HOMCOM A61-024 Installation guide

ASSEMBLY & INSTRUCTION MANUAL
INaia004_UK
A61-024
READ AND SAVAE THIS INSTRUCTION FOR FUTURE USE
60MIN
Notice to assemblers:
All the basketball systems, including those used for display purposes must be assembled and filled with weight
according to instructions. Failure to follow instructions could result in serious injury. Please read all warnings and
cautions before assembly. It is recommended to supervise children as they play with this product. This product is to
be assembled by 2 adults only!
We appreciate your purchase of one of our many fine products. We are assured that you will be very satisfied with
your selection.
WARNING:
IMPROPER INSTALLATION OR
SWINGING ON THE RING MAY
CAUSE SERIOUS INJURY OR
DEATH

WARNING
Moving the system
• The system should be moved by at least 2 adults capable of handling its weight.
• Children should not be allowed to move the system
• Stand in front of the system and pull the pole forward until the system is balanced on its wheels.
Move the system to the desired location and carefully set the base down
WARNING!!
FAILURE TO COMPLY WITH THESE WARNINGS COULD RESULT IN INJURY. FAILURE TO
COMPLY COULD ALSO RESULT IN PROPERTY DAMAGE
1. Never hang from the rim or climb on the pole as injury or property damage could occur.
For these reasons do not perform dunking activities on this system as it is not designed for
such use. Do not allow children to climb on the basketball system.
2. Never leave the unit assembled without weight in the tank.
3. Check the base frequently for leaks or loose cap. Slow leakage could cause the system to tip
over unexpectedly and damage the floor if used inside.
4. Seat the pole sections properly. Not doing so might allow the pole sections to separate during
play or during transportation of this system.
5. Further Check before each use if all fittings and hardware are tight.
6. Climate, corrosion or misuse could result in system failure.
7. This system is not intended for children and under.
8. All payers must use sufficient guards when playing
POLE CARE AND SYSTEM MAINTENANCE:
The product live of your basketball system depends on many variables. The climate, exposure to
corrosives such as salt, pesticides or herbicides and excessive use or misuse can all contribute
to pole failure, which may cause property damage or personal injury.
Check your basketball system frequently for loose hardware,excessive wear and signs of
corrosion. For safety reasons and to prolong the life of your basketball
system, you must take the following preventive measures:
• Check all nuts and bolts. If any are loose, tighten them.
• Check all pole sections for visible rust, chipped or cracked paint. If either are present, do the
following:
1.Use an emery cloth to completely remove any rust or chipped paint.
2.Clean the area with a damp cloth and allow it to dry.
3.Apply two coats of a rust preventative, hight gloss enamel to the area. Allow the paint to dry
betwecn two coats.

1.Boardx1
2.Ringx1
3.Netx1
4.Board Bracket x1
5.Boltx2(M8×35mm)
6.Nutx4
7.Boltx2(M8x16mm)
8.Boltx6(M10x85mm)
9.Nutx2
10.Capx1
11.TopPolex1
12.Middle Polex1
13.Bottom Pole×1
14.Basex1
15.Whteel Shaftx1
16.Wheelx2
17.Boltx1 (M8x90mm)
18.Nutx1
19.Pole Bracex2
20.Boltx2(M8x20mm)
21.Nutx2
24.Boltx2(M8x110mm)
25.Spring washerx2
26.Spring x2

Assembly Steps
1 .Open the carton, find out all the parts listed on page 3, two adults are required for assembly.
2.Fix ring(2)and board bracket( 4)on board( I )by bolts(5)(24)and nuts(6). After that,use bolts(7)
to fix the top of board bracket( 4 )on the back of board( I )tightly.Insert top pole(l l)into board
bracket(4),fix them by bolts(8)and nuts(9).
3 .Insert top pole( 11 )on the top of middle pole(12),then join the middle pole(12) and bottom
pole( 13) as show, fix these poles together by 4.pc.bolts( 8).
4.Place the base(14)on a chosen playing ground,the surface beneath the base should be
horizontal. Insert the wheel shaft(15)into wheel (16)，base(14 )and end of bottom pole ( 13)
orderly.
5 .Fix one end of the 2pcs pole braces(19) on bottom pole( 13 )by bolt(17)and nut( 18).
Then fix another end of the 2pcs pole braces(19)on base( 14 )by bolt(20)and nut(21).
6.Tighten
WHEN USING WATER:
-Place the base on a smooth surface only! Without gravel or other sharp objects which could
puncture the base and cause leakage.
- Check the base frequently for cracks and punctures.
- Always check the water level before the game.If a leak is found or the water level is low,lay the
system onto the ground so that it can’ t tip over.
-Add a tablespoon of chlorine bleach to the water each time the base is filled with water.This
prevents algae from forming inside the base.
Sand
24.Plastic Lid
Filling water