Hobby King FD-BT User manual

-
Specificaon
BLUETOOTH ALTIMETER (FD-BT)
MANUAL
Connect the JST of FD-BT to the balance channel
of receiver and connect 1.25mm JST of Bluetooth
with almeter.
There is one 3 secon toggle switch, its funcon
as follows:
Record data: when you make the switch to
“RECORD” Bluetooth module were not access,
almeter gets into working mode and start to
record data, at this me the Bluetooth module
power consumpon is almost 0 mA.
Stop working: When you make the switch to
“STOP” posion, Bluetooth module and almeter
are not working.
Seng clear: When you make the switch to “SETUP” posion, Bluetooth module was access, at
this me the blue LED on Bluetooth will be flash.
Download the newest soware of Android from www.fd-rc.com, and install it to your Android
system. At present, it support Android2.2 version or over. The system will in the installaon of a
new root directory called "FlyDream" folder, the upload data and screenshot of FD-BT will keep
all in it.
Take ZTE U880 for example to show the operaon
Find the soware of FD-Almeter, open it and you will see two icons. The above is connect the
Bluetooth module sengs almeter interface, and the below one is drawing interface. Press the
menu buon of mobile, you can see “Contact us”,” soware state” and “Exit” informaon.
1.
2.
1.
2.
Hardware operaon
The soware of Android installaon
Dimension：28mm*16mm*5mm
Weight：3.3g
Maximum range：10m
Working current：<20mA
Working voltage：3.7V-8.4V

Drawing Interface
FD-Altimeter for Android FD-BT (v1.0)
Setup interface
Click the first icon, enter setup interface, the screen will prompt Bluetooth permission request, click
“YES”, enter setup interface. At first “connect Bluetooth device ". The hardware of FD - BT named for
"FLY - DREAM" and the password is "1234". Aer the success of the connecon, the blue LED on the
Bluetooth module will flash and changes to a long light.
In setup interface, users can upload the data of FD-A almeter, also can set up the frequency of FD-A
and clear the data of FD-A.
Click the second icon enter drawing interface. Choose the data you uploaded just now or lead data
from “Import from.fda” to your mobile. Off course you can export data from “Export to.fda” to your
mobile. Press the menu buon of mobile, you will see the buon of “Parameter seng”, you can set
the height unit, the temperature unit, Height calc and data automacally collate in “parameter
seng”. Choose one of your flight and click” drawing” buon enter drawing interface.