Hobby Topgun D011 User manual

Model No : D011
Scale EDF Radio Control model airplane
Wingspan : 1,550 mm
UNDER SAFETY PRECAUTIONS
This radio control is not a toy!
- Always keep this instruction manual ready on hand for quick reference.
- Assemble this kit only places out of children reach.
- First-time builders of EDF model should seek the advice of experienced modellers before
beginning assembly and if they do not fully understand any parts of the construction.
- Taking out liability insurance is recommended.
- You are responsible for this model’s assembly and safe operation.
6 pcs required
1. Signal cable
- Elevator
- Aileron
2. Micro servo
Dimension : 23mm (L) x 28mm (H) x 12mm (W)
You need to purchase the following accessories separately to complete the model.
5 pcs required
800mm
1 pc required
4. 70A Electric Speed Control (ESC) w/BEC
70A
w/ BEC
5. B36 Brushless Motor, 1500-1700kv,
Outruner or Inrunner, Shaft dia 5mm
1 pc required
3. Li-Po Battery, LiPo, 5-6 cells, 4400mAh 20C
CCopyright 2010 Hobby Topgun Designed and Manufactured by : Hobby Topgun http://www.hobbytopgun.com
1 pc required
Designed by :

Fuselage main
Plywood set
Decal set
Main component
Qty Description
Parts
3 mm
thickness
Tail plane
Plastic parts
P-1
P-3
No
4 x 45mm screw
4 x 60mm screw
P-6 4
2
4mm blind nut
P-2 6
Nose x 1
Main x 2
P-1 1
4 mm collar
P-3 1
4 x 54mm wire
P-4
1
1.5 x 130 wire
P-5
7
3 x 10 mm screw
P-8
16
3 x 4 mm set screw
P-9
9
4 x 40mm wire
P-7
2
3 x 4 mm screw
P-10
7
P-11
7
P-12
2
1
P-13
Canopy lock
1
P-14
CCopyright 2010 Hobby Topgun Designed and Manufactured by : Hobby Topgun http://www.hobbytopgun.com
Vertical tail fin
Wing
Ducted fan unit
1 set
W-1
Description
Parts Qty
No
Undercarriage
housing
Nylon horn
P-16
P-16
P-16P-16
P-18
Magic tape
P-19
P-22
Nylon horn
P-17
P-15
3
7
2
Epoxy Glue
1
1
2Stainless steel
base
P-20
P-21
P-22
P-22
Canopy
4
Epoxy A
Epoxy B
W-14
W-15
Fuel tank
Nylon hinge
21
W-16
W-2
W-8
W-9
W-3 W-4 W-7
W-5
W-10
W-13
W-6
W-11 W-12
PP-1
PP-2
C-1
C-2
C-3
C-4
C-5
Carbon Rod
160x10x2mm
150x10x2mm
6 x 60 mm
8 x 70 mm
6 x 100 mm

W-1
W-9
CCopyright 2010 Hobby Topgun Designed and Manufactured by : Hobby Topgun http://www.hobbytopgun.com
Li-Po
P-20

W-7
W-13
Main gear assembly Nose gear assembly
P-13
P-10
P-9
P-8
P-10
P-16
P-4
P-3
P-9
P-16
P-16
P-10
P-14
Undercarriage
3
P-10
CCopyright 2010 Hobby Topgun Designed and Manufactured by : Hobby Topgun http://www.hobbytopgun.com
LED

CCopyright 2010 Hobby Topgun Designed and Manufactured by : Hobby Topgun http://www.hobbytopgun.com
W-2
ESC
P-19
P-12
P-11

