Home Decorators Collection 1007516309 User manual

Safety Information
IMPORTANT SAFETY
INSTRUCTIONS
When using electrical products, basic precautions should always be
followed including the following:
a) READ AND FOLLOW ALL SAFETY
INSTRUCTIONS.
b)Thisproduct is for indoor use only. The electrical rating0.57 A 120 V 60
Hz.
c) Do not use seasonal products outdoors unless marked suitable for
indoor and outdoor use. When products are used in outdoor applications,
connect the product to a Ground Fault Circuit Interrupting (GFCI) outlet. If
one is not provided, contact a qualified electrician for proper installation.
d) This seasonal use product is not intended for permanent installation or
use.
e) Do not mount or place near gas or electric heaters, fireplace, candles or
other similar sources of heat.
f) Do not secure the wiring of the product with staples or nails, or place on
sharp hooks or nails.
g) Do not let lamps rest on the supply cord or on any wire.
h) Unplug the product when leaving the house, when retiring for the night,
or if left unattended.
i)Thisisanelectricproduct–notatoy! Toavoidriskoffire,burnspersonal
injuryandelectricshockit shouldnot be playedwithor placedwheresmall
children can reach it.
j) Do not use this product for other than its intended use.
k) Do not hang ornaments or other objects from cord, wire, or light string.
l) Do not close doors or windows on the product or extension cords as this
may damage the wire insulation.
m)Do not cover the product with cloth, paperor any materialnotpart of the
product when in use.
n) Do not move the tree by pulling the tree tips or tree branches.
o) Read and follow all instructions that are on the product or provided with
the product.
p) SAVE THESE INSTRUCTIONS.
CAUTION! – ALWAYS UNPLUG YOUR TREE
FROM ITS POWER SOURCE BEFORE ASSEMBLING OR
DISASSEMBLING.
CAUTION:
1. The product consists of non-replaceable LED lamps. To reduce the
riskoffireor electricshock,do not attempttoreplacelampsor modify
string.
2. This product can only be used with the original adapter, not other
brands of adapter.
7.5 ft Elegant Grand Fir LED Pre-Lit Tree with
Timer
SKU# 1007516309
Package Contents
A. Top Section
Qty: 1 B. Middle Section Qty: 1 C. Bottom Section Qty: 1
D. Stand with an eye
bolt
Qty: 1
E. Power Cord
Qty: 1 F. Remote Control Qty: 1
G. Rivet
Qty: 2

Assembly
Assembling the tree stand
Step 1. Choose a location near a wall outlet.
Step2. Open the stand to a 90 degree angle until the hole lines up with the
hole on the tube.
Step 3. Screw an eye bolt into the hole.
Pre-Assembly

