Osmond Ergonomics FLO User manual

FLO - INSTRUCTIONS
1.
SEAT HEIGHT
2. BACK ANGLE
3. SYNCRO LOCK
Lift the lever on the right-hand side
and take your weight off the seat to
raise the height. Remain seated to
lower the height. Release the lever
to lock the seat height.
Take your weight off of the back and
twist the rear knob on the right-hand
underside of the chair to adjust the
angle of the back rest. To angle it
forwards twist clockwise, to angle it
backwards twist anti-clockwise.
To adjust the angle of the chair,
ensure the left-hand lever is lifted
and lean back to the required
position. To lock the chair, push the
lever down. To reset the angle of
the chair lower the lever lean back
slightly and then allow the backrest
to rise to its original upright angle.
4. BODY WEIGHT TENSION
5. BACK HEIGHT
6. LUMBAR SUPPORT
The resistance of the chair, when
unlocked, can be adjusted to suite
your body weight by turning the knob
on the right-hand side of the seat. To
increase the resistance turn
clockwise, to decrease the resistance
turn anti-clockwise.
To adjust the height of the backrest,
grasp the bottom of the backrest
and raise to the desired height. To
allow the backrest to be lowered
again, raise the backrest all the way
to the top and lower it to its lowest
position.
As you are sitting on the chair,
squeeze the bulb on the rear right-
hand side of the chair repeatedly to
inflate the lumbar support. Press
the button on the bulb to deflate
the lumbar support.

7. THORACIC SUPPORT
8. SEAT DEPTH
9. ARMREST HEIGHT
As you are sitting on the chair,
squeeze the bulb on the rear left-
hand side of the chair repeatedly to
inflate the thoracic support. Press the
button on the bulb to deflate the
thoracic support.
Push in the button on the right-hand
side and slide the seat forward or
backward. Release the button to lock
the seat pan.
To adjust the height of the armrest
press the button on the side of the
armrest and lift or lower to the
desired position. The armrest will
lock in to a total of six different
heights.
10. ARMREST ROTATION
Press the button underneath the
arm-pad and rotate the arm rest in
to position. Release the button to
lock the armrest in to position.
11. ARMREST WIDTH
12.HEADREST ADJUSTMENT
Lower the lever on the underside of
the armrest and move the arm to the
desired width, lift the lever back in to
its upper position to lock in the
armrest width.
Rotate the headrest cushion and
slide the support arm up or down for
varying support.