Assembly
Assembling the Haunted House
Step 1. Attach the Bracket (J) to the matching holes on the back side of the Main Section of
House (E) and fasten them with Cotter Pin (I). (FIG.1)
Step 2. Insert the connecting rods on the Left & Right Fence (G & H) into the matching holes
on the front side of the Main House (E) and fasten them with Plastic Ties (L). (FIG.2)
Step 3. Insert the connecting rods on the three parts (A, B & C) of Highest Section of House into the
matching holes with each other and fasten them with Plastic Ties (L).(FIG.3）
Step 4. Insert the connecting rods at the bottom of the Lowest Part of Highest Section of House (C)
into the holes at the top of the Main Section of House (E). Insert the connecting rods of
Middle Section of House (D) and Chimney (F) into the matching holes at the top off the
Main Section of House (E). (FIG.4)
Step 5. Insert Ground Stakes (K) into the ground at base of House. (FIG.5)
Pre-Operation
CAUTION:Grasp the plug to insert or remove from the power source.
Do not unplug by pulling on cord.
CAUTION:The lighting string on this product is rated at 7.2 Watts
(0.06Amps). Do not overload. Do not connect to another lighting string, decorative
outfit or other electrical products. Before you use or re-use this product inspect it
carefully. Return to place of purchase with purchase receipt if the product has cuts,
damage, frayed wire insulation on cords, cracks in the socket enclosures, loose
connections or exposed copper wire.
CareandCleaning
a. Carefully remove the product from wherever it is placed. This helps to avoid any
undue strain or stress on the product conductors, connections, and wires. If the
product is placed somewhere other than the ground it should be well secured and
stable.
b. Wipe the product with a damp cloth and allow the product to dry before storing.
c. Store the product neatly in a cool, dry location protected from sunlight.
FOR INDOOR AND OUTDOOR USE
FIG.3
FIG.4
FIG.1
FIG.5
FIG.2
