Holman 40380 User manual

Holman
Rancho Cordova, CA 95742
800-343-7486
[e-mail]
20221107R1 DATE: ________________
Installation Guide
40380

For Technical Support Call: 800-343-7486, Monday-Friday, 7AM - 4 PM (PST) Page 1
Instructions –40380
PLEASE READ ALL INSTRUCTIONS AND WARNINGS PRIOR TO
ASSEMBLING, INSTALLING, AND USING THIS PRODUCT.
Warning
Always check for wires, fuel tanks and lines, brake lines and other important
vehicle functionality items prior to drilling and installing all products.
Tools Needed
Phillips Driver
1/4” Drill Bit (optional)
Drill (optional)
Table of Contents
Parts List .................................................................................................................2
Hardware List ..........................................................................................................2
Step 1 Assemble .....................................................................................................3
Step 2 Find Location ................................................................................................3
Step 3 Attach ...........................................................................................................4
Before You Begin
Read all instructions.
ENSURE SAFETY PRIOR TO DRILLING.

For Technical Support Call: 800-343-7486, Monday-Friday, 7AM - 4 PM (PST) Page 2
Instructions –40380
Parts

For Technical Support Call: 800-343-7486, Monday-Friday, 7AM - 4 PM (PST) Page 3
Instructions –40380
Hardware
Step 1 –Assemble Tote Holder
Bolt both side assemblies to the back support in the orientation shown using
#10 x 1/2" pan heads, #10 flat washers and #10 lock nuts.

For Technical Support Call: 800-343-7486, Monday-Friday, 7AM - 4 PM (PST) Page 4
Instructions –40380
Step 2 –Find Location
Find desired location for tote holder to be
installed.
Slots and holes can be found along the shelf of
most Holman shelf units.One can make use of
these.
If desired, place tote unit in any desired
location, mark holes and drill with 1/4" drill bit.
Be sure the shelves are in the position shown.
The shelf lip should facing upwards.
Step 3 –Attach
Bolt tote holder to shelf using a #10 x 1/2”pan heads, #10 flat washers and #10 lock
nuts.

For Technical Support Call: 800-343-7486, Monday-Friday, 7AM - 4 PM (PST) Page 5
Instructions –40380
Tote holders may be installed in a variety of different locations.
Some examples are shown below.
Ensure all bolts are tight.
Your Installation is now complete.