JWA CARY 68429 User manual

1
Imported by JWA Furniture Pty Ltd, Qld, Brisbane Australia.
For any assistance with assembly or for missing parts please refer to your receipt
ASSEMBLY INSTRUCTION
CARY
ITEM CODE 68429
CORNER DESK

PRE-ASSEMBLY PREPARATION
Before you start:
1.Choose a clean, level, spacious assembly area. Avoid hard surfaces that may damage the
product
2.Take care when lifting. Product should be assembled as near as possible to the point of
use
3.Ensure that you have all required contents for complete assembly
4.Always read the assembly instructions carefully before beginning assembly.
5.Keep all hardware parts and packaging out of reach of small children.
6.Do not over tighten the screws and bolts as this may damage the threads
2
Allow 30 min For 1 person Additional tools required

3
PARTS LIST
1Desktop panel
2Layer panel
P1 Right metal frame
P2 Left back metal frame
P3 Left front metal frame
P4 Support pipe
P5 Layer panel support pipe
P6 Main metal frame
connection pipe
P7 Back support pipe
P8 Left back support pipe

Load the fitting F into the metal frame P1, P2 and P3.
4
STEP 1:
1) Use fittingA to fix the metal pipes P5 and P6 on the metal frames P2 and P3;
2) Fix the panel 2 on the metal pipe P5 with fittingA.
STEP 2:

Fix one end of the metal pipe P4 to the metal pipe P6 and the other end to the metal
frame P1 with fittingA.
STEP 3:
Fix panel 1 on the assembled metal frame with fitting A.
STEP4:
5

1) Fix the metal pipes P7 and P8 with fitting C and E;
2) Fix the assembled metal pipe P7 assembly on the metal frame P1 and P2 with
fitting B and D;
3) Fix the assembled metal pipe P8 assembly on the metal frame P2 and P3 with
fitting B and D.
STEP 5:
6
Install a fall preventer.
STEP 6:

7
ASSEMBLY IS COMPLETE

8
SAFETY BRACKETS
INSTRUCTIONS
1. Attach one Mounting Plate to the wall with the Large Screws. Make sure to
attach the Mounting Plate into a stud. If mounting into brick or masonry you
will need to acquire wall anchors.
2. Attach the second Mounting Plate to the furniture frame with the Short
Screws.
3. Move the furniture to its final position. Thread a Wall Strap through the both
Mounting Plates and tighten until snug. Do not over tighten.
4. Make sure that the Mounting Plates are firmly attached to the wall and
furniture and that the Wall Strap is snug.

9
To protect your furniture, we suggest the following:
•Avoid placing your furniture in direct sunlight.
•Do not place furniture directly under windows.
•Do not place sharp materials (knife, fork, etc.) directly onto
your furniture as sharp material may scrape and damage the
finish.
•Do not place material with high temperature directly onto the
surface of your furniture.
•Clean up spills quickly. Water left over a prolonged period of
time may cause damage. Alcohol, perfume, nail polishes,
aftershave and some medication may cause severe finish
damage if not cleaned immediately.
•Use a clean, soft, dry, lint free absorbent cloth to clean your
furniture. Do not use any detergent as they may contain
ingredients that may react and damage the finish.
NOTE: If the above care advise is not adhered to your product
warranty may become void