HME JTECH ISTATION 4400RF PLL Owner's manual

ISTATION RECEIVER BOARD (4400RF PLL)
PROGRAMMING

1st:
Connect the ID Writer (ACCPRG) v-20 into
a PC USB port.
The Jig tool will show its version for a
second and go to Stnd
Click “Next”
Click “Finish”
Click OK
2nd:
Run RF_MODULE PC Program, PC program will ask to install the driver, click
OK.

Port(COM & LPT)
Port Setting
Device Manager
1ST Connection : (CP2102 , VCP) Select
port # that matches the one shown in
Device Manager
2nd Available Settings:
•baud-rate: 512 or 1200
•Frequency: 420 - 470 MHz

IMPORTANT:
DO NOT plug the power adaptor into the IStation
while programming the RF board.
1. Having the side with mark/green
dot/arrow label facing you, push down the
jig pins firmly on the contacts.
2. To see programmed baud-rate and
frequency click on the “Read” button or
Shortcut Key: F1 (a window with the
information will pop up).
3. Select the desired Baud rate and Frequency,
Click the “Write” button (or Shortcut Key:
F2) to program the baud-rate and
frequency.

- Read Success - Write Success - Read/Write Fail

-LED2 turns on when
Baud-rate is set to 512
-LED2 turns off when
Baud-rate is set to 1200
-LED1 flashes when there
is incoming signal