Assembling the tree
Pleaseremove protective covers from the base of the pole for each tree
section before assembling.
Step 1. Insert tree bottom (C) into the tree stand and tighten the screw.
(See Fig. 1)
Step 2. Insert middle section (B) into the tree bottom (C). (See Fig. 2)
Step 3. Insert tree top (A) into the middle section (B). (See Fig. 3)
Step4. Allowbranchestofallinto place orgentlypullbranchesupandout.
When adjusting branches be sure that all wires are free of branch
hinges. (SeeFig. 4)
Step 5. Shape the branches. Starting with tips closest to the pole, shape
one tip to the right, one to the left and oneat the center of the main
stem. Repeat pattern for each branch. (See Fig. 5)
Step 6. Plug the power cord into a proper outlet. This tree comes with a
control box and a remote control. You can change the lighting
patterns of the tree by using control box or remote control.
Please see Instructions of control box and remote control as
below.
Operation
Turning on the tree
Step 1. Connect each tree section well and plug the power cord into a wall
outlet.
Instruction of control box and remote
control
Instruction of control box
1. Press the button on control box to turn on and off the lights or timer
function.
2. Press and hold the button on control box to activate timer mode,
select below timer hours:
i. The first indicator lights of timer on control box turn on:
The tree lights will automatically run through a 2-hours
ON, 22-hours OFF cycle.
ii. The second indicator lights of timer on control box turn on:
The tree lights will automatically run through a 4-hours
ON, 20-hours OFF cycle.
iii. The third indicator lights of timer on control box turn on:
The tree lights will automatically run through a 6-hours
ON, 18-hours OFF cycle.
iv. The fourth indicator lights of timer on control box turn on:
The tree lights will automatically run through an 8-hours
ON, 16-hours OFF cycle.
Toturn off thetimer function,press the button oncontrol box or press
the off button on remote control.
Thereismemorymodeontimercontrolevenunplugandre-plugbackon.
Instruction of remote control
Please note this tree has a remote control.
Please pull out the insulation tape from the remote control, before starting
to use it.
1. PressthebuttonONorOFFto turnonoroffthe lights ortimerfunction.
2. Pressthe 2H,4H, 6H or 8H buttonto select the different timer hours.
If the remote control does not work, check whether the battery of the
remote control is out of power.
To replace the remote control battery:
1. Replace with a new button cell “CR2025” (3 volt) into
the compartment.
CAUTION: DO NOT DISPOSE OF
BATTERIES IN FIRE. BATTERIES MAY EXPLODE
OR LEAK.
Use and Care Instructions
a) Before using or reusing, inspect product carefully. Discard any
products that have cut , damaged, or frayed wire insulation or cords,
cracks in the lampholders or enclosures, loose connections, or
exposed copper wire.
b) Whenstoringtheproduct,carefullyremovetheproductfromwherever
it is placed, including tree, branches, or bushes, to avoid any undue
strain or stress on the product conductors, connections, and wires.
c) When not in use, store neatly in a cool, dry location protected from
sunlight.
Care and Cleaning
Step 1. Remove all ornaments and decorations.
Step 2. Unplug the power cord from the wall outlet.
Step 3. Gently lift the tree top straight up to remove from the center section
and fold all branches towards the pole.
Step 4. Repeat this step for the center and bottom tree sections.
Step5.Carefullyplace alltreesections intoa shippingboxandtapeitshut.
Step 6. Store your tree in a cool, dry place away from sunlight.

Troubleshooting
Problem Solution
The tree or the
tree top does
not light
Ensure that all tree sections are connected into
each other well by pressing each section down and
rotating. Make sure the power cord is well
connected to the tree bottom (C).
If you are still experiencing problems with the tree
please call 1-800-986-3460 for instructions.
Top section does
not light
Push downward and
rotate the top section to
B section to make sure
they are connected
securely.
The device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must
accept any interference received, including interference that
may cause undesired operation.
Warning: Please note that changes or modifications
not expressly approved by the party responsible for
compliance could void the user’s authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by
one or more of the following measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the equipment and
receiver.
● Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
● Consult the dealer or an experienced radio/TV technician
for help.
CAUTION
a) To reduce the risk of electric shock, useonly with the power-supply
cord provided or with a cord set intended for indoor use.
b) Do not use a cracked, frayed, or damaged cord. Inspect the cord
periodically.
c) Donotabusecord–Donotcarryproductbythecordoryankorpull
it to disconnect from the outlet.
d) Disconnect the product from the outlet when not in use.
Loose branches
If a branch of the tree falls off, follow the steps below to reinstall it with a
spare rivet (G).
1) Place the branch into the slot of the bracket.
2) Insert a spare rivet
through the hole and use
diagonal pliers (not
included) to crimp the
rivet. (See Fig. A)
WARRANTY
3-year Limited Warranty
This product carries a three (3) year warranty against defects
in workmanship and materials. This product is not
guaranteed against wear or breakage due to misuse and/or
abuse.
Date Code: 04012022_2003186
Importer: The Home Depot
Address: 2455 PACES FERRY ROAD ATLANTA, GA 30339
Tel: [phone]
Adapter Model No. TS-24WLF12V