Holman 40114 Manual

Holman
Rancho Cordova, CA 95742
800-343-7486
[e-mail]
20221102R1 DATE: ________________
Instruction Guide
40114

Instructions –40114
For Technical Support Call: 800-343-7486, Monday-Friday, 7AM - 4PM (PST) Page 1
PLEASE READ ALL INSTRUCTIONS AND WARNINGS PRIOR TO ASSEMBLING,
INSTALLING, AND USING THIS PRODUCT.
Warning
Always check for wires, fuel tanks and lines, brake lines and other important
vehicle functionality items prior to drilling and installing all products.
Table of Contents
Tools Needed.......................................................................................................................................1
Before You Begin.................................................................................................................................1
Parts List ..............................................................................................................................................2
Hardware..............................................................................................................................................2
Step 1 –Prepare Installation Location................................................................................................3
Step 2 –Install Tray Organizer............................................................................................................3
Tools Needed
3/8” Socket and Wrench
7/16” Box Wrench
17/64” Drill Bit
Drill
Before You Begin
Read all instructions prior to assembling or installing any Holman product.
Always locate your installation locations prior to performing any work.
ENSURE SAFETY WHILE INSTALLING OR DRILLING INTO VEHICLE.

Instructions –40114
For Technical Support Call: 800-343-7486, Monday-Friday, 7AM - 4PM (PST) Page 2
Parts List
Hardware

Instructions –40114
For Technical Support Call: 800-343-7486, Monday-Friday, 7AM - 4PM (PST) Page 3
Step 1 –Prepare Installation Location
Determine proper installation location. Tray
organizer can be mounted to nearly any flat surface
such as shelf end panels and partitions. The tray
organizer may also be installed to van rear doors
with additional mount kit 40114T.
Verify clearance around installation, checking for
interference with van doors or other accessories.
Note: Minimum 6” clearance is required from mount
surface to front of tray organizer.
Mark location of six holes onto installation surface.
Note: When possible it is recommended to use the
highest top hole and lowest bottom hole for mounting.
Set aside tray organizer. Use 17/64” drill bit to drill six
marked holes.
Step 2 –Install Tray Organizer
Using six 1/4” x 5/8” flanged hex head screws and six
1/4” flanged lock nuts, install tray organizer.
TIGHTEN all hardware.
GO BACK AND ENSURE ALL HARDWARE IS
TIGHTENED.
INSTALLATION IS COMPLETE.
Minimum 6”