HobbyBoss Mi-2T Hoplite User manual

PLEASE READ BEFORE OPERATION!
* Tools recommended as below: (Not included)
Adhesives; Paints; Side Cutters; Shar Edged Pliers; Modeling Knife; Modeling
File; Ni ers; Drill; Scissors; Sand Pa er; Soft Cloth; Cyanoacrylate Glue.
* Make sure to read this instruction listed below before assembling.
* The kit contains the small arts, they can be dangerous if swallowed by mistake,
so kee them away from reach of children.
* Cut the all arts off carefully and remove the waste arts into the garbage can.
* More caution and care should be needed for cutting and handling the hoto
etched arts.
* Make attention that some arts should be attached the decal when assembled.
* During assembling, lease tear u and throw away the lastic bags, or may cause
the dangerous if wearing over head by children's mistake.
* When using the adhesives and aints, lease do not use them in the closed room
or near the fire, also must be very careful to rotect your eyes.face and clothes.
* Adult su ervised when assembled by children under 14 years old.
*nsrji, -Km®, tik.
mi, * m mu, w Ⱦ.RinttTR*.
* tu««*)*
H a Hmaa□aa
cyanoacrylate glue weight make hole cut / remove o tion no cement decal bend Re air
SEfi *5iL m m üfÉ
The method to a ly the decals
1 .Cut off the decal from the decal a er and ut it into the warm water 40 C for 10
seconds.
2. Take the decal from the water and ut it on a iece of clean cloth.
3. Remove the decal slowly from the a er to the targeted location by a wet finger.
4. Use a iece of dry and soft cloth to ress it gently on the decal until it getting dry
and no bubble existing.
&A40C££ltt
-. s*±.
Vj