
Sync: SeparatemV or Composite H/V lTL level or
Sync on Oreen at0.3 Vpp.
Horizontal 30 —58 kHz
Vertical 5O—1OOHZ
Automatically synchronize.
Horizontal: Up to 1024 dots
Vertical: Up to 768 lines
75 MHz “
Horizontal: 260 mm
Verticak 195 mm
Active display areais changed by the graphics board
standard.
Less than0.5 mm
AC 200--240 V, 50 Hz
100 WApproximately
358 (W) X378 ~X414@) mm
Jncluding Tilt& Swivel base.
16.5 kg
Operation Storage
Temperature 5°C to 35°C -20°C to 60”C
Humidity: 30% to 80% 10% to 90%
15MVX User Manual 7