7Ducted fan unit
Warning : Always check the motor and fan
unit assembly every 5 flights at
least. The screws may loose by
the vibration in flight.
PRECAUTIONS : BALANCING OF THE ROTOR.
(1) PLEASE WELL BALANCE THE ROTOR WHILE MOUNTING THE MOTOR.
ANY UNBALANCED ROTOR WILL EXPLODE AND DAMAGE TO THE
HOUSING IN THE HIGH RPM ROTATION.
(2) CONNECT THE POWER AND RUN THE ROTOR IN LOW RPM.
(3) HOLD THE FAN BY HAND AND FEEL THE VIBRATION OF
THE FAN HOUSING.
(4) HODING THE SHAFT OF THE MOTOR AND TURN
THE ROTOR IN ONE DIRECTION 20 EVERY TIME.
(5) RUN THE ROTOR AGAIN. REPEAT STEP
(3)-(4) TO FIND THE LESS VIBRATION POSITION.
COMPLETE THE ABOVE PROCESS
AND YOUR FAN IS WELL BALANCED.
SECURE THE NUT BY THREADLOCKER.
R
Achtung: Bitte prüfen Sie immer nach 5 Flügen alle Verschraubungen. Die Schrauben können sich durch Vibrationen während des Fluges lösen.
(a) Bitte lose Gegenstände von der Ansaugseite bei Inbetriebnahme fern halten.
(b) Den Impeller nicht einschalten, wenn Sie ihn in der Hand halten weil er dadurch zerstört werden könnte.
(c) Bitte nach jedem Flug kontrollieren
(d) Immer an die Sicherheit denken
(e) Alle Schrauben sichern. Der Betrieb des Impellers ist das Risiko des Betreibers.
Das Modell ist kein Spielzeug. Nicht für Kinder unter 12 Jahren geeignet.
(a) Never operate the unit with loose items of clothing or equipment near to the intake area.
(b) Never operate the unit held in your hands as personal injury, or damage to the unit may occur.
(a) Never operate the unit with loose items of clothing or equipment near to the intake area.
(c) Always do a thorough inspection of the unit prior to any operational use.
(d) Always think safety first.
(e) Secure all the screws. If any screws loose while rotating and the serious injury may occur.
This is not a toy! The unit should only be operated by childs of 12 years and supervised by an adult.
8Ducted fan unit
W-11
W-12
W-10
CCopyright 2010 Hobby Topgun Designed and Manufactured by : Hobby Topgun http://www.hobbytopgun.com
C-3
C-1 C-2
P-2
P-9

Wing
Undercarriage
9
10
CCopyright 2010 Hobby Topgun Designed and Manufactured by : Hobby Topgun http://www.hobbytopgun.com
W-8
W-4
W-6
W-3
W-5
C-4
C-5
P-20
PP-2
PP-1
P-19
P-12

P-6
W-16
11
12
CCopyright 2010 Hobby Topgun Designed and Manufactured by : Hobby Topgun http://www.hobbytopgun.com
W-14
P-6
P-7
W-15
P-14
DON’T GLUE THE
COVER. REMOVABLE
FOR ACCESS TO THE
CABLE CONNECTION.

HOBBY TOPGUN
HOBBY TOPGUN
13 Decal
Water base decal set
Instructions to apply the water base decal:
(1) Cut the graphic by individual pieces.
(2) Put the decal inside water for few
seconds until the graphic able to
move by hand.
(3) Place the graphic with base paper to
the right position.
(4) Hold one end of the graphic to the
surface and slide out the base paper.
CCopyright 2010 Hobby Topgun Designed and Manufactured by : Hobby Topgun http://www.hobbytopgun.com

         
         
                                            !
"                    #    #           #            
       #     !
$ % & ' ( ) * + , - . / 0 / 1 & 2 2 ( 3 & ' + 4 5 6 7 8 * + 5 7 9 : 5 9 ; : 5 4 < : = - 4 ) 7 9 2 ( > 1 & 2 2 ( 3 & ' + 4 5 , - - ' > ? ? @ @ @ A , & 2 2 ( - & ' + 4 5 A = & B
C
C D
E F G G
E F G G
E H G G
E H G G I J I K L M N O
L P J I O N Q
R F G G S
J L T
10 mm