7
Trampoline Assembly
Take one of the side tensioning lines and pass the line
through the pad-eye that is fixed to the front crossbar.
Then tie with a bowline knot the line onto the grommet of
the trampoline near where the rope exits the trampoline.
Repeat this step at the opposite side front corner.
Unfold the trampoline. Note that the trampoline has side tension lines that are already pre-threaded.
Insert the front edge of the trampoline into the track at the left, rear side of the front crossbar. Continue
feeding the trampoline into the track and position it in the center. line up the grommet in the center of the
trampoline with the dolphin striker post to ensure it is centered.
1
2
Move to the rear of the trampoline. Very closely to where the side
tensioning line exits the rear of the trampoline tie a loop. ensure you
pull the side tensioning line firmly as to tie the loop as closely to the
trampoline where the rope exits as possible. Tie a bowline or a similar
loop in the line which will be used for a 4:1 purchase of the side
tensioning lines. Repeat this step for the opposite side rear corner.
Now take the tale of the side
tensioning line and pass the
rope through the pad-eye
mounted on the rear cross beam
closest to where the line exits
the trampoline. Then pass the
line back through the loop tied in
step3. Again go through the
pad-eye on the beam and back
through the loop. This will
provide a 4:1 purchase. Pull the
line slightly as to take some tension for
the sides but do not completely tension
at this stage. Repeat this step for the
opposite side rear corner. Ensure that
the trampoline is still centered.
3
